2052 Find Ic by 20A uSing Suferfostion

Q: Explain this diagram for a dummy

A: The given circuit is as shown below,

Q: The current in a load impedance of Z = 15215° Q is I = 2440° A. Calculate the voltage drop over the…

A: Given, Current in al load, I=2∠40° A Load impedance, Z=15∠15° Ω

Q: Sketch RL for the system below, and find the value of K that make the system stable: (assume H(S)…

A:

Q: Write the impedance equation for the circuit shown. Follow the format used in the manual. ... XL R1…

A: The detailed solution is provided below.

Q: A 4200-V, three-phase transmission line has an impedance of 4+j ohms per phase. If it supplies a…

A:

Q: 10.) The current in an ac circuit at any time t seconds is given by i = 120 sir 0.36) amperes. Find:…

A: In this question we will find current periodic time, frequency,peak value ,angle etc... Note - as…

Q: What's the approximate distance a 480V, 45A, three-phase transformer, wired with 6 AWG copper can be…

A: It is given that: V=480 VI=45A

Q: Base Current 10uA 29uA 3mA 5mA   2. Collector Current 30uA 6mA 2.89mA 1mA   3. Emitter Current 2.9mA…

A: The solution is given below

Q: x (п) %3D{1,2, 1, 1, 1} h(n) = {1,–1,-2, 2}

A:

Q: 1. Difference between Luminance and illuminance? 2. Difference between Lumen and Candela? 3. List…

A:

Q: A balanced Y - connected, negative-sequence voltage source having an internal impedance of 20 + j20…

A: The solution is given below

Q: What is pi type lc filter

A:

Q: If an op-amp comparator has a gain. of 100,000, an input difference of 0.2 mV above reference, and a…

A:

Q: A battery with a terminal voltage of 12V is connected to a circuit consisting of four 10 and one 5…

A:

Q: 9. Determine the voltage at capacitor, current through inductor and the energy storage in C and L…

A:

Q: With the given circuit, write the impedance equation

A: In this question,   We need to write the impedance equation?

Q: Q2) Draw the block diagram for DVM using a dual-slope-integrator ADC

A: T

Q: 3. Find the Total Resistance RAB in the circuit. 2 kll 2 kll 10 kl A O 6 kft 6 kl 6 Kn RAB 4 kn 1 kl…

A:

Q: A wire of resistance 5.0 ohm is connected to a battery whose emf is 2.0 V and whose internal…

A: Please refer the attached images for the complete answer..

Q: A 741 op amp has an open-loop voltage gain of 2×10$, input resistance of 2 MN, and output resistance…

A: given open-loop gain of 741 op amp is 2×105 input resistance is 2 M ohms output resistance is 50…

Q: A Wheatstone bridge has a 10 V supply, all four resistors are 5 k2, and the 2u galvanometer has a 25…

A:

Q: Determine Vo1 and Vo2 for the network shown. Si 4.7 k2 Voz +12 Vo Vor GaAs

A:

Q: a) i(0) (5mA) b) v(t),vi(t) and v2(t) (200e-10mV, 80e-10*mV, 120 e10ʻmV) c) i(t) and i2(t)…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Find v(t), for t>0 in the following circuit, suppose the switch has been open for a long time and it…

A: as per our guidelines we are supposed to answer?️ only one question. Kindly repost other questions…

Q: Consider the finite-duration sequence a[n] = {-1,2, –1} where the highlighted and underlined number…

A: In this question,   We need to choose the correct options What is Fourier transform of the given…

Q: 10-5. A 220-V, 1.5-hp, 50-Hz, two-pole, capacitor-start induction motor has the follow- ing…

A: Note: As per the policy we can solve only 3 sub-parts of a question, please re-upload the remaining…

Q: Rp2 Rp1 H- Vout R M2 Cp2 M1 HT CG Vin Csi Rs2 Cs2 R, R$1 Vss = 0 V Figure 5

A: Saturation region: It is the region in bjt  where maximum collector current flows for  a given…

Q: Find v   If t > 0

A:

Q: Given the transistor circuit with beta as 100. Answer the following items below. 1. Collector…

A: In this question,   We need to determine the 1. Collector Current at saturation 2. VCE at cut-off 3.…

Q: How much current will flow in a 100 Hz series RLC circuit if VS = 20 V, RT = 66 ohms, and XT = 47…

A:

Q: VDD Rp2 R1 Rp1 M2 HT Vout Cp2 M1 Vin H CG Rs2 Cs2 R2 Rs1 CSI

A: Types of coupling  Transformer coupling  Impedence coupling  RC coupling  Direct coupling

Q: Question 1 A ferromagnetic core is shown in Figure 1. The depth of the core is 5 cm. The other…

A:

Q: A filter circuit consisting of a capacitor C, in series with a parallel combination of Cp-L is to be…

A: It is given that: Passing frequency=fp=50 KHz=50×103  HzBlocking frequency=fb=20 KHz=20×103…

Q: Problem 1. 6 kn 12 kl 12 kn Find lo using nodal analysis.

A:

Q: WL Fland IL wsing Nortoi's treikem. Sou DIA

A:

Q: 9. All tangent lines of the parabola y = x2. Ans: (y')2 – 4xy' + 4y = 0

A:

Q: 1. Determine the output voltage for the circuit 300 kQ 150 k2 V2 = 2 V 741 V. 10 k2 V1=1 V M 10 kQ

A:

Q: I wo factories A and B consume energy (kWn) as shown in the table below. They have the same maximum…

A:

Q: Calculate the gauge of TW type copper wires required for a two-conductor power supply in an FMC tube…

A: Given information, Type of material is copper. Type of insulation is TW insulation. Number of…

Q: Use Nodal analysis and mesh analysis to find voltage drop accross R3…

A: In this question,   We need to determine  voltage drop accross R3 using the nodal analysis and mesh…

Q: A parabolic rehector tocuses etectromagnetic waves into a beam as shown in the figure. The…

A: Note: As per the policy we can solve only 3 sub-parts of a question, please re-upload the remaining…

Q: Two impedances of Z1 = 100 +j50 Q and Z2 = 20 -j20 Q are connected in series what is the magnitude…

A: Given: The two impedance connected in series are Z1=100+j50 ΩZ2=20-j20 Ω

Q: Find IL whing Souvce tranlyrmatiom

A:

Q: The elements marked A and B, respectively, correspond to Flip-flops and programmable counters Logic…

A: For the given FPGA functional block diagram, the elements A and B respectively are . Flip-flop and…

Q: A pure capacitive circuit and a pure inductive circuit absorb: zero and non-zero power,…

A: We need to select correct option for inductor and capacitor power.

Q: VDD R1 Rp V M1 out Cs in R2 CG Rs Vss =0 V SS

A: MOSFET(Metal Oxide Semiconductor Field Effect Transistor): The MOSFET, which has become the most…

Q: Q4. By using Karnaugh map, reduce the combinational logic circuit in Figure 1 to a minimum form. А в…

A: By using karnaugh map method, reduce the following given logic circuit diagram to a minimum form.…

Q: Q1: The bode diagram of the following open-loop T.F is as shown in Fig. below K GH(s)= s(s+2)(s+2)…

A: Bode plot is a plot drawn to determine the frequency of the system. Phase margin and Gain margin is…

Q: Mention six (6) applications of attenuators.

A: Attenuator: It is a  device which can be used to adjust the signal level and for impedance…

Q: A commercial 60-Hz, 440/110-volt, 50-kVA power transformer has 600 turns on its high-voltage side.…

A:

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.