Two balloons with charges of +4.00 μC and -10 µC attract each other with a force of 0.0625 Newton. Determine the separation distancetween the two balloons.

Q: Design the minimum CMOS transistor network that implement the functionality of Boolean equation: F =…

A:

Q: = For E-MOSFET gives Ip(on)= 500mA (minimum) at VGS 10V and VGS(th) Determine the drain current for…

A: Brief description: For the given enhancement MOSFET we need to derive the value of drain current ID…

Q: Q2. Discuss mathematically the force system and equilibrium system?

A: Force system : : A force system system is collection of different forces which acts at the same…

Q: Find Vth and Rth at load. 5 Ω ΖΩ Μ Μ Μ 10 Ω 0.5 Ω 1Ω Load Μ 12V (b) www 4Ω

A: In this question,  We need to determine the Thevenin voltage and Thevenin resistance across the load…

Q: The ac bridge shown in Fig. 9.84 is known as a Maxwell bridge and is used for accurate measurement…

A:

Q: Simplify the block diagram shown in Fig. (1), then obtain the closed-loop transfer functions C(s)/R…

A: Given circuit is,

Q: Assume a single phase transformer with primary and secondary winding. Explain what would happen if a…

A: Transformer is a static device which is used to step up/down the voltage or current level without…

Q: 5. The voltage across a coil when di/dt = 20 mA/ us and L = 8 µH is O(A) 16 mV O(B) 160 mV O(C) 1.6…

A: Given a coil with, Rate of change of current, didt=20 mAμs Inductance, L = 8 μH

Q: A 3-ph balance express feeder has an impedance of (6+j20)/ph. At the UP load end, the line-to-line…

A: Given data, Impedance of per phase Zph=6+j20 Ω/ph Line voltage VL=13.8 KV Absorbed power P = 1200 KW…

Q: The efficiency of a 440/110V, 40kVA, single-phase transformer is 98.77% when delivering full-load at…

A: Single Phase Transformer: A single phase transformer is an electrical device that accepts…

Q: Q. The input for any circuit at lab experiments are O B. the switches OD. None of the above O C.…

A: While performing the experiments in Laboratory, the inputs is given at one terminal and switches and…

Q: 3. What is the rated full-load current of a 34-horsepower, 208-volt single-phase motor?

A: In this question,  We need to determine the rated full load current of a 3/4hp , 208V single phase…

Q: Based on the circuit configuration, determine the following: a) Ceq b) q1 c) V1 d) Vs จ C1=5&F se C4…

A: From above circuit solve as C1 and C2  are in series and other combination  C4 and C5 also are in…

Q: Classify and explain with example the instruction that used to transfer .the data between the…

A: The Intel 8085 (pronounced "eighty-eighty-five") is an 8-bit microprocessor that was announced in…

Q: 1-Why transformer Rating in KVA? 2-Why is efficiency of transformer high as compare to other…

A:

Q: 3. A certain waffle iron is rated at 1.00 kW when connected to a 120-V source. (a) What current does…

A: Waffle iron power P = 1 KW = 1000 W  Source voltage V = 120 V  Waffle iron carrying current I = ?…

Q: 50 HP, 440 V, 3 Phase, 60 Hz, 6 Pole squirrel cage induction motor is operating at full load and 0.8…

A:

Q: Identify the given statement. The phase deviation sensitivity and the peak modulating-signal voltage…

A:

Q: 3. What is the rated full-load current of a %4-horsepower, 208-volt single-phase motor?

A: We need to find out the current for given power

Q: نقطة واحدة * ?M-ary help to drive System complexity System simplicity Power improving ] maintain the…

A: Given  Multiple choice question based on M- array modulation technique. Please find the answer with…

Q: 34. The saving in Cu achieved by converting a 2-winding transformer into an autotransformer is…

A:

Q: Calculate the value of Zab in the network j6 Ω -j9 Ω α. Η 9 Ω −9 Ω bo j6 Ω j6 Ω 20 Ω 20 Ω 10 Ω

A:

Q: 3- Plot3 helps in creating 3D lines and 2D lines. A:YES B: NO 4- The ----------enables you to add…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Given that Jamie worked 50 hours (Hours = 50) last week and earns $10.00 an hour (Kate =10), how…

A: Given data, Total number of hours = 50 Earning per hour is $10

Q: Differentiate apparent power from true power.

