2) You have an underground buried cable, suppose the cable is defected (open circuit) somewhere along its length. Explain with the needed diagrams, how you can locate the position of the failure point. Suppose that you can calculate Vp from the characteristic of the cable.

2) You have an underground buried cable, suppose the cable is defected (open circuit) somewhere along its length. Explain with the needed diagrams, how you can locate the position of the failure point. Suppose that you can calculate Vp from the characteristic of the cable.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.38MCQ

See similar textbooks

Related questions

Q: 6. What is the full-load current of a 600-volt, 3-phase, 50-horsepower induction motor?

Q: 6. Explain double revolving field theory.

Q: ş DC (6 amps) 8 ohms 4 ohms 15 www 6 ohms 5 volts W 2 ohms 10 volts 12 www 1 ohm ·+|+ 15 volts www 3…

Q: Q3: find the time Response parameters (Tr, Tp, O.S.Td, Ts) Step response Unit step response of…

Q: nano materials have high surface area property because small size little atom in the surface have…

Q: systems are marked with the letters A. X, Y, and Z. B. U, V, and W. C. T, Q, and R. D. C, D, and

A: Servo motors are nothing but an actuator that is basically used for precise angular positioning ,…

Q: نقطة واحدة * ?M-ary help to drive System complexity System simplicity Power improving ] maintain the…

A: Given Multiple choice question based on M- array modulation technique. Please find the answer with…

Q: Electrical Engineering For the three-phase circuit obtain a) Obtain the complex power supplied by…

A: In this question we need to find a complex power supply by source and power factor

Q: want the solution quickly, please

A: ASM stands for Algorithmic State Machines.It consists of state name, state box, condition check and…

Q: An earth electrode consisting of a round section metal pipe of 15 mm diameter is driven in to ground…

A: Earth electrode is a material used for earthing, it can be any conductor buried in the ground.

Q: What is the a+ib form of: - 2+3i Z = (-2-5i)ei 30°

Q: Q.1 A single phase load of 100kv is connected across lines b and c of a 3-phase supply of 3.3kv.

Q: Based on the circuit configuration, determine the following: a) Ceq b) q r c) V₁ d) Vs ប C1=5xF ← C4…

A: given here a circuit and asked to determine the equivalent capacitance Ceq , total charge qT ,…

Q: sub-transient reactance of 8% and G3: 110 MVA, 30 KV, sub transient reactance of 12%. reactance of…

Q: A 1-ph transformer 25kVA, 330/110V, 50Hz, Req2 = 0.04522 and Xeq2 = 0.0650 draw the Kapp regulation…

A: Single Phase Transformer: An electrical device that accepts single-phase alternating current and…

Q: Use the analytical method, design a lossless L-section network to match a load impedance of 30+j15Q…

A: L-section matching network:- This network consists one reactive element which is in series and also…

Q: In the network shown, what is the value of le in mA?

Q: When dots are connected, what shape is formed?

A: It is given that:

Q: modulated signal that is passed through a white Gaussian noise channel is demodulated?

A: An additive white gaussian channel is that channel in which white noise gets added(superimposed)…

Q: Determine all the branch currents in this circuit using Kirchhoff's Analysis. Problem Requirement:…

A: Given circuit :

Q: Determine the maximum value of Vi for proper operation of the zener diode. 910 Vi 22002 Vz = 8V Pzm…

A: Zener diodes are used in constant voltage devices. It is a silicon semiconductor device in which…

Q: 4. Discuss the following (rated torque, starting torque, break down torque).

A: Given Enumerate rated torque, starting torque and break down torque. Please find the below…

Q: A balanced load of 30 MW is supplied at 132 kV, 50 Hz and 0.85 p.f. lagging by means of a…

A: Given A balanced load of 30 MW is supplied at 132 kV, 50 Hz and 0-85 p.f. lagging by means of a…

Q: V+ DC (6 amps) 8 ohms 4 ohms 15 ww 6 ohms 117 5 volts W 2 ohms 10 volts 1 ohm # 15 volts 3 ohms 5…

Q: Q2. Discuss mathematically the force system and equilibrium system?

A: Force system : : A force system system is collection of different forces which acts at the same…

Q: Find the convolution of x(n)=(1/3)n u(n) and h(n) = δ(n)+(1/3)n u(n). Hint use the convolution…

A: Given An input and h(n), we need to determine the output using convolution theorem. Please find the…

Q: Q2// For the circuit shown Plot curve between V and I When voltage variable Vin 0.1 0.2 0.3 0.7 0.8…

Q: A wind turbine system has a double fed induction generator of 6 pole 50 Hz has the following…

A: wind turbine is power generate device. it is convert kinetic energy into mechanical power. Wind…

Q: Q3) what is the dispersion taking place in long transmission lines? State the condition to obtain…

A: Introduction - A long transmission line is one that has an overall length of more than 250…

Q: Write a short note on each of the following 1) Propagation constant 2) Phase constant 3)…

A: Transmission line connection between the transmitter and receiver to permit signal transmission.…

