Gven: A(2.5.7) and B(-1,3.-4) determine the displacement vector RAB. O a. <3.2.11> O b. <2.15.-28> 3.2.-11 O d. <2.5.7>

Q: 15 The voltage 2,000,000 V can be expressed in powers of 10 as: (a) 2 mV (b) 2 kV (c) 2 MV (d) 2 GV

A:

Q: w R + 30 V For the circuit shown above, if the 30 resistor Ris (a) 12Ω (b)10Ω (c) 6 Ω ΖΩ V voltage…

A: Given circuit: Power delivered by source, P=150 W

Q: 1. Calculate the lc in figure below with beta = 80 Vcc= 12 V 550k Select one: O a. 0.174mA O b.…

A: given here a BJT npn transistor based circuit and asked to determine the current Ic .

Q: 8. Reduce the parallel subsystem below into its equivalent transfer function C(s) / R(s). X₁(s) =…

A:

Q: Write the appropriate term for the following questions A clipper or limiter circuit consists of a…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: A single-phase electrical installation, supplied by a volta includes in Two single-phase motors,…

A:

Q: A generating station has four bus-bar sections. Each section is connected to tie-bar though 20%…

A: Busbars is used carry high amount of current. In every home electrical panel has busbars to…

Q: Two point charges exert force of 0.49 grams on each other. If the charges are 3.2 cm apart and with…

A: We need to find out the value of charge particle

Q: Q2) an infinite length cylindrical tube of conductor with (2<p <= uniform distribution over the…

A:

Q: For the ideal op-amp shown, what should be the value of resistor Rf (in kilo Ohms) to obtain a gain…

A:

Q: Given the vector field in spherical coordinate system: A = 4sindag. Determine the value of its y…

A: given here the vector field in spherical coordinate system is A= 4 sinϕaθ. here we have to find the…

Q: The maximum deviation allowed in a frequency modulation system is 100 kHz; the modulating signal…

A: Given a frequency modulation system with, Maximum deviation, δ=100 kHz Modulating signal frequency,…

Q: Communication . Draw the Split-Phase Manchester code for the following binary data: (1001010110)

A:

Q: Problem 3: Reduce the Block Diagram to Canonical Form. R(s) G₁(s) G₂(s) Gy(s) H₁(s) H₂(s) Hy(s) C(s)

A: Closed loop transfer function is:=G(s)1±G(s)H(s)+ for negative feedback - for positive feedback

Q: 15KV 100 MVA S Z₁ =j15% Z₂=112% Z₁ -17% At + AR Zunes = Zune2=1382 38 ZLineo=1532 138/15KV 15/138 KV…

A:

Q: Q1 of 2) The circuit given has reached steady state before the switch closes at time t = 0. (a)…

A:

Q: Problem 9. A coil of inductance 318.3 mH and neg- ligible resistance is connected in series with a…

A: Given:  In a series RL circuit, L=318.3 mHR=200 ΩV=240 Vf=50 Hz

Q: Find the total energy stored in the circuit of Figure below 60 L₁ = 2mH 302 = 4 mH m www C₁ = 20 µF…

A:

Q: An electrical system has a load of 5,000 kw at a lagging power factor of 0.67. If a 3,000-kva…

A:

Q: 8/ Find the modulation index for the following AM modulated signal: 0.6 0.8 5 211004112 1.5 0.5 -0.5…

A: We need to find out the modulation index for given signal .

Q: Is a 16-bit register containing address of 64 KB segment with processor instructions. code segment a…

A: Stack segment is also a 16 bit register contatin 64 KB segment with programs stack Code segment is…

Q: Q5-B: Complete the sentences with a word from the box. snack stressful despite of comfortable train…

A:

Q: Determine R₁, R., Rc of the following for the given networks Vcc 9V Re R R₂-20KQ L-101 4₁ a=0.98…

A:

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: Brief description :  For the above given transfer function we need to calculate its step response.…

Q: What is the velocity of an electromagnetic wave in free space?