A:

Q: Find Values PID control (Kp, Ki, Kd) step by step 727.40 0.558s2 +55.85s + 441.2

A: Given data :  Standard transfer function of PID controller  G1(s)=KP+sKD+Kis open loop-transfer…

Q: 4. What are the minimum allowable ampacities of the phase conductors and the neutral conductor that…

A: Solution (4) - Given,For a 2-phase, 3-wire motor,Voltage =230VPower =30 hp

Q: Calculate the value of Zab in the network j6 Ω -j9 Ω α. -j9 Ω ba j6 Ω j6 Ω 20 Ω ww 20 Ω j9 Ω 10 Ω

A:

Q: 4. Obtain the equivalent circuit of a 200/400 V, 50 Hz, single-phase transformer from the following…

A: In this question we need to find the secondary voltage for the given condition

Q: Give the Fourier coefficients ao, an, and bn of the waveform in Fig. 17.47. Plot the amplitude and…

A:

Q: 4. The primary and secondary windings of a 30 kVA, 6000/230 V transformer have resistances of 102…

A:

Q: Q1// For the circuit shown Plot curve between V and I When voltage variable Vin 0.1 0.2 0.3 0.7 0.8…

A:

Q: For the following network determine: a. laq. b. lcq. c. Vera- d.Vc.e. Vs.f. Ve. 510 KO 180 Ico 1.8…

A:

Q: to the diagram in fig.2 for an ple of a closed electrical circuit. The ity of charge passing a point…

A:

Q: 3. Consider a 24-bit system. To represent the system, a) How many bytes are required? b) How many…

A: 3)  Given: A 24-bit system  a) no of bytes required b) no of nibbles required c) no of digits…

Q: Q3.A. Choose the most appropriate technology for each of the system constraints below from among…

A: The electronic IC design process using VLSI Physical design Process using Automated Equipment's…

Q: Q6. All ICs needs input power to work D. None of the above B. VCC (+5 volt) A. Ground (0 volt) C.…

A: ICs are electronic element

Q: Q3)B-A transmission line has the following per unit length parameters: L=0.2 µH/m C=300 pF/m R=5 /m…

A:

Q: Q2 What is the mode and I/O configuration for ports A, B, C of an 82C55 after its control register…

A:

Q: Q2) show that: X(0)8(f) a) Stx(t)dt → + x(f) 2π]f 2 b) if x(t) = x(-t) (even symmetery) then all the…

A: Given data, a). ∫-∞tX(t)dt = X(f)2πjf+X(0)δ(f)2. b). if X(t) = X(-t) (even symmetery)then all sin…

Q: Ω 3. A) Apply Thevenin's theorem on the circuit below and determine the current in the 3-ohm…

A:

Q: Q3) Mesh Analysis a) Write mesh equation for loop current I, and then simplify it in terms of I, and…

A: Given circuit,

Q: AC Power and Power Factor 1. Two loads are connected in parallel across a 13,200-volt line. Load A…

A:

Q: B. The name-plate of a squirrel-cage induction motor has the following information: Rated power: 50…

A: As per Bartley policy we can answer only 3 subparts at a time. I am solving first three for you,…

Q: 2. Which NEC table is used to determine the full-load current of a torque motor?

A: In this question we will find Which NEC table is used to determine the full-load current of a torque…

Q: 1. A 50 kVA, 6360/240 V transformer gave the following test results : S.C. test: Voltage across…

A:

Q: 7.what do you mean by instruction cycle,mechine cycle and T- state

A: Instruction cycle: The time taken by the processor to  fetch and execute an instruction is called…

Q: Calculate the value of Zab in the network j6 Ω -j9 Ω α. -j9 Ω bo j6 Ω j6 Ω 20 Ω 20 Ω -j9 Ω 10 Ω

A:

Q: 1-Why transformer Rating in KVA? 2-Why is efficiency of transformer high compare to other electrical…

A: Given  We need to explain the reasons why a. Transformer rating is in KVA and efficiency is higher…

Q: The ac bridge shown in Fig. 9.84 is known as a Maxwell bridge and is used for accurate measurement…

A:

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.