Q: Show that the z-transform of [rn cos ω0 n]u[n] is 1-[rcos ω0 ]z-1 /1-[2rcos ω0 ]z-1 +r2 z-2 (|z|…

Q: Determine the 12 current using Source Transformation ş @ DC (6 amps) 8 ohms 4 ohms 15 6 ohms www 5…

A: The circuit diagram is shown below,

Q: Polyphase Circuits 749 small which is equally deterimental to some types of electrical equipment.…

A: Current: It is the time rate of the change of the charges. It flows from high voltage to low voltage…

Q: Two balloons with charges of +4.00 μC and -10 µC attract each other with a force of 0.0625 Newton.…

Q: 21.a. What type of circuits are present on an axis logic card for a stepper motor system and are…

A: Given; The objective is to find what type of circuits are present on an axis logic card for a…

Q: .Define the return loss, reflection coefficient and if the return loss (R.L) for a load is 12dB.…

Q: his normal weight

Q: A 1200 kVA, 6600 volt, 3-phase, Y-connected alternator has an effective resistance of 0.40 ohm and a…

A: Given Few parameters of an alternator.we need to find the terminal voltage. Please find the below…

Q: quaternary PCM system works for sinusoidal modulation signa of 40 dB, the desired SNR if 50 dB, find…

Q: 41. Review. The heating element of an electric coffee maker operates at 120 V and carries a current…

A: Given, The heating element of a coffee maker operates at 120V and carries a current of 2.00A water…

Q: Question 3 Determine the Rt of the circuit below in ohms. R₁ AO 10 32 R₂ R₂ 100 100- BO O 50 O 80 O…

Q: For the transfer function shown below, L(s) = s²+1 s(s²+4) Determine the following using the four…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: AC Power and Power Factor 1. Two loads are connected in parallel across a 13,200-volt line. Load A…

Q: Let S = 120 cm², d = 4 mm, er = 12, and V. = 40 v, calculate the capacitance C and the total stored…

Q: Q2) Define the return loss, reflection coefficient and if the return loss (R.L) for a load is 12dB.…

A: Given We need to define return loss and reflection coefficient. For the given return loss we need…

Q: 5-horse- a nameplate full-load

A: Given as, Nameplate full-load current =185A Minimum capacity of the conductor is 125%. full load…

Q: 1-Why transformer Rating in KVA? 2-Why is efficiency of transformer high as compare to other…

Q: 2. A 75 22 load uses 2 W of power. The output voltage of the power supply is approximately

A: Given, Load resistance, RL=75 Ω Uses power, P=2 W

Q: Using the oscillogram of a periodic sequence of rectangular video pulses u(t) shown in the figure,…

A: Option:d) is correct Because the explanation as shown below.

Q: Tutorial Problem No. 19.3 1. Three impedances Z₁, Z, and Z, are mesh-connected to a symmetrical…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Question

i need the answer quickly

2) You have an underground buried cable, suppose the cable is defected (open
circuit) somewhere along its length. Explain with the needed diagrams, how you
can locate the position of the failure point. Suppose that you can calculate Vp
from the characteristic of the cable.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You have an underground buried cable, suppose the cable is defected (open circuit) somewhere along its length. Explain with the needed diagrams, how you can locate the position of the failure point. Suppose that you can calculate Vp from the characteristic of the cable.
A wind farm is being built on an island 6km offshore and needs to be connected to the power grid substation 12km down shore before it can become operational. The cost of laying cable under water is $10,000/km, and the cost of laying cable on land is $8,000/km. a) Determine the cable route that will minimize cost. b) What is the minimum cost
Give a detailed account of the pontetial of underground and submarine XLPE cable. Include the pontetial benefits and its disadvantages.
Describe the challenges and techniques associated with splicing and terminating fiber-optic cables.
Describe some of the factors that have contributed to the delays in undersea cable maintenance.
6.a. What type of cable installation is typically used in industrial facilities?A. Aerial onlyB. Buried onlyC. Buried and aerialD. Industrial facilities don't use cable installations.6.b. Which type of fiber is used in a standard FDDI network?A. OM3 or OM4 at 850 nmB. OM1 at 1,550 nmC. OM2 at 1,310 nmD. OM1 at 1,310 nm
Discuss the importance and methods of maintaining proper cable bend radius in fiber-optic installations.
what is the cladding modes in Optical Fiber delivery system?
Explain some of the factors that have contributed to the delays in undersea cable maintenance.
Explain Basic Trip Circuit in Transmission line? Also, Discuss the Fundamental Requirements of Protective Relaying in Transmission Line
7. Two towers of height 40 m and 30 m respectively support a transmission line conductor at water crossing. The horizontal distance between the towers is 300 m. If the tension in the conductor is 1590 kg, find the clearance of the conductor at a point mid-way between the supports. Weight of conductor is 0·8 kg/m. Bases of the towers can be considered to be at the water level.
C.Comments on this statement: "PMUs can be used as a protective relays”. D. What is the ZIB and it role in OPP E Is there any effect of existence of HVDC transmission lines in OPP and state estimations? F. Discuss the challenges that might face application of PMUS/WAMs in any given power system.