2. Ik L IV 2 кл 2v-M 3v 3 кл R2 ilkir Vo=? M 2

Q: 1.1 Find the relationship between V and V in circuits a and b of figure 1 assuming b) a) R R mmm…

A: The ideal op amp is a variation on the ideal amplifier concept. At all frequencies, a perfect…

Q: 2. For the network of Fig. 5.162 : a. Determine re and pre. b. Find Zi and Zo. c. Calculate Av. 16 V…

A: A closed path, where electric current can flow defined as an electric circuit. It is various…

Q: Design a second order low pass filter at a cutoff frequency of 2kHz with a pass band gain of 20.…

A: Types of filter Low pass filter  High pass filter  Band pass filter  Band stop filter

Q: Determine the nodal voltages for the networks in Figure? ane 1₁ = 3A 40° 000 501 40 20 1₂ = 5A230

A:

Q: AJFET PN junction is between the (A) gate and channel B) drain and channel C) source and channel…

A:

Q: Use Bode stability to find the following system stability 1 1. GOL = S-1 10 e 3s 2. GOL 4s+ 1 =

A: Given  Open loop transfer function systems and we need to find the stability. Please find the below…

Q: Q5: Compute the magnetic field intensity B of a long straight wire that has a circular loop with a…

A: Disclaimer As per the Bartleby guidelines we are allowed to answer only one question at a time Since…

Q: 1.4 A charge of 2 C flowing past a given point each second is a current of 2 A.

A:

Q: A 3-phase transmission line, 160 km long, has the following constants: Resistance/phase/km= 0.2 ohm…

A:

Q: Compare Insulators

A: Insulator in transmission line- The device used to protect transmission line and prevent the…

Q: Circuit Diagram V1 R1 50 Q 220 Vrms 60 Hz 0.⁰ L1 100mH Computed Values Compute the expected power…

A: It is given that: R1=50 ΩXL=2πfL1XL=2π×60×10×10-3XL=3.769  Ω

Q: A system that is excited by a unit step input gives the following response, c(t) = 12e-t + 4e-3t…

A:

Q: Ex6: Find the unknown currents x ₁ = 1, X 2= 12, X 3 = 13 in the electrical network fig(1). Solve…

A: circuit solve from.kcl kvl as shown below

Q: 1. Explain electric arc discharge V-A characteristic in DC and AC modes.

A: Electric arc :- It is a electric discharge of the gases that is produces by passing electric current…

Q: Given the vector field in spherical coordinate system: A = 8sindag. Determine the value of its…

A: given the vector field in spherical coordinate system A=8sinϕ aθwe have to find the value of its…

Q: 1-A d.c. shunt motor is running with certain load. The effect of adding an external resistance field…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: Find the Inverse Laplace Transform of the following functions 3 F(s) = S³+3s²-s-3 (s²+2s+5)²

A: given Laplace equation

Q: 6) Solve the meshes and order the matrix of the following way: [AB] Then, what is the value of E and…

A:

Q: ( Vi=5V lo кл ww lokr MW 10 kr + 10 kr ↑ 35 kr 5 кл V₂ ↓ FIND THE OUTPUT VOLTAGE (Vo)

A:

Q: Is a 16-bit register containing address of 64 KB segment with processor instructions. code segment a…

A: Stack segment is also a 16 bit register contatin 64 KB segment with programs stack Code segment is…

Q: 8-14 Find the steady-state current in the RLC-circuit in Fig. 61 for the given data. Show the…

A:

Q: A) What are the addressing mode and physical address for each instruction if you know…

A: Given  Register address of a 8086 microprocessor.we need to determine the physical address of the…

Q: -5v 1010 m 1010 W SIW Find Vo 1010 no 1019 w SIW ↑ Vo

A:

Q: If an FM wave is represented by the equation e=10sin (9×10³t+4sin 1500t), then what is the carrier…

A:

Q: An FM wave uses a 2-5 V. 500 Hz modulating frequency and has a modulation index of 50. The deviation…

