Question 3:Determine the number of poles on the RHS, LHS, and jw-axis for the following open loop system:R(S)C(s)²+45-334+45³ +85² +20s +15Question 4:Determine the number of poles on the RHS, LHS, and jw-axis for the following open loop system:s+8T(s) = 55-54 +353-35² +3s-2

Answered: Image /qna-images/answer/f4b9f942-00f3-4a3d-a98d-7292434bc93a.jpg

Answered: Question 3 : Determine the number of…

Question 3 : Determine the number of poles on the RHS, LHS, and jw-axis for the following open loop system: R(s) C(s) +45-3 s+45³ +85² +20s +15 Question 4:

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 1PP: Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow....

See similar textbooks

Related questions

Q: 1. A voltage divider - R2, R3 is connected to a DC voltage source of e.m.f. E and inner resistance…

A: When two or more than impedence are connected in series then voltage across one impedence = Vtotal =…

Q: using a decoder and external gates, design the combinational circuit defined by the following…

Q: The conductivity of the material given below is o S/m. Find the resistance between the shaded…

Q: xplain the concept of radiation source in machine vision with different types of lighting.

A: Lighting is one of the most important aspects of the use of machine vision. Failure to properly…

Q: Find the rms value of the current waveform of Fig. 11.15. If the current flows through a 9-…

A: given here a waveform and asked to find the rms value and average power dissipated through the…

Q: 6. You have a complicated wire structure with an area of 1 cm², and an average interior magnetic…

A: Given data, Area, A=1 cm2 Magnetic field, B=10-9 T

Q: A 3300/230 V, 50-kVA, transformer is found to have impedance of 4% and a Cu loss of 1.8% at…

A: Given data, A 3300/230 V, 50-kVA transformer percentage impedance = 4% and Cu loss = 1.8% at…

Q: Full adder circuit using Design a and external gates. a decoder

A: In this questions, we need to design full adder using decoder.

Q: A power amplifier has an input of 90mV across 10K ohm. The output is 7.8V across an 8 ohm speaker.…

Q: H.W: Find the Parallel Realization for Z² H(Z) = (2-1) (2-0.5)

Q: 2. Convert each decimal fraction to binary using the sum-of-weights method: (a) 0.32 (b) 0.246 (c)…

Q: 1- The R.M.S. value of a half-wave rectified current is 10A, its value for full-wave rectification…

A: Given data:- Current=10A

Q: 4Ω και = 20 sin(10r + 30°) V 0.2 Η Answers: 8.944 sin(10t + 93.43) V, 4.472 sin(10t + 3.43

Q: Q2: A) Sketch the block diagram of thermal power station, then state the main parts of the plant and…

Q: For the network of Fig. 6.79, determine: (a) ID and VGS (b) VDs and Vs. 16 V 22K0 =fimA

Q: B/ Compute the work done in carrying a 5C charge from P (1, 2, -4) to R (3, -5. 6) in electric field…

A: Given data : Charge Q=5C Path P1,2,-4R3,-5,6 Electric field E=ax+Z2ay+2YZazvm

Q: The main difference between a register and a counter is

A: ans:(d) register has no specific sequence of states

Q: 2. For the circuit shown below, calculate: a) The gain (G) of the amplifier associated with the 1.5…

Q: In an 8-bit 2's complement adder/subtractor circuit, if A=2, B=6, the operation (A-B) results in…

Q: A) Three conductors of a 3-phase line are arranged at the corners of a triangle of sides 2m, 2.5 m…

Q: temperature and that of its surroundings. Suppose that the temperature of a cup of coffee obeys…

Q: D = x^²Y Z ax + 2X Y " Zay + 4x²2az c/m² dz Find @Dx, Dy, Dz Div D For O<X, Y, Z < 1 3 Total charge

Q: the stability of the following -ized system the Lya punor equation conside

A: Solution- Given,X1˙X2˙ =01-2-3+X1˙X2˙Q = IQ =1001Here A = 01-2-3Lyapunov's equation is…

Q: Provide at least 3 Examples of Control Systems Models or Representations and its corresponding…

A: Following control system models are mostly used- Differential equation model Transfer function…

Q: Calculate current 1, in the circuit of Fig. 10.11. Answer: 2.538/5.943° A. Practice Problem 10.4…

Q: Q5:-An electron [pc-620 keV and Eo-511 keV]. Find the phase and group velocities of its de Broglic I…

Q: Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…

A: Given circuit:-

Q: Construct the TT-model of the transistor with all parameters labelled and evaluated.

A: The Given Transistor parameters of β=130 and VBE=0.7V The Given Network diagram is

Q: 2/ What are the main characteristics of a transistor? What are the ways to connect? Among the most…

A: A transistor is a three-terminal semiconductor device, which can be used as an amplifier , as a…

Q: Calculate the voltage needed to supply 2 A through a resistance of 30 ohms

A: It is given that: Current=I=2 AResistance=R=30 Ω

Q: Q2/A-list the characteristics of PIC 17 series B- Explain with drawing the basic blocks in PIC16F48

A: (A) PIC 17 a memory mapped accumulator. read access to code memory (table reads) direct register…

Q: The AC system used instead of DC system power possible to: 1) Reduce the risk of electric shock. 2)…

A: The HVAC transmission is economical up to 400-500Km. If distance is more than that then HVDC is…

Q: B) Four regions of peak loads 5 MW, 7 MW, 8 MW and 10 MW are supplied by a generating station. The…

A: Peak loads are given, 5 MW, 7 MW, 8 MW, 10 MW. Average load factor LF = 0.6 Diversity factor DF =…

