21. a conductor has a conductance of 70µS is used to supply a load. Find its equivalent resistance A. 17.5 B. 35.1 C. 15.69 D. 14.3 22. The average value of the sinusoidal wave current is 15A. The maximum value is: A. 36.45 B. 65.98 C. 12.32 D. 23.56

21. a conductor has a conductance of 70µS is used to supply a load. Find its equivalent resistance A. 17.5 B. 35.1 C. 15.69 D. 14.3 22. The average value of the sinusoidal wave current is 15A. The maximum value is: A. 36.45 B. 65.98 C. 12.32 D. 23.56

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.10MCQ: The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero

See similar textbooks

Related questions

Q: 1-which transmission media provides the highest transmission speed a) Coaxial cable b) Twisted pair…

A: In this question , we will write answers related to transmission line.... Note :- as per guidelines…

Q: What are the characteristics of an ideal operational amplifier?

Q: PRACTICE PROBLEM 16.2 Find vo(t) in the circuit shown in Fig. 16.9. Note that, since the voltage…

A: Given An electrical circuit.we need to determine the output voltage. Please find the below…

Q: Write down the different method of power transmission?

A: In the above given question we need to list different methods of power transmission.

Q: Discuss the difference between resonant and non-resoinant circuits. Use equations to explain your…

A: It is asked to discuss the difference between resonant and non-resonant circuits. We need to explain…

Q: 14. Which of the following is a condition that must be met in order to qualify for the exemption…

A: Since #14 and #17 are two different questions, as per the guidelines, #14 has been solved in the…

Q: A SERIES RC CIRCUIT TAKES A CURRENT WHOSE EQUATION Is 2 sin (754t+40) AMPERE. WHEN CONNECTED TO A…

Q: For the circuit shown: 1. Find the value of "Rc" that makes the circuit in resonance. 2. Calculate…

A: Given data : Voltage(VT)=10∠0°VResistance(RL)=8ΩInductance(XL)=j6ΩCapacitance(XC)=-j5Ω

Q: If the surface leakage current is 2nA for a reverse voltage of 25V, what is the surface leakage…

Q: 6. A Thevenin de equivalent circuit always consists of an equivalent.. a. AC voltage source b.…

A: Network theorems are very useful in analysis of various circuits.

Q: Using mesh analysis, determine the currents for the network of fig (5) www 652 A 8 A W 212 Fig-5 852

Q: An electric heater with a resistance of 40 ohms and a current of 5 amperes. What is the voltage? O…

Q: Design 4-bit combinational circuit for a 2’s complementer, (The output generates the 2’s complement…

A: 1. Truth table Inputs: A, B, C, and D Outputs: W, X, Y, and Z

Q: ood day! Can anyone help me design a lattice - type balanced modulator (just a simple one) Thank you

A: The carrier is missing from the output waveform, yet it still retains all of the information…

Q: A load of 10,000 kVA, 80% pf lagging is connected to a 13,200 volts line. How much capacitive…

A: Power triangle is the denoted the three power Active, reactive, and apparent power so , the active…

Q: What we covered in Chapter 10 are called bilateral z-transform X(z). There 00 is also a thing called…

Q: Three resistors R1, R2 and R3 are connected in series. According to the following relations, if RT =…

Q: Find vo(t) in the circuit shown in Fig. 16.9. Note that, since the voltage input is multiplied by…

Q: For the circuit shown. Find R₁, R₂, R3 so that Z₁1=2.5K₁, Z₁2=Z₂₁1 = 1.25K₁² Z2₂2= 3.125 K R₁ -MM ww…

Q: 20] For the system given below, find the sinusoidal expression for the unknown current i, if 201060…

Q: Describe the s-doma

A: Here in the above question we need to define Laplace transform in s domain.

Q: PRACTICE PROBLEM 16.1 1 H -O F Figure 16.6 m + vo(t) 2u(t) V 492 For Practice Prob. 16.1. Determine…

Q: 1. Which of the following is the derived unit for Tesla (T)? a. Weber per meter squared b. Weber per…

A: In this question, We need to choose the correct options We need to find the unit for the Tesla?…

Q: Arm resistances of Wheatstone bridge are,R₁ = 200 £2 R₂ = 400 2 R₁ = 500 S R₁ = 600 Input is, E5V.…

A: A wheat stone bridge with the given resistances is shown below: The bridge output voltage is given…

Q: The magnetizing equivalent circuit of transformer can be found by open circuit test O True OFalse

A: The magnetizing equivalent circuit of transformer can be found by open circuit test....

Q: Q2) Find the x(t) signal is Energy or Power signal? x(t) = 1e-²t.u(t))

Q: For the following toroid, the flux is 440μWb, r1= 8 cm and r2=12 cm. The flux density is 12 O 0.0875…

Q: The voltage and current of a load are v(t)=5cos(5nt+15) and i(t)=0.5cos(5t+45), respectively.…

A: Given, The voltage and current of a load are, vt=5cos5πt+15°it=0.5cos5πt+45°

Q: The value of the equivalent resistance in the circuit shown in: Figure is R1=90 O 21 O 15.14 O 0.095…

Q: 03- The magnetic circuit is laminated with 0.93 iron factor and μ, 1200. Calculate the current…

A: Given, For a magnetic circuit,iron factor = 0.93μr=1200ϕ=0.5 mwbAndWe know,μ0=4π×10-7 H/m

Q: B) State the junction bias conditions for a bipolar junction transistor operating as an amplifier.…

A: The BJT can be used in three different types of configuration which are listed below :…

Q: 40. According to the continuity of current, if we consider closed surface, then current out of the…

A: Continuity of current :- It states that " when current leaves a small closed surface then there…

Q: 22. Calculate the charge stored on a 3- pF capacitor with 20 V across a. 0.150 pC b. 0.06 nC с. 6рс…

A: In this question we will find charge stored on capacitor with given data....

