2. Use the Ksp values in the table to calculate the molar solubility of AgBr Compound Formula Ksp Silver bromide AgBr 5.35x10-13 Magnesium hydroxide Mg(OH)2 2.06x10-13 Scandium hydroxide Sc(OH)3 8.0x10-31 3. Use the Ksp values in the table to calculate the solubility of Mg(OH)2 in g/L 4 Use the Ksp values in the table to calculate the solubility of Sc(OH)3 in mg/L

2. Use the Ksp values in the table to calculate the molar solubility of AgBr Compound Formula Ksp Silver bromide AgBr 5.35x10-13 Magnesium hydroxide Mg(OH)2 2.06x10-13 Scandium hydroxide Sc(OH)3 8.0x10-31 3. Use the Ksp values in the table to calculate the solubility of Mg(OH)2 in g/L 4 Use the Ksp values in the table to calculate the solubility of Sc(OH)3 in mg/L

Chemistry by OpenStax (2015-05-04)

1st Edition

ISBN:9781938168390

Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Chapter15: Equilibria Of Other Reaction Classes

Section: Chapter Questions

Problem 11E: The Handbook of Chemistry and Physics (http://openstaxcollege.org/l/16Handbook) gives solubilities...

See similar textbooks

Similar questions

Figure 15-3 outlines the classic scheme for separating a mixture of insoluble chloride salts from one another. Explain the chemistry involved in the various steps of the figure.
Calculate the solubility of AgCl(s) in 2.0 M NH3(aq).Ksp = 1.6 × 10-10 for AgClKf = 1.7 × 107 for Ag(NH3)2+(aq) 1.9 × 10-5 M 9.5 × 10-2 M 1.3 × 10-5 M 5.2 × 10-2 M 5.4 × 10-3 M
Which of the following compounds will have the highest molar solubility in pure water? A) PbSO4, Ksp=1.82•10-8 B) MgCO3, Ksp=6.82•10-6 C) AgCl, Ksp=1.77•10-10 D) CdS, Ksp= 8.00•10-28 E) HgS, Ksp= 1.60•10-54 please show work if necessary or explain why.
Which is the correct order of steps in the preparation of a hydrochoric acid standard solution with sodium bicarbonate standard solution. I. Dissolved sodium carbonate (13.25 g) in about 150 mL of distilled water in a beaker II. Solution of sodium carbonate was transferred into a volumetric flask and diluted to mark before mixing. III. Weigh the appropriate amount of the primary standard. IV. Titrate with enough volume of the acid to completely neutralize the base. V. Transfer 10.00 ml primary standard into an erlenmeyer flask and add indicator III, I, II, V, IV III, II, I, V, IV V, III, I, II, IV V, IV, III, I, II
you want to separate Ni2+ and Mn2+ by precipitating the corresponding sulphidesfrom each other. What pH value must you set so that one of the twometals is precipitated quantitatively (concentration in the solution less than/equal to 10/-5 mol/l)is precipitated while the other is still in solution? Ksp (NiS): 10^-21, Kps (MnS): 10~15; Ks (H2S): 10 ~- 20,Saturation concentration of H2S in water: 0.1 mol/l
Calculate the moles of H+ delivered to eachsample based on your experimental dataand record these values in Data Table 1. 0.1M HCl = 0.1 moles HCl / 1 Liter solution Calculate the moles of OH- in each sampleand record these values in Data Table 1. H+ + OH- H2O Calculate the moles of Ca2+ in each sampleand record these values in Data Table 1. Ca(OH)2 Ca2+ + 2OH . Calculate the molar solubility of Ca(OH)2for each sample and record these values inData Table 1. Molar solubility = moles / Liter . Calculate the Ksp for each trial and theaverage Ksp and record these values inData Table 1. Ksp = [Ca2+][OH-]2 Sample 1 Sample 2 Sample 3 Mass of Erlenmeyer Flask 25.47 25.47 25.47 Mass of Erlenmeyer Flask + Calcium Hydroxide Solution (lime water) 28.32 28.30 28.43 Mass of Calcium Hydroxide Solution 2.85 2.83 2.96 Volume of Ca(OH)2 Density = 1.000 g/mL Concentration of HCl (M) Initial HCl Volume in Syringe 1.0ml…
Without doing a calculation, predict which of these compounds has the greatestmolar solubility in water: AgCl (Ksp = 1.8 x 10-10), AgBr (Ksp = 5.0 x 10-13), orAgI (Ksp = 8.3 x 10-17).
Just fill out Table 1 by writing “+” if the compound is soluble/miscible in the solvent. Otherwise, write “-“. Table 1. Data on the results of solubility tests for C4H6O2. Solubility Test Observations + or - 10% NaOH Clear, colorless solution Litmus paper test (indicate if acidic, basic, or neutral) Blue litmus paper turned red distilled water clear, colorless solution 10% NaHCO3 rapid production of bubbles; clear, colorless solution
. Calculate the moles of H+ delivered to eachsample based on your experimental dataand record these values in Data Table 2. 0.1M HCl = 0.1 moles HCl / 1 Liter solutionCalculate the moles of OH- in each sampleand record these values in Data Table 2. H+ + OH- H2O Calculate the moles of Ca2+ in each sampleand record these values in Data Table 2. Ca(OH)2 Ca2+ + 2OH24. Calculate the molar solubility of Ca(OH)2for each sample and record these values inData Table 1. Molar solubility = moles / Liter Sample 1 Sample 2 Sample 3 Mass of Erlenmeyer Flask 25.37 25.37 25.37 Mass of Erlenmeyer Flask + Calcium Hydroxide Solution (lime water) 28.18 28.21 28.28 Mass of Calcium Hydroxide Solution Volume of Ca(OH)2 Density = 1.000 g/mL Concentration of HCl (M) Initial HCl volume in Syringe 1.0ml 1.0ml 1.0ml Final HCl volume in Syringe .54ml .58ml .5ml Volume of HCl Delivered .46ml .42ml…
In which solution PbSO4, be most soluble ? Why? 1 pure H2O 2. 0.05mol/L NaNO3 3. 0.05mol/LNa2SO4 4. 0.05 mol/L Pb(NO3)2
A solution is 0.025 M in Pb2 + . What minimum concentration of Cl- is required to begin to precipitate PbCl2? For PbCl2, Ksp = 1.17 * 10 - 5.a) 1.17 * 10 - 5 Mb) 0.0108 Mc) 0.0216 Md) 5.41 * 10 - 4 M
Without doing a calculation, predict which of these compounds has the greatest molar solubility in water: AgCl (Ksp = 1.8 * 10-10), AgBr (Ksp = 5.0 * 10-13), orAgI (Ksp = 8.3 * 10-17).