Q: Q11/ Operational amplifier with a bandwidth of 3.5MHz has input resistance 3k0. The noise voltage at…

A: To find the noise voltage at the input of the amplifier operated at 25° C Bandwidth, B = 3.5 MHz…

Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the ?second clock…

A: We need to find out output state of given counter

Q: Consider the circuit in Fig. 16.12(a). Find the value of the voltage across the capacitor assuming…

Q: the power factor and transmission efficiency to be the same in the two cases. B) Give a reasonable…

A: Given We need to enumerate few questions based on feeder and transmission design. Please find the…

Q: Quguse Parallel full adder and other type of gates to design a circuit which for form the following…

A: Given & to find: Use parallel full adder and other types of gates to design a circuit that…

Q: Find the output sequence Z for the given input if the output Z is 1 if the total number of I's…

A: Given Data, Input is 11110101001111

Q: (4) A delta modulator is designed to operate at four times the Nyquist rate for a signal with a 3kHz…

Q: Two resistors are arranged as shown with a 12V DC power supply. The two resistors are: R₁ = 220 ohms…

A: Given circuit: V=12 VoltR1=220 ΩR2=330 Ω

Q: 'Construct a 4-to-16 line decoder with 3-to-8 like decoders with enable and external gates.

A: We need to design 4 to 16 decoder by using of 2 to 4 decoders

Q: Using for each op amp circuit shown in Figure 1(a through d). Assume ideal op amp behavior. 30 441…

A: As per guidelines given to us we can only provide the solution of first three subpart in multi part…

Q: A transformer has 1200 primary turns and 200 secondary turns. The primary and secondary resistances…

A: It is given that: N1=1200N2=200R1=0.2ohmR2=0.02ohmX1=1.20hmX2=0.05ohm

Q: There are different states in a 4-bit Johnson counter 8 none of the mentioned 4 O 3 O

A: In this questions we need to find the no. Of possible different state in 4 bit Johnson counter.

Q: If a summing point is placed after a take off point, they will be represented ______ a. separate…

A: If a summing point is placed after a take off point, they will be represented ______ Options are:…

Q: Given the circuit as shown, what is the output voltage (Vo) of the circuit, if E1 and E2 is equal to…

A: The input voltage of E1 and E2 is +10V as given in the circuit. First, check the status of the…

Q: Q18/ Consider the CT signals shown in figure below. Calculate the power and then classify this…

A: In this question, we need to find whether given signal is energy signal or power signal. Also we…

Q: Find the current value for the resistance (4 ohm) using mesh (loop) method or nodal method. All…

A: To find the value of current flowing through 4 ohm resistor in the circuit using Mesh analysis

Q: Ques2: For the periodic signals, find the coefficients of trigonometric Fourier series. -π/4 th TT/4…

A: Types of signals Even Symmetric signals Odd symmetric signals Skew symmetric signals.......based on…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
Solve no.16 and show solutions. (Situation no.07 image below)
11. An air core toroidal ring with a mean diameter of 25 cm and a circular cross sectional diameter of 4 cm is wound uniformly with 500 turns of copper wire of 1 mm diameter. Calculate the inductance of the coil.
A capacitor sensor consists of 3 charged parallel plates having length of 25.5cm and breadth of 31.25mm. These plates are separated from each other by 4 cm. Calculate the displacement of middle plate to get a total change in capacitances of 0.45 pico Farads. Assume upper and lower plates are fixed.
A. Find the following requirements in plotting the root locus. number of branches number of asymptotes asymptote real-axis intercept asymptote line angles real-axis break-away points / break-in points points at the jw-crossing B. Manually plot the root locus based on the requirements from item A.
DHA) A capacitor bushing forms arm ab of a Schering bridge and a standard capacitor of 500 pF capacitance and negligible loss, forms arm ad. Arm bc consists of a non-inductive resistance of 300 Q. When the bridge is balanced arm cd has a resistance of 72.6 2 in parallel with a capacitance 0.148 micro Farad. The supply frequency is 50 Hz. Calculate the capacitance and dielectric loss angle of capacitor. Derive the equations for balance and draw the phasor diagram under conditions of balance.
A capacitor with a capacitance of 3.6360426666667E-10 pF is a parallel plate capacitor. Each plate has an area of 0.0924 m^2 and a dielectric thickness of 0.0135 m. How many parallel sections are there if the dielectric constant of the material is 1?
A parallel rlc circuit containing a resistance of 1.5kohm,an inductance of 0.15h and a capacitor of 100uf are connected in series across a 240v, 60hz supply. Calculate the total circuit impedance power factor and voltage phasor diagram
The supply voltage of an inductive coil with a resistance of 35 ohms and an inductance of 92.84 millihenry has the equation e = 340 sin (377t). Determine the resulting current's equation. a.) i(t) = 6.867 sin (377t + 45°) b.) i(t) = 6.867 cos (377t - 45°) c.) i(t) = 6.867 cos (377t + 45°) d.) i(t) = 6.867 sin (377t - 45°)
given the following points: A(3,-2,0) B (4,5,2) C (-3,2,1) Determine RAB ⋅ RAC
10. The higher the frequency, the easier it becomes to analyze electronics circuits.a. Not all the timeb. Truec. Falsed. In some cases only11. The __ ___ leads ensure low inductance and permit high currents.a. Short, fatb. Long, fatc. Long, thind. Short, thin12. Most microwave amplifiers have input and output impedances of _a. 75Ωb. 50Ωc. 300Ωd. 120Ω Note: Explanation is not needed just provide the correct answers for each number.
SERIES RLC ,TOTAL IMPEDANCE ( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).