Q: Q3) Given the circuit in Fig. 3, calculate the current i, through t, using mesh analysis 3A +4 6 A…

A: We need to find out the current for given circuit

Q: 4. For the Wheatstone bridge network shown in Figure. a) Evaluate the Wheatstone Bridge network and…

Q: With necessary sketch, Explain the mode of operation of chopper which is turn off due to external…

A: Chopper is a power electronics device that transforms fixed DC voltage/power to variable DC…

Q: For the following circuit, the resistance of R2 is 20 mA SR2 SR3 •2ΚΩ 100 mA SR1 2ΚΩ 4 Ω 8 ΚΩ Ο 2 ΚΩ…

A: given here a electrical circuit and asked to find the value of resistor R2.

Q: 3: Find the truth table of the logic circuit shown below: MUX 83 B DO 0 0 1 0 1 23 EN D 180 But…

Q: 15. Which of the following is TRUE? a. A conductor has a large amount of energy gap between…

A: Given a. A conductor has a large amount of energy gap between conduction band and valance band b.…

Q: An inductive load of 100 Ohm and 200mH connected in series to thyristor supplied by 200V dc source.…

A: In this question we will find that SCR will be fired or not by given data...

Q: Vin For the circuit shown, draw the corresponding small signal model. Vcc Vcc Vcc W ww|ll R1 R2 WWW…

Q: Compute the voltage vo(t) a e(t) 8 09 12 the leady E. Î te for Eod Im 12v and e(t); V Jolt) sin(3t+…

Q: VDD +15 V R₁ LAMP 3Ω 1 ΜΩ T MTV10N100E R₂ 2 ΜΩ Figure 12-55 14- The lamp of Fig. 12-55 is replaced…

A: Given A circuit parameters,we need to find the lamp power when it's dark. Please find the below…

Q: Q- For the circuit shown in Fig (3) - Soka lod 2mA 13 50 PF 3MA a) By using approximate Parllel…

Q: Find the voltage and current across R,L,C Include phasor diagrams and impedance triangle

A: In parallel circuit, the voltage is same across the components. In pure inductive circuit the…

Q: The four resistors shown below in Fig.6 have the lengths and cross-sectional areas indicated and are…

Q: bvolut M 86052 A = 1 m A A Si Calculate the minimum Voltage that keeps the diode operating above the…

A: In this questions, we need to calculate the operating point of the silicon diode.

Q: 28. Find the magnitude of a curl of the vector at point (1,1, −0.2); F = 30 ax + 2xy ay + 5xz² a₂ a.…

A: 28. Find the magnitude of curl of the vector at point (1,1,-0.2) ; F=30 ax+2xy ay+5xz2 az Options…

Q: 8. The divergence of H will be a. Less than 0 b. Greater than 0 c. 0 d. Infinity

Q: For the system given below, find the sinusoidal expression for the unknown current i, if 4- 20 x 10…

A: given here a circuit and asked to find the value of i1 in the circuit. we know that i= im sin…

Question

21. a conductor has a conductance of 70µS is used to supply a load. Find its equivalent resistance

A. 17.5

B. 35.1

C. 15.69

D. 14.3

22. The average value of the sinusoidal wave current is 15A. The maximum value is:

A. 36.45

B. 65.98

C. 12.32

D. 23.56

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

(a) Determine the standing wave ratio ‘s’ shown in the figure below. Note that the dielectric is air. (b) Find the input impedance. (c)⍵L=10Ω. Find Is. (d) What value of C will produce a maximum value for |Is| at ⍵=1Grad/sec? For this value of C, calculate the average power: (e) supplied by the source (f) delivered to ZL=40+j30Ω.
If emf in a circuit is given by e = 100 sin 628t, the maximum value of voltage and frequency is _____V, _____Hz
An incident wave on TL is V+(z,t)=10cos(ω0t-βz-π/6). The line has a characteristic impedance 50 Ω. If the line is connected to a 25+j35Ω load, what is the reflected wave?
Each phase of a transmission line is a bundle of 4 conductors that form a square with all sides equal to d=33 cm. Each conductor is stranded and has GMR = 0.5 cm. Find GMR of the bundle to be used in inductance calculations. Express your answer in cm with 2 digits after decimal point
A sinusoidal signal of 20V peak at 50 Hz is applied across a series combination of a resistor and inductor. If the impedance of the combination is Z = (10 + 5.03j)Ω, the power factor of this arrangement
Q.3/ Answer the following: A- Analternating voltage is given by V =220 sin 314t volt. Find: (1) the amplitude, the peak-to-peak value, (2) the r.m.s. voltage (3) the periodic time, the instantaneous value of voltage when 7 = 6 ms, (4) Draw the waveform, write the phase difference.
Ra= 13.682 kohms from part a Rb = 136.82 kohms from part b
Find the average power absorbed by a circuit component that has a voltage of v = 20.3 cos(754t - 10°)V across it when a current i = 15. 6 cos(754t - 30°) mA flows through it.
find the sinusodial expression for e if Va = 60sin(wt + 30°) Vb = 30sin (wt + 60°) Vc = 40sin (wt + 120°)
The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero
An air line has a characteristic impedance of 70 ohm and a phase constant of 3 rad/m. Calculate the inductance per meter and capacitance per meter of the line.
4.2 A wave of sinusoidal nature has an angular velocity of 314.16 rad/s and has a particle displacement of 22.825 m after 6 ms.4.2.1 Draw the wave on the graphing paper below. Clearly show the calculations and indicate/highlight the amplitude, period of one of the cycles and the point of displacement described above.