2. Determine the equivalent Сеа 8F 6F IOF R₂² SF не pacitance. SIBU Jct/2sto@mapua.edu.ph

Q: F(s) = 16 (S-2) (s²7s +12)

A:

Q: 5. Who is the tallest? a. 6 feet 2 inches tall b. 187.96 cm c. 1.8796 m d. 74 inches e. All

A: we are given with various options of height, and we have to find out the tallest out of all given…

Q: 25 Given the closed-loop transfer function T(s) = s2+7s+25 Find wn, Ts Natural Frequency wn =…

A: Given, Transfer function, Ts=25s2+3s+25

Q: Which of the following is constant in a parallel circuit? Voltage Power Current Resistance…

A: For two or more elements connected in parallel, both the terminals of elements must be connected to…

Q: Fig. shows the single line diagram of a 3-phase system. The percentage reactance of each alternator…

A:

Q: Problem 1. A parallel-wire air-spaced transmis- sion line operating at 1910 Hz has a phase shift of…

A: Given a parallel wire air spaced transmission line operating at, Frequency, f = 1910 Hz Phase shift,…

Q: Please solve the following problems show a step by step solution. Use four decimal places. Use the…

A:

Q: Que 2.23. What should be the value of R, so the maximum po can be transferred from the source to R,…

A: The maximum power will be transferred to the load if the load resistor is complex conjugate of input…

Q: Multiply (4 + j6) * 9<54° O in rectangular form, -22 +j60.87 NFTOC O in rectangular form, -22 -…

A: Given here a complex number and polar of a number and asked to multiply both.

Q: A 10-μF capacitor is connected to a supply which produces a voltage wave having two sinusoidal…

A:

Q: V R ww 2₁ + Vcc Vo - ↓ A ww Q2 R V+ -VEE 1. Show that the voltage VO has the form: Vo = R*IA*tanh(Vd…

A:

Q: Problem 07.028 For the circuit shown in the given figure, assume f- 60 Hz. V-9020 V. R=25 ohm, XL 80…

A:

Q: The magnetic field is given as: H = 1ax + 2z²ay – 3yaz A/m Find the x-component O 1.5 A/m² O2A/m²…

A: Given magnetic field, H=1ax+2z2ay-3yaz Am

Q: Determine all the mesh currents. Assume clockwise direction of urrents.

A: Given- Voltage source= 100V and 50 V To find- Mesh current=? Circuit is-

Q: Determine v, and i in the circuit shown in Fig. 2.23(a). 12 V 4Ω www 6Ω www % + (a) 2% 4 V

A:

Q: 0=685-1922,2=0.00497 Neper / mile 1=0.0352 rad /mik at 1000 Hz. If Z₁ = 2 and E= 10 Vrms with Zgs…

A: Given, l=1000 miles Zo=685-j92 ohm α=0.00497 Np/mile β=0.0352 rad/mile f=1 KHZ ZL=2000 ohm E =10Vrms…

Q: (526) 10 =(------------)10%

A: .

Q: roblem 12. A cable has the following primary constants: resistance R= 80 $2/loop km, conductance,…

A: Given a cable has the following primary constants: Resistance, R=80 Ωloop km Conductance, G=2 μSloop…

Q: There is currently substantial interest in the development of electric vehicles, which may well…

A: Electric vehicles had become a fascinating part of Electrical engineering because it involves many…

Q: What is the minimal solution for the Kmap shown? AB CD 00 01 11 10 00 1 1 01 1 1 1 11 10 1 1 1

A: Given K-map,

Q: The frequency of e.m.f. generated in an 8- pole alternator running at 900 r.p.m. is

A: Given an alternator with, Total number of pole, P = 8 Synchronous speed, Ns=900 rpm Frequency, f =?

Q: 2. series RLC circuit has a resistance of 60 ohms, a capacitance of 10-2 Farads, an inductance of 5…

A: Series RLC circuit has the following parameters : R=60 ΩC=10-2 FL=5 Happlied voltage=20sin5t volts =…

Q: Advantage of using a high frequency carrier wave is

A: The correct option along with the explanation is provided in the following section.