A:

Q: ough the inductance XL for e 1₂ X50 260 E X₂ ele 41. 802

A:

Q: A 37.5 kVA, 2300/230 v single-phase transformer has an equivalent impedance of referred to the high…

A:

Q: Find the charge on the capacitor in an LRC-series circuit when L = q(t) = C - h, R = 10 , C = 0.01…

A: Brief description: For the above given question we need to calculate the value of charge on the…

Q: If A = 19a₂ +9ay + 2a, and B = 15a, +19ay + 14a,, then A. B =

A: We need to find out the dot product

Q: A 10 kVA transformer has 2% resistance and a rated core loss of 150 watts. At what percent of its…

A: Given the rating is 10 kVA The resistance is 2 %  The core loss is 150 W,

Q: Q1. a) Given the State Diagram of Figure 1, draw and complete the state, transition, and output…

A: According to the question, for the given state diagram as shown below We need to design the state,…

Q: For the circuit in Figure, solve the nodes and order the matrix as follows: B] [1 C c. What is the…

A: The required parameters can be calculated by using the kirchhoff's current law to the nodes.

Q: Q4: An op-amp multivibrator circuit is constructed using the following components. R₁ = 30kΩ…

A: We need to find out the frequency of multivibrator

Q: Is a 16-bit register containing address of 64 KB segment with processor instructions. code segment…

A: Types of segment  Code segment  Stack segment  Data segment... Etc

Q: 1. Calculate the lc in figure below with beta = 80 Vcc= 12 V ३1. 550k Select one: O a. 0.174mA O b.…

A: In this question,  We need to determine the collector current as shown the circuit.  We know…

Q: ✓5- Compare between the power transmitted in the (DSB-SC (DSB) if modulation index m-1.

A:

Q: 3A 3 A (1 + 4Ω επίσης RITA O 2 Ω 2 www R₂

A: Consider the given circuit: There are 2 current sources and 2 resistances.

Q: find the Laplace of the following function π 27 t

A: In this question we need to find a Laplace transform of the given signal.  The given signal is…

Q: Question 1: Q1- For the sinusoidal waveform in Fig. 1: a. What is the peak value? b. What is the…

A:

Q: ● Calculate

A:

Q: b) Find the capacitance of a parallel plate capacitor if the area of each plate is 0.1 m² and the…

A: Given: A parallel plate capacitor with, A=0.1 m2d=2 mmεr=5ε0=8.854×10-12 F/m

Q: AJFET data sheet specifies VGs(off) = -6 V and loss = 8 mA. The value of lp when VGs = -3 V is Blank…

A: The value of drain current can be calculated by using the shockley's equation.

Q: A JFET data sheet specifies VGS(off) = –6 V and IDSS = 8 mA. The value of ID when VGS = –3 V is…

A: Brief description: In the above given question they want to know the saturation current for the…

Q: At what rate the flux must be varied to measure 12 V across the terminal of 300 turns coil?

A:

Q: if a positive charge Q=100uC is located at the origin in rectangular coordinate system. Determine…

A: Magnetic field is a place where the influence of the magnetic lines of force are felt.

Q: Determine the nodal voltages for the networks in Figure? ane 1₁ = 3A 40° voo 51 40 20 1₂ = 5A230

A: To know the node voltages , KCL can be applied. With KCL equations both the node voltages could be…

Q: Example 6.31. A 3-phase, 1455 rpm induction motor drives a load requiring constant torque. In case…

A: when T remains constant S1V12=S2V22So S2S1=V1V22=10.92=1.23We know that I2 ∝ SVI2'I2=S2V2S1V1=1.2×…

Q: Use Thevenin Theorem to solve for the current and voltage at the 40 ohm resistor. 20 Ω ww 2 10Ω 3…

A: We need to find out current and voltage by using of thevenin equivalent circuit

Q: The generator is connected to two electrodes are placed in the ground 1000m from each other. The AC…

A: Grounding gives extra strength to the only and most secure path from a piece of equipment lower back…

Q: Transformers: 1. How does the polarity settings affect Vprimary and Vsecondary?

A: Transformer:- It is a  static electric machine which transfers energy from one end to another end…

Stator and Rotor Magnetic Field

The stator and rotor magnetic field is the resulting magnetic field generated by a system of coils that are symmetrically aligned. They are supplied with polyphase currents. The magnetic field is generated by poly-phase (two or more phases) current or single-phase current. In the latter case, two field stator windings are supplied and two resulting electromagnetic fields are generated beyond the stage.