Answered: 2. Find the RMS value of the voltage…

2. Find the RMS value of the voltage waveform and the average power absorbed by the 9 ohms resistor if the voltage has the same waveform v(1) (V) A 6 m 2 3 6 1 (s) 7

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2MCQ: If the rms phasor of a voltage is given by V=12060 volts, then the corresponding v(t) is given by...

See similar textbooks

Related questions

Q: Given: L = 4pH; C = 11.26nF; R=0.18842 IF = 455kHz RF RF Filter Amplifier Mixer IF Amplifier &…

A: For the above given question we need to calculate the value of resonance frequency, quality factor…

Q: In a certain CS amplifier, RD = 2.84kΩ,RS = 560Ω, VDD = 10 V, AND gm = 5.58mS If the source resistor…

Q: A schematic Diagram is given below. Label each component with appropriate reference designator.…

A: For the above given question we need to write designations of all the components which are present…

Q: Q1. Correct the following statements without changing the underline words: (do not use NOT) 1- The…

A: Diode: It is a semiconductor device and this is unidirectional because it flows the current when it…

Q: 9.42 Calculate vo(t) in the circuit of Fig. 9.49. 50 Ω 30 S2 ww HH + 50 μF 0.1 H (1) 100 sin 200t V…

A: The inductive reactance and the capacitive reactance of the circuit is, vt=100sin(200t)…

Q: 3 k m + DR (1) (1) 18 mH Xo 1=0 Q2) The switch has been closed for a long time before opening at…

A: For the above given question we need to calculate values of all the transient parameters of the…

Q: Which of the following statements is correct regarding electrical safety? Question 11 options:…

A: The objective is to determine whether the statement is true or false.

Q: / For the figure below shows a d.c. Two sources network. Using the superposition theorem to find the…

A: given here a electrical circuit and asked to find the current through the 10 ohm resistor using…

Q: ANSWER IT. ABC D

A: Given a logic circuit and we need to implement it with the nand gates.

Q: Example 8.11(b). A 4-pole lap-connected armature of a d.c. shunt generator is required to supply the…

A: DC shunt generator- In a shunt-wound generator, the field winding is connected across the armature…

Q: 12 V +t e 20.0 Ω E W 2.0 Ω w 10.0 Ω W 10.0 Ω w 6 How much current is in one of the 10 22 resistors…

Q: G₂₁ 0.1 F C3 220 pF R₁ 10 ΚΩ Vcc +30 V O C₂ R₁ 10 ΚΩ I

A: For the given value of passband frequency and quality factor we need to compute the value of…

Q: 9.60 Obtain Zin for the circuit in Fig. 9.67. 50 Ω j30 Ω Ο -j100 Ω — Ω 40 Ω Zin 0 Figure 9.67 For…

Q: Example 04:- A capacitance comparison bridge (similar angle bridge) is used to measure a capacitive…

A: Given A capacitance comparison bridge.we need to find the equivalent series circuit of the unknown…

Q: A schematic of a buck converter is shown below. Vin is the DC Input voltage. CTRL is a control…

A: Given A schematic of a buck converter is shown below. Vin is the DC Input voltage. CTRL is a…

Q: +V 'BB RB Rc +Vcc

A: We need to find out the base current for given circuit

Q: Find Z₁ for maximum average power transfer and the maximum average power transferred. ΠΩ www 1Ω…

Q: y doping semiconductors, it is possible to create materials with specifically d lectromagnetic…

A: Solution- Given, f= 10THz = 10×1012 Hz = 10000 GHzE→ = E→ejωt =E→ejωte-jrzr =α+jωE →=E→ejωt-rzσ =…

Q: Grey converters are often used in industrial circuits where the normal sequence of binary numbers…

A: Xor operation: The output of 2 input xor gate is high only when there is odd number of one's in the…

Q: Compute the closed-loop poles. What effect does increasing the free pa- rameter Kp have on the…

A: Note: Transfer function is not given so I am considering transfer function and then finding the…

Q: (d) (a)+(b)+(c) 3- The generation of electricity achieved by moving a conductor in a magnetic field…

Q: (g) For the resistive circuit in Fig. A-3. Calculate at point "A" (i) The Thevenin equivalent…

A: In this question, We need to calculate the Thevenin resistance and Thevenin voltage across the…

Q: Example 05:- An inductance comparison bridge is used to measure inductive impedance at a frequency…

A: In this question inductance comparison bridge is given at balance.....We have to find out equivalent…

Q: Consider the circuit in Figure A2 where Vs = 12 V, R₁ R₂ and the input is a sinusoidal signal with…

Q: Required information Obtain the steady-state response of each of the following models, and estimate…

Q: An averaging amplifier has seven inputs with RF = 36.51 kohms, what should be the value of each…

A: An averaging amplifier has seven inputs with RF = 36.51 k Ωhere we have to find the input resistance…

Q: Use superposition to find the phasor current, I, for the circuit below. 13 N -js Q Ht Ω ΣΩ 20/-30° V…

A: In this question we need to find a current I by using superposition theorem.

