Answered: 2. In a transformer,the core loss is…

2. In a transformer,the core loss is found to be 52 W at 40 Hz and 90W at 60 Hz measured at same peak flux density. Compute the hysteresis and eddy currrent losses at 50 Hz.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.5MCQ: For an ideal 2-winding transformer, an impedance Z2 connected across winding 2 (secondary) is...

See similar textbooks

Related questions

Q: Protection

A: Answer Differentiate Phase Reversal Protection between Phase Failure Protection based on your own un...

Q: The maximum instantaneous voltage and current outputs of an alternator are 308 V and 21 A, respectiv...

Q: A 30 ft by 40 ft classroom with 8 ft high ceilings will have an ambient lighting target illuminance ...

Q: 7. Find R so that maximum power is transferred to the resistance R. * 2 A Figure 2 10 V R 6Ω 8 V O 5...

Q: 1 kn 100 nF

Q: What is the Average value of 169sin 377t?

Q: 8. Referring to problem 7, find the Thévenin equivalent voltage Vth between a and b. O 14.56 V 9.28 ...

A: (7) To obtain the Thevenin equivalent resistance, the current source is open circuited. Redraw the c...

Q: . Consider a device connected to an ac power supply. The current leads the voltage by 90°, with the ...

A: (a) Since the current leads the voltage by 90° the given device is capacitor. (b) The angular freque...

Q: 6v? Calculate the output voltage of a noninverting amplifier for values of V = 12v, R = 500kN, and R...

A: Note: As per the guide lines of the bartleby we are supposed to solve 3 questions, when they are i...

Q: A rectifier voltmeter uses a full wave rectifier. The meter has an internal resistance of 50 N and r...

A: Given a rectifier voltmeter uses a full wave rectifier, The meter has internal resistance, Rm=50 Ω R...

Q: Problem#2: A compact disc (CD) records audio signals digitally by using PCM. Assume that the audio s...

A: We need to find out number of bits per sample and SQNR and data rate and bandwidth for given PCM sys...

Q: what is the mutual inductance in ohms (or the mutual inductive reactance ) between the two mutually-...

Q: Are Limit Switches available that cannot be used outdoors? Why?

A: The limit switch is the device that work on the electro-chemical property. The limit switch operate ...

Q: 2 ksl 7 k) 24 V IR V

Q: Can somebody help me how to read the voltage of this? We’re given 5V/Div Thank you!

Q: A generator is rated 100 MW. 13.8 kV and 90% power factor. The effective resistance is 1.5 times th...

Q: 33. a. Find the value of R for maximum power transfer to R for the network of Fig. 9.138 D. b. Deter...

Q: 14. The node voltage method is based on * О ксL Ohm's law

Q: R eeee (a) THE R- CKT. Ub) THE L-CKT. (c)THEC-CKT.

Q: a. Find rms power for signal shown below f(t) b. For the same signal shown below f(t), find rms powe...

Q: A voltage regulator is rated at an output current of I, = 0 to 40 mA. Under no-load conditions, the ...

Q: 3. When an electrician refers to a voltage as being 1200 V ac, it is understood that he means the ef...

Q: 7. Assume that a large room has three doors and one light in the center of the room. Three lat- chin...

Q: 6Ω. 2Ω 2 A 4Ω

A: Please refer the attached images for the complete answer..

Q: Which of the following is not a type of capacitor O Electrolytic Mica Glass O Carbon

Q: 85. Find the current in R= 11 2, L= 0•1 H, C= 102 F Connected an RLC- circnit with w hich is to coar...

A: We need to find out current through given circuit

Q: If vi = 10 cos (9t) V, what is the magnitude of the the output? The circuit functions like a passive...

A: The solution is given below

Q: A coil of resistance of 8 ohms and inductance of 150mH in series with a 110 microFarad capacitor, is...

Q: band gap of Germa is 7.32ev at room temperature. Find the maximum wavelengin of excitation light sou...

A: Given thatEg=7.32evh=6.62×10-34j-sc=3×108m/s1eV=1.6×10-19j

Q: ind the normalized frequency that corresponds to a DT filter cut-off of pi/4. What normalized freque...

Q: The maximum possible mutual inductance between the coils have self inductance L1 = 4 H and L2 = 16 H...

A: This question belongs to circuit theory . It is about mutual inductance between coil . Have a look a...

Q: Please help me answer this problem. Choose the correct answer from the given choices. Put whether yo...

A: In this question we will use nodal analysis to find unknown currents i1 and i6....

Q: A +Q -Q В

A: The parallel plate capacitor is define as the two plates which are parallel to each other acquires a...

Q: Q5. Using the impedance approach, obtain the transfer function Eo(s)/E:(s) of the op-amp circuit sho...

Q: Problem 4: Given is A (delta) network, convert it to Y (wye) network. The resistors of this A (delta...

Q: Find the current flow through each resistor 125 V 20 Q 30 0 50 Q wwww 2.25 A 3.25 A 1.25 A none of t...

Q: A flux density is given as D r(x3+1) -âr in free space. Find the total electric flux leaving the m2 ...

Q: find the phase, frequency, amplitude, period of the sinusoid v(t) = 10sin(377t +45°). Graphically sk...

A: v(t) = 10sin(377t +45°)

Q: A two-wire d.c. distributor AB, 600 metres long is loaded as under : Distance from A (meters) : 150...

A: The above diagram is the distributor with its tapped currents. Let Ia be the current supplied from t...

Q: Simplify the following expressions using Karnaugh map. Provide a complete and legible solution. 1. F...