A: Given an FM wave uses, Modulating frequency, fm=500 Hz Modulation index, μ=50 Frequency deviation,…

Q: Referring to the figure below, Given Vcc= 20 V, R1 = 500k, R2 = 3k and R3 = 1k. Calculate the lg if…

A:

Q: AJFET data sheet specifies Vas(off) = -6 V and loss = 8 mA. The value of lp when VGs = -3 V is Blank…

A:

Q: Briefly explain the working of following power plants a) Thermal Power plant b) Hydel power plant

A: thermal power Plant coverts heat energy to electric power / Energy. The basic principle of these…

Q: Determine the true power and reactive power of the circuit shown. Vrms 2V ƒ= 2 kHz с 0.01 μF

A:

Q: Q4: An op-amp multivibrator circuit is constructed using the following components. R₁ = 30kΩ…

A: We need to find out the frequency of multivibrator

Q: Q3/A- Find Fourier transform of the following signal: f(t) = e-³¹u(t)

A: given f(t)=e-3tu(t)here we have to find the fourier transform of f(t)

Q: A single-phase electrical load draws 1000KVA at 0.6 power factor lagging Find the real and reactive…

A: Given, A single phase load draws, S=100 kVA Power factor, cosϕ=0.6 lagging

Q: The cylindrical-rotor synchronous machine * is with is with maximum air-gap along the direct axis…

A: There are two types of synchronous machine: Cylindrical rotor synchronous machine Salient pole…

Q: A 37.5 kVA, 2300/230 v single-phase transformer has an equivalent impedance of referred to the high…

A:

Q: Gven: A(2.5.7) and B(-1,3.-4) determine the displacement vector RAB. O a. O b. 3.2.-11 O d.

A: We need to find out given vector

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: Transfer function is the ratio of Laplace transform of output to the Laplace transform of input.…

Q: 1. Find V1 and the power absorbed in the resistor 12 ohms by using thevenin theorems. 74.0 16.4 Ո…

A:

Q: ● Calculate

A:

Q: An electrical system has a load of 5,000 kw at a lagging power factor of 0.67. If a 3,000-kva…

A:

Q: A square bar of 1 cm dimension and 30 cm long formed into a ring leaving an air gap at both ends of…

A:

Q: The maximum deviation allowed in a frequency modulation system is 100 kHz; the modulating signal…

A: Given a frequency modulation system with, Maximum deviation, δ=100 kHz Modulating signal frequency,…

Q: "If Va is equal to 302angle;74 and Vab is 523.079/44, the phase sequence is:" O POSITIVE O NEGATIVE

A: A phase sequence is called positive when the Phasor is rotating in clockwise direction in a balanced…

Q: A metal rod is 2m long and 8mm in diameter. Compute its resistance if the resistivity of the  metal…

A: Resistance- The electrical resistance, R of this simple conductor is a function of its length, L and…

Q: Referring to figure, determine the lp, for VGs = -3.2V Voo 2.2 M2 www 69+ ID Vas 4.3 k2 S Rs 1k £2

A:

Q: he value of 1₁ and 1₂? E,= 10V 201 R 40 60 80 E₂40 V 60°

A:

Q: 2.10 In the circuit of Fi 2.67, a decrease in R3 leads to a decrease of: (a) current rough R3 (b)…

A: Steps: Choose some value of R1 ,R2 and R3 and do the voltage and current calculations  Reduce R3…

Q: What is the Peak Inverse Voltage (PIV) of a Bridge-type rectifier if Vp = 12V? Group of answer…

A: We need to select correct option for PIV inversion voltage .

Q: Q2: An AM modulator shown in figure below: a) Sketch the amplitude spectrum of Þ(t). b) Find the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: In Figure 3.3 shows the circuit diagram of a typical n-channel JFET common source amplifier. If ac…

A: The circuit parameter are given…

Q: What is the value of ix?

A: Brief description: For the above given question we need to calculate the value of current ix.

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.