Q: A 25 KVA, 100 V/300 V, single-phase transformer has a secondary terminal voltage of 280 V when…

A: Given, A single phase transformer is having S=25 kVAV1:V2=100V/300V Secondary load voltage, V2fl=280…

Q: For the circuit shown, calculate the magnitude of line current at line Aa. TAG EAB = 208 V 0° ECA =…

A:

Q: 1) An SCR has a circuit fusing rating of 90 A²s. The device is being used in a circuit where it…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Consider a causal second-order system with the transfer function 1 G(s) = 1+2s+s² with a unit-step…

A: The given transfer function is G(s)=11+2s+s2Unit Step R(s)=1sWe have to find the time taken by the…

Q: A 3-phase, 50 hp, 400 V, 4-pole, 60 Hz, wye-connected synchronous motor has an armature winding…

A:

Q: The equivalent resistance of the resistive network shown below is 50 a www o 109 50 bo www O a. 2002…

A: Given circuit,

Q: What is the maximum transmission efficiency of an AM signal?

A: The solution is provided in the following section.

Q: Problem 1: Suppose voltmeter is used to measure the voltage across the 40 resistor. for the circuit…

A: Given circuit:

Q: Consider a causal second-order system with the transfer function 1 G(s) = 1+2s+s² with a unit-step…

A:

Q: (2) V2 sine 1 kHz BAT2 15 V R1 7 ΚΩ Q1 2N2222 BAT1 15 V ww R3 ww Q2 2N2222 3 ΚΩ R2 7 ΚΩ D V3 sine 1…

A: Given, R1=collector resistance of BJT1=short R2=collector resistance of BJT2=7kΩ V2=Input base…

Q: Determine the current I in the given circuit, using the superposition theorem. 10 10 ν 19 3 Ω www…

A: The given circuit is shown below. Find the current I.

Q: What is the difference between standard FSK and MSK? What is the advantage of MSK?

A: Solution !! Minimum Shift Keying (MSK): The minimum frequency space that allows 2 fsks representing…

Q: R(s) + G1 G2 G3 G4 +1 + G5 G1 FIGURE P5.5 Anter +A G6 day bindell C(s)

A: Given diagram,

Q: Determine the current I in the given circuit, using the superposition theorem 3Ω Μ 10 V 1Ω 19 ΖΩ ww…

A: When multiple source act on circuit then circuit parameter can be obtained by using superposition…

Q: answer number 3 asappoo

A:

Q: A delta-connected unbalanced load is connected across a three-phase balanced source. The sequence…

A:

Q: 1'0 Derive the expression for ladder network shown in 0%. Y₂ Ys 6 Z 02

A: Solution according to the question asked !!

Q: 1. 2. A wire carries a steady current of 2.00 Amp over a period of 600 ms. What total charge passes…

A:

Q: Determine the currents i and in, and the power developed in the 64V voltage source and 8-0 resistor…

A: The required parameters can be calculated by using mesh analysis. The equation cannot be formed for…

Q: Add 398Bcd to 269BCD Showing carries and digit corrections

A: The BCD representation of the number 398 is,  3: 00119: 10018:1000398BCD=0011  1001  1000 The BCD…

Q: A transformer having a turn ratio 1:5 and a resistance of 1000 ohms is connected across the…

A: Given data, Turn ratio, NpNs=15 Secondary resistance Rs=1000 Ω

Q: A 120-22 lossless line is terminated with 40- and 20- resistors in parallel. The voltage at the…

A: Given:- 120 ohm lossless line terminated with 40 ohms and 20-ohm resistors in parallel,…

Q: 2. What is the saturation current at 30°C temperature if at 20°C the saturation current of a silicon…

A: I am giving answer of number 2  question. As we know that reverse saturation current doubles every…

Q: FIND Pt. An 212 32 f₁. 22 42 = Is fre t le F2R -

A:

Q: In a balanced three-phase system, the source has an abc sequence, is Y-connected, and Van 126/16° V.…

A:

Q: As a designer, you are considering a switch from Al to Cu metal interconnects. Given the resistivity…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: For each graph, state the amplitude, period, equation of the midline and the sine equation. The…

A: Given:  4 sinusoidal signals with specifications Xmin= - 900 , Xmax=  3600 , Xscl=300  Ymin= - 2 ,…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.