Q: 3. Which of the following statements IS NOT CORRECT ? * for two motors with equal output power,…

A: Motor: It is an electromechanical device. this takes the electrical input and converts this power…

Q: Calculate the input voltage* (in millivolts) if the final output is 24.19 V. Vi= _mV *note…

Q: Find the equivalent resistance across the terminal 452 www 202 402 4 692 60 www 892 202 892 B

A: Given:

Q: In a certain CS amplifier, Rp = 1.44k2,Rs = 56002, VDD = 10 V, AND gm = 4.36mS If the source…

A: Given: The resistances, voltage and the transconductance are, RD=1.44 kΩRS=560 ΩVDD=10 Vgm=4.36 mS

Q: An uncompensated system shown in Figure 3(a) has forward transfer function G(s) with a unity…

A: The Given Transfer function is Gs=ass+b To Design a phase lead compensator. To cascaded with the…

Q: Answer the following questions: a) What is the physical meaning of Mutual Inductance? b) Explain the…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: 1: Answer the following sentences with (True) or (False) then correct the false sentences: 1- When…

A: We need to tell about whether the given statement are true or false

Q: The Excess -3 code of 6 is O a. 0110 Ob. 0111 C. None of the above Od. 1001

A: We need to find out excess 3 code of given digit

Q: Q4 write a program that will print the following multiplication table 1 24 369 4 8 5 10 12 16 15 20…

A: Writing the program in python language,

Q: Calculate the gain of a negative feedback amplifier having A = -2,005 and 3 = -0.065.

Q: E7.11 The voltage source in the network in Fig. E7.11a is shown in Fig. E7.11b. The initial current…

A: The output response of the circuit can be calculated by analysing the circuit at various time period…

Q: D) ANSWER IT. А ВС э

A: To implement using NAND GATE

Q: In your answers below you may use sqrt(), but no trig functions, complex multiplication, or powers.…

A: As per our guidelines we are supposed to be the first question only. Kindly repost the other…

Q: Find v and ic for t> 0 if i(0) = 1A and v(0) = 8V. 4H 20 250 mF H6 ic + > 802

A: By using Laplace domain circuit can be drawn as shown below:

Q: Let A = (3y - z)ax + 2xzay Wb/m in a certain region of free space. (a) Show that V.A = 0. (b) At…

A: We need to find out the divergence of A and magnetic field and current density.

Q: e Loop antennas

A: Antenna- An antenna is a structure made up of metal which captures or transmits radio…

Q: 1. If Vass = 6mA and V₂ = -6V with ß BJT = 100. Calculate A. Draw the Thevenin replacement circuit!…

A: For the above given combination of JFET and BJT circuit we need to calculate the value of all the DC…

Q: Q2. Find the convolution of the two finite length sequences: x(n) = 0.5n(u(n) – u(n – 6)) h(n) = 2…

Q: 6 For the state machine shown in Figure Q6 do the following: (a) Is this a Moore Machine or a Mealy…

A: As per our guidelines we are supposed to be answer the first three subparts only. Kindly repost the…

Q: For the figure below, obtain the actual value of I„ . 14 6Ω 2 V I Μ 3 I, = 15 A 7Ω www 2Ω 1 V www 4Ω…

Q: Q1. Express the sequence: x(n) = 1 2 3 0 n=0 n=1 n=2 otherwise

Q: Calculate the output impedance of a voltage-series feedback amplifier having A = - 230, Ri = 1.5 kΩ,…

Q: Diode Model: 1N5817 R = 10k Vi= sine (05 100) Given the parameters above, simulate the given circuit…

A: The Given circuit is R=10kVi=sine0 5 100 To simulate the given circuit

Concept explainers

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.

Question

2. Find the RMS value of the voltage waveform and the average power absorbed by the 9 ohms
resistor if the voltage has the same waveform
v(I) (V) A
6
I
2
1 (s)
0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

P-channel Metal-Oxide Semiconductor (PMOS), N-channel Metal-Oxide Semiconductor (NMOS), and Complementary Metal-Oxide Semiconductor (CMOS)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero
The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
determine the average rms values for the function: y(t)=25+10 sin6(pi)t
A coil has a resistance of 50 ohms and an inductance of 0.5 Henry. What is the RMS value of current flowing in the coil if the supply voltage is Vt = 500sin377t.
Determine the peak-to-peak voltages, RMS voltage, frequency, period and phase shift for the following expression: v(t) = −10 sin (2π 250 t + 180°).
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags behind A by pi/3 radians and the line current is 23.4 amp, determine the current in B.
A wire is carrying a direct current of 20 A and a sinusoidal alternating current of peak value 20 A. Find the rms value of the resultant current in the wire.
13. If an AC signal has an average voltage of 18 V, what is the rms voltage? a. 19.9930 V b. 25.4558 V c. 28.2743 V d. 39.9860 V
Consider the following equation: v (t) = 110 sin(78.5 t) Calculate: Frequency (f) = ? Time period (T) = ? Peak Voltage (Vp) = ? Average voltage (VAVG) = ? RMS voltage (VRMS) = ? Sketch the labelled waveform showing Peak voltage, full cycle and half-cycle times.
44. The equation for 60 cycles current sine wave having RMS value 30 amperes, will be __ A. 42.4 sin120pi t Amp B. 30 sin 120t AmpC. 30 sin60t AmpD. 42.4 sin 60pi t Amp
Find the RMS voltage of a waveform whose voltage is v(t) = 17sin(70t) Vp
An alternating voltage is given by v = 20 sin (100πt – π/2) volts. Find (a) the amplitude, (b) thepeak-to-peak value, (c) the r.m.s. value, (d) the periodic time, (e) the frequency, and (f) type ofcircuit if voltage is 200 sin 100πt.