2. Current is defined as the rate of charge flow.If a charge of 0.0065 colombs passes a givenpoint in a conductor in loa milliseands, calculate the:a) current in amperes (Hint: I = 2)b) Current in milliamperes.Ans: a) 0.065 Ab) 65 mA

This question belongs to circuit theory . It is based on the concept of formula of current . Problem…

2. Current is defined as the rate of charge. .flow. If a charge of 0.0065 colombs passes a given point in a conductor in loa milliseconds, calculate the: (a) Current in amperes (Hint: I = 2) b) Current in milliamperes... Ans: a Ans: a) 0.065 A b) 65 mA

2. Current is defined as the rate of charge. .flow. If a charge of 0.0065 colombs passes a given point in a conductor in loa milliseconds, calculate the: (a) Current in amperes (Hint: I = 2) b) Current in milliamperes... Ans: a Ans: a) 0.065 A b) 65 mA

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter1: Atomic Structure

Section: Chapter Questions

Problem 1RQ: What are the three principal parts of an atom, and what charge does each carry?

See similar textbooks

Related questions

Q: * If X= (1100101)excess-3 X=(65) decimal O X=(110000) gray O X=(101)octal

A: If X= (1100101)excess-3

Q: 3. A 4-pole, single-phase, squirrel-cage induction motor operates from a 115 V, 50 Hz supply. The…

Q: The block diagram representation of a hydraulic system which provides the power for a numerically…

Q: B. One method of Amplitude Demodulations is shown below: AM Input LPF VOUT m(t) + Distortion Low…

A: Demodulation is an important step in receiving any amplitude modulated signal, whether for broadcast…

Q: We need a three-stage time-space-time switch with N = 100. We use 10 TSIs at the first and third…

A: Given a three-stage time-space-time switch with, N =100 No of TSIs at the first stage= 10 No of TSIs…

Q: * If X= (1100101)excess-3 X=(110000)gray O X=(65)decimal O X=(1000001)binay O X=(101)octal O none of…

Q: S(t) = e-2|t| t0 s(t) = {e- t ²

Q: Quguse Parallel full adder and other type of gates to design a circuit which for form the following…

A: Given & to find: Use parallel full adder and other types of gates to design a circuit that…

Q: 1. A 3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature resistance is…

A: Given data, KVA rating S=15000KVA Terminal voltage Vt is 11kV Synchronous impedance Zs is (1.5+j30)…

Q: 8. Two edge-triggered J-K flip-flops are shown in Figure 7-77. If the inputs are as shown, draw the…

A: Given: Two edge-triggered J-K flip-flops are shown in the figure below: To find: If the inputs are…

Q: 2. For the circuit shown below, calculate: a) The gain (G) of the amplifier associated with the 1.5…

Q: Q-1. A 3 phase, 0.8 MVA, 3.3 kV, star - connected synchronous generator has 5 2/phase synchronous…

Q: The gray code has the property of when going from any number to the next only one bit is flip O none…

A: We need to select correct property of gray code .

Q: The minimum sampling period of the signal m(t)=5cos(300πt)cos(500πt)is

Q: 2- A resultant current is made of two components: a 10 A D.C. component and a sinusoidal component…

A: This question belongs to circuit theory . It is based on the concept of sinusoidal analysis of…

Q: Question 1. Calculate the peak LTE OFDMA downlink data throughput of 20-MHz channel bandwidth using…

A: Given data, The no. of sub-carriers for 20MHz channel bandwidth=256 and for 128QAM=27 so, 7 bits are…

Q: / Construct 4-to-16 live decoder with 2-to-4 а line decoders with enable.

A: A 2 to 4 line decoder is a modular digital logic circuit which has 2 input lines and 4 output lines.…

Q: PRE 1997- B) Sketch the phasor diagram and the circuit of medium transmission line using nominal- T…

A: Kirchoff's voltage states that the sum of net voltage around a closed loop is equal to zero. It is…

Q: Problem 4: Find Zth, (Z-Thevenin) for the following circuit j20 12 1052 wwww 50/30° V >10 Ω

A: Given circuit:

Q: A 1-cm X 2-cm waveguide is filled with deionized water wither=81. If the operating frequency is…

A: We need to find cut off frequency of given waveguide

Q: Q4 for the following circuit find total current, la fe.V. V and Po He 404 40 ALT AR 030 130

Q: For step -down chopper circuit, source voltage Vs=220V, Chopping period T=2000micro second, on…

A: Step- down chopper is the DC input voltage. It is the static device the average output DC voltage of…

Q: 1 Find the current value for the resistance (4 ohm) using mesh (loop) method or nodal method. All…

A: This question belongs to circuit theory . It is based on the concept of mesh analysis in the circuit…

Q: Provide at least 3 Examples of Control Systems Models or Representations and its corresponding…

A: Following control system models are mostly used- Differential equation model Transfer function…

Q: Which of the following could be the boundaries of the given shape? R=5 A=44⁰ B=17° O a. R=5, 17° < <…

Q: (1) What is the maximum amplitude for a 1kHz sinusoidal input for a DM system that prevents…

A: Given here frequency of sinusoidal input is 1kHz for DM and sampled at 10 times the nyquist…

Q: 6. You have a complicated wire structure with an area of 1 cm², and an average interior magnetic…

A: Given data, Area, A=1 cm2 Magnetic field, B=10-9 T

Q: A single-phase alternator, having a delivers a current of 100 A. Calculate the e.m.f. generated in…

A: Given synchronous reactance Xa=5.5Ω armature resistance ra=0.6Ω armature current Ia=100 A…

Q: 'Construct a 4-to-16 line decoder with 3-to-8 like decoders with enable and external gates.

