2. For a series RC high-pass filter, component values are given as R = 10 k and C = 0.01 µF. The amplitude of the source voltage is 10 V peak-to-peak. a) Calculate the cut-off frequency in Hz. b) Calculate V, in magnitude when the source voltage has frequencies of 0.4, 0.8, 1.2, 1.6, 2, 4, 8 kHz.

Q: For the transfer function given, sketch the Bode log magnitude diagram which shows how the log…

A:

Q: 1.20. Given the spectrum -4 sin [r (f – 10°) 10-1)2 n (f- 10) 10-4 Gx(f) = 10 find the value of the…

A: Dear student ,the question has multiple sub-part .We have limited time to solve your question.kindly…

Q: Design a linear phase FIR filter using Rectangular window and implement using linear phase…

A: Given: The desired frequency response is given as: Hd=e-jωα,  ω≤π40,          otherwise and N=5 So,…

Q: 5. a. Find the bandwidth of a series resonant circuit having a resonant frequency of 6000 Hz and a…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 10.1 Design an FIR linear-phase, digital filter approximating the ideal frequency response 1, for wS…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Design an RLC handpass passive filter (parallel LC) if e5 KHz, C=lpF, =1KHZ, A) Draw the circuit,…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 12.52 A variable-frequency voltage source drives the network in Fig. P12.52. Determine the resonant…

A:

Q: Ex. 753. For the transfer function (TF) 4s/(s+9) and resulting Bode Plot, calculate the gains (dB)…

A:

Q: Discussion: 1. Compute the Band Width and Power of AM-SSB? 2. Which side the filter is select (upper…

A: We need to tell about amplitude SSB modulation

Q: A series RLC circuit has a source voltage 30 Vrms (reference) and a resonant frequency of 10 kHz.…

A: The inductor and capacitor exchange energy between themselves. At resonance, the energy exchange is…

Q: 4. 2+ jøl0 frequency (in Hz) , (ii) Calculate the gain and phase of H(@) at w = 2 rad/s., (iii)…

A: Given,  Transfer function of filter is  H(w)= 4/(2+jw10) The cut off frequency (fc) is the frequency…

Q: source voltage V:(t) = 10cos2Tf,t. Connect the oscilloscope to the output and measure the output…

A:

Q: Draw the circuit diagram of a second-order highpass filter. Suppose that R=1 kΩ, Q s = 1 and f 0…

A: Given data: R = 1 kΩ QS = 1 f0 = 100 kHz   The circuit is given as, The expression for f0 is…

Q: 21.5 For a series RLC circuit... a) Find the bandwidth of a series resonant circuit having a…

A:

Q: (c) A power supply with ms voltage 400V and frequency 50HZ is equipped with a resonant harmonic…

A:

Q: 100 мF For the given passive circuit + a) Determine its filter-type. b) Find the cutoff frequency…

A: As per our policy we can provide solution of first three questions only. For a) Its  a high pass…

Q: 2) Create Bode plots of the magnitude transfer functions of high-pass filters.

A:

Q: Find the frequency response (magnitude and phase) of the system at w = 0, n/4, a/2 and a radians.…

A:

Q: Provide the Bode plot (sketch the gain |H(jw)| and the phase shift ZH(jw)) of a system with the…

A: Write the given transfer function.

Q: 3. Determine the magnitude and phase of the Frequency Response H(w), for the three-point moving…

A:

Q: 2- for the high Pass filter shown below derive te CHes)), ( Hegws), (Wc), (Vout) . thank 242 lv

A: The solution is given below

Q: A power supply with rms voltage 380V and frequency 50HZ is equipped with a resonant harmonic filter…

A:

Q: For the following bandpass filter circuit, calculate the given value. (a) Transfer function H(s)…

A:

Q: Problem 21: Design a RC low-pass filter to have a cutoff frequency of 500 Hz using a resistor of 1.2…

A: cut-off frequency is the break frequency and corner frequency and it is define the boundary…

Q: Consider the filter circuit shown in the figure below (a) What type of filter is this? Calculate its…

A:

Q: For the bandpass filter circuit of Fig. 6. Find the following: i. Centre frequency, wo. ii. Lower…

A:

Q: 4. Show the pole locations on the complex plane for a Butterworth filter to meet the following…

A: According to the question, Amax=1 dB;Amin=30 dB;fp=15 kHz;fs=20 kHz; we need to find the poles of…

Q: 1. For a series RC low-pass filter, component values are given as R = 10 kN and C = 0.01 µF. The…

A: Given data: R=10 kΩ C=0.01 μF Input voltage: 10 V (a) Cut off frequency is given by, fc=12πRC…

Q: What is the expected frequency at resonance fs if v = 50, R = 2.2k ohms, XL = 1.0k ohms, XC = 1.0k…

A: The resonance frequency for RLC circuit is given by: Where,  The inductive reactance is “XL”, The…

Q: Example 05:- For the filter circuit shown, sketch the frequency response and determine the cutoff…

A: To get cutoff frequencies first transfer function is obtained.by comparing the obtained transfer…

Q: a) According to the circuit in the Figure 1: I. Write down the type of this filter (Output taken…

A:

Q: a. Find the bandwidth of a series resonant circuit having a resonant frequency of 6000 Hz and a Q,…

A:

Q: 3) Consider the following band-pass filter. Setup the circuits in Figure 10.3. (Vin(t)= 5sin(@t))…

A: Magnitude Plot:

Q: 2) A series RLC network has R=2 k2 ,L=40 mH, and C=1 µF. (a) Find the resonant frequency and the…

A:

Q: For a parallel RLC circuit, if R = 40 ohm, L = 2H and C=0.5 F. the bandwidth and quality factor are…

A: we  need to determine bandwidth and quality factor.

Q: Consider a linear time-invariant system such as |H(jw)|= 120,000/ 160,000 + 16w^4. Assume the…

A: Hjω=120000160000+16ω4   To characterize whether the given filter is low pass, high pass or band pass…

Q: 3. Determine the magnitude and phase of the Frequency Response H(w), for the three-point moving…

A: Frequency response: It is the steady state response of the output when the sinusoidal input is…

Q: Q1) For the parallel RLC bandpass filter shown in the circuit below: R = 795.774 N, L = 253.303 µH,…

A: A RLC bandpass filter given in the network Find the center frequency, bandwidth quality factor and…

Q: Direction: Round off your answers to three decimal places. a) The filter of a diode detector circuit…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: If a filter is non ideal, the gain in the passband (0 ≤ w ≤ wc) is one for the entire band, and the…

A: In this question  we have analyse the behaviour of non ideal filter. So here is given that : If a…

Q: 1. Calculate the cut off frequencies and central frequency of the circuit given in photo with C=10…

A: We need tell about series rlc circuit , where we need to find out center frequency and lower and…

Q: Example 05:- For the filter circuit shown, sketch the frequency response and determine the cutoff…

A: Given the circuit, as shown below: We need to sketch the frequency response and cut-off frequency.…

Q: Plot the module and frequency response phase for the low-pass filter shown in the figure below…

A:

Q: For the circuit at right, determine the magnitude, in decibels, of the voltage transfer function at…

A:

Q: Let v, = 20cos(10t) V. in the circuit below. Find the resonance frequency, ab, %3D in radian/sec.,…

A: Given:

Q: 1.A series consist of 30 - 2 resistor , 0.15henry inductor, & a 0.15 uf capacitor,. If a variable…

A:

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.