A: Given function, FA,B,C,D=A'B'C'+B'CD'+A'BCD'+AB'C' Here inputs are A, B, C, and D

Q: What would be the efficiency of an alternator having 2hp power output if the input voltage is 230 vo...

Q: Calculate the power at MPP (Pm) for a PV cell that has the following: Voc=0.654 V, current density3D...

A: Given, For a PV cell VOC=0.654 V Current density is 38.1 mA/cm2 Cell area is 1.1 cm2 Fill factor is ...

Q: Simplify the following functions, and implement them using NAND and NOR gates only: F(A, B, C, D) = ...

Q: The noise produced by a resistor is to be amplified by a noiseless amplifier having a voltage gain o...

Q: A 20-hp, 3-phase, 400-V, 60-Hz 4-pole induction motor delivers full-load at5% slip. The mechanical r...

A: Solve for the shaft power. Psh=20 hp=20×746 W=14920 W Solve for the speed of the shaft as, N=120fP1-...

Q: Given : 240 /120 V , 10 KVA transformer r1=0.130 , r2= 0.030 , x1= 0.20, x2= 0.050 Find: The full lo...

Q: R(s) 10 C(s) K1 5 (s+2) K25 Consider the block diagram shown above 16/[s(s+4)]. (a) In the absence o...

Q: R1 VGEN 10 V pk-pk 60 kHz L3 GEN R2

A: Given circuit, R1 = 475 ohms, R2 = 14 ohms and L3 = 4.9 mH.

Q: determine the regulated d.c output voltage for the LM317

A: The LM317 voltage regulator circuit diagram is shown below, The values of the resistors are,R1=240Ω...

Q: A voltage regulator labelled LM2574 is designed for a voltage level of

A: LM2574 is adjustable switching voltage regulator. This voltage regulator is mainly used as buck swi...

Question

Rush, help me solve this one

2. In a transformer,the core loss is found to be 52 W at 40 Hz and 90W at 60 Hz
measured at same peak flux density. Compute the hysteresis and eddy currrent
losses at 50 Hz.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the rated voltage on the other winding? (a) Yes (b) No
A 23/230-kV step-up transformer feeds a three-phase transmission line, which in turn supplies a 150-MVA,0.8 lagging power factor load through a step-down 230/23-kV transformer. The impedance of the line and transformers at 230kVis18+j60. Determine the tap setting for each transformer to maintain the voltage at the load at 23 kV.
The ideal transformer windings are eliminated from the per-unit equivalent circuit of a transformer. (a) True (b) False
Rework Problem 3.14 if the transformer is delivering rated load at rated secondary voltage and at (a) unity power factor, (b) 0.8 power factor leading. Compare the results with those of Problem 3.14. -
For an ideal transformer, the efficiency is (a) 0 (b) 100 (c) 50
A single-phase, 50-kVA,2400/240-V,60-Hz distribution transformer has the following parameters: Resistance of the 2400-V winding: R1=0.75 Resistance of the 240-V winding: R2=0.0075 Leakage reactance of the 2400-V winding: X1=1.0 Leakage reactance of the 240-V winding: X2=0.01 Exciting admittance on the 240-V side =0.003j0.02S (a) Draw the equivalent circuit referred to the high-voltage side of the transformer. (b) Draw the equivalent circuit referred to the low-voltage side of the transformer. Show the numerical values of impedances on the equivalent circuits.
Three single-phase, two-winding transformers, each rated 450MVA,20kV/288.7kV, with leakage reactance Xeq=0.10perunit, are connected to form a three-phase bank. The high-voltage windings are connected in Y with a solidly grounded neutral. Draw the per-unit equivalent circuit if the low-voltage windings are connected (a) in with American standard phase shift or (b) in Y with an open neutral. Use the transformer ratings as base quantities. Winding resistances and exciting current are neglected.
Consider an ideal transformer with N1=3000andN2=1000 turns. Let winding 1 be connected to a source whose voltage is e1(t)=100(1| t |)volts for 1t1ande1(t)=0 for | t |1 second. A2- farad capacitor is connected across winding 2. Sketch e1(t),e2(t),i1(t),andi2(t) versus time t.
Consider Figure 3.4. For an ideal phase-shifting transformer, the imda nce is unchanged when it is referred from one side to the other. (a) True (b) False
Consider the three single-phase two-winding transformers shown in Figure 3.37. The high-voltage windings are connected in Y. (a) For the low-voltage side, connect the windings in , place the polarity marks, and label the terminals a, b, and c in accordance with the American standard. (b) Relabel the terminals a, b, and c such that VAN is 90 out of phase with Va for positive sequence.
The leakage reactance of a three-phase, 300-MVA,230Y/23-kV transformer is 0.06 per unit based on its own ratings. The Y winding has a solidly grounded neutral. Draw the per-unit equivalent circuit. Neglect the exciting admittance and assume the American Standard phase shift.
The ratings of a three-phase three-winding transformer are Primary(1): Y connected 66kV,15MVA Secondary (2): Y connected, 13.2kV,10MVA Tertiary (3): A connected, 2.3kV,5MVA Neglecting winding resistances and exciting current, the per-unit leakage reactances are X12=0.08 on a 15-MVA,66-kV base X13=0.10 on a 15-MVA,66-kV base X23=0.09 on a 10-MVA,13.2-kV base (a) Determine the per-unit reactances X1,X2,X3 of the equivalent circuit on a 15-MVA,66-kV base at the primary terminals. (b) Purely resistive loads of 7.5 MW at 13.2 kV and 5 MW at 2.3kV are connected to the secondary and tertiary sides of the transformer, respectively. Draw the per- unit impedance diagram, showing the per-unit impedances on a 15-MVA,66-kV base at the primary terminals.