A: We need to design 4 to 16 decoder by using of 2 to 4 decoders

Q: Q-2. A. A lighting load of 2000 kW and a motor load of 4000 kW at a p.f. 0.8 lagging are supplied by…

Q: The transmission line act as inductor when it terminated by short circuit O open circuit O matched…

A: Transmission line parameters Transmission line :- a system which is used to tranfer energy from…

Q: 2. For the circuit shown below, calculate: a) The gain (G) of the amplifier associated with the 1.5…

Q: The progressive phase shift k =180, the direction of the main beam eo for a uniform linear array…

A: The Given Progressive phase shift k=180, A uniform linear array with d=λ

Q: Calculate the inductive reactance, X₁, of a 2.5 H inductor when operated at a frequency of 50 Hz…

A: Given: Inductance, L=2.5 H Frequency, f=50 Hz

Q: a. The AC system used instead of DC system in power transmission in o possible to: 1) Reduce the…

Q: A voltage divider has values of R1=10kΩ and R2=470kΩ. a.What is the attenuation? b.What amplifier…

A: It is given that:R1=10kΩR2=470kΩAT=1

Q: E6.24 Consider the system represented in state variable form x = Ax + Bu y = Cx + Du, where 0 1 0 […

Q: 5. For the circuit shown in the figure below find the following a. Write the name of the…

A: We need to find out current and voltage for given circuit and load line for given circuit

Q: unctions

Q: For the network of Fig. 6.79, determine: (a) ID and VGS (b) VDs and Vs. 16 V 22K0 =fimA

Q: A square plate residing in the x-y plane is situated in the space defined by -3 m ≤x≤3 m and -3…

Q: 1. What is the equivalent transformer specification if needed to produce an output of 15 volts…

Q: Z * To implement the Boolean function F(Z,Y,X)=[m(0,1,2,4,6,7) using a multiplexer as shown in the…

A: We need to find out the input of given mux

Q: 3. A 4-pole, single-phase, squirrel-cage induction motor operates from a 115 V, 50 Hz supply. The…

Q: 1-Efficiency 2- Ripple factor 3- PIV

A: The power electronic circuit which is used to convert ac power to dc power is known as the…

Q: Question 3 : Determine the number of poles on the RHS, LHS, and jw-axis for the following open loop…

Q: xplain the concept of radiation source in machine vision with different types of lighting.

A: Lighting is one of the most important aspects of the use of machine vision. Failure to properly…

Q: The value of the Vgs that causes the drain current to reach its maximum value; a. 0 b. Vp c. Vd max…

A: In JFET, The maximum drain current IDSS occurs when gate-to-source voltage VGS = 0 V and…

Q: Q1: For the J-K flip-flop, determine the Q output for the inputs in figure below Assume that Q…

Q: 2. The equation for an alternating current is given by I-40 sin (200xt +0.5) volts, find: a) Time…

Concept explainers

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.

Question

2. Current is defined as the rate of charge flow.
If a charge of 0.0065 colombs passes a given
point in a conductor in loa milliseands, calculate the:
a) current in amperes (Hint: I = 2)
b) Current in milliamperes.
Ans: a) 0.065 A
b) 65 mA

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Semiconductor Material and Its Energy Band Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What are the three principal parts of an atom, and what charge does each carry?
Where do electrons exist in an atom, and what is their charge?
How many times more does a proton weigh than an electron?
An 18-gauge copper wire with a diameter of 1-mm carries a constant current of 1-A. The charge concentration in the wire is 8.5 x 1028 per cubic meter. Determine the resistance, in ohms, of a 77-m wire in milli-ohm. Use resistivity equal to 1.72x10-8 ohm-m.
An 18-gauge copper wire with a diameter of 1-mm carries a constant current of 1-A. The charge concentration in the wire is 8.5 x 1028 per cubic meter. Determine the electric field in mN/C. Use q = 1.602 x 10-19 and resistivity equal to 1.72x10-8 ohm-m.
11. What is the resistance of 600 ft. of no. 20 copper wire? Given : Area =1022 circular mils and resistivity ( P) of 10.4 cm- ohms / ft.
An 18-gauge copper wire with a diameter of 3-mm carries a constant current of 1-A. The charge concentration in the wire is 8.5 x 1028 per cubic meter. Determine the resistance, in ohms, of a 1-m wire in milli-ohm. Use resistivity equal to 1.72x10-8 ohm-m. Answer in 4 decimal places.
The temperature coefficient of resistance of a wire is 0.00125 °C-1. At 30 °C, its resistance is 10. At what temperature will the resistance of the wire be 2 ohms? A current of 4.8 A is flowing in a conductor. Determine the number of electrons flowing per minute through the X-section of the conductor.
Three equal charges of +2C are arranged in a straight line in the sequence of Q1, Q2 and Q3. The distance between charge 1 and 2 is 3/4 meters while the distance between charge 2 and 3 is 1/4 meters. What is the total electric field intensity experienced by Charge 3? Note: Your Answer should be in Giga-Newton per Coulomb unit and is written in the form: 14.143x10^9 N/C Pls include figures.
A current of 10.0 A is flowing in a wire. (a) In 1.00 min, how many coulombs ofcharge pass by a point? (b) In 1.00 min, how many electrons pass by a point?
Determine the thermal coefficient of resistance of copper at 50°C, then use this value todetermine the resistance of copper wire at 170° if the resistance of this copper wire at 50°C is50ohms. The thermal coefficient of resistance of copper at O°C is 0.004264/C°
What is the area in circular mils of an aluminum conductor that is 80 ft long with resistance of 2.5 ohms? What is its diameter in inches?