24. Determine the absolute pressure required to lift the column of water from 5m depth. Assume atmospheric condition of 101,325Pa and density of water at 1000kg/m³. a. 81,705Pa b. 52,275Pa c. 49,803PA d. 50,313PA

24. Determine the absolute pressure required to lift the column of water from 5m depth. Assume atmospheric condition of 101,325Pa and density of water at 1000kg/m³. a. 81,705Pa b. 52,275Pa c. 49,803PA d. 50,313PA

Name: 24. Determine the absolute pressure required to lift the column of wa
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 24. Determine the absolute pressure required to lift the column of water from 5m depth. Assumeatmospheric condition of 101,325Pa and density of water at 1000kg/m³.а. 81,705Pаb. 52,275Paс. 49,803Раd. 50,313PA

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.115P: Determine the smallest distance I) that would prevent the concrete dam from tipping about corner A....

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
Determine the smallest distance I) that would prevent the concrete dam from tipping about corner A. Use w=62.4lb/ft3 for water and c=150lb/ft3 for concrete.
16. A semi-circular plate whose radius is 3.6 m and its bottom diameter is 5.6 m from the water surface. What it’s the hydrostatic force acting on the plate?685.3 kN758.9 kN704.5 kN813.2 kN
Determine the total pressure and depth of centre of pressure on a plane rectangular surface of 1 m wide and 3 m deep when its upper edge is horizontal and (a) coincides with water surface (b) 2 m below the free water surface.
End D of a 2.5 long uniformly plain wooden rod( s.g=0.7) is held 0.3m below the surface of still water. (a.) How much of the rod remains above the water surface? (b.) if the rod diameter is 25mm what force of D is required to hold it in place ?
The uniform control gate AB shown is pinned at A and rests on the smooth surface at B. The gate has a width of 1m. If the gate has a mass of 3.9 Mg, determne the maximum depth of water h in the reservoir that will cause the gate to be on the verge of opening.
If the rate of rotational speed of the 3-tube system shown is ? = 10 rad/s, determine the water heights in each tube leg. At what rotational speed will the middle tube be completely empty?
A triangular wooden body (S=0.80) is placed in water in theposition indicated in the figure. If the width of the body is 7.0 m,determine if the same for this position is stable or not indicating themetacentric height (YM).
A circular tank with a diameter of 4.5m is filled with two immiscible fluids. Water to a depth of 3m andoil with a relative density of 0,9 to a depth of 2mDetermine the Hydrostatic force acting on the verticalside of the tank and the position of the centre of pressure from the oil-free surface.
Q6: A hydraulic lift is to be used to lift a 2500 kg weight by putting a weight of 25 kg on a piston with a diameter of 10 cm. Determine the diameter of the piston on which the weight is to be placed.
Determine the maximum capillary rise (h) that can be expected from water at 4°C, between two clean glass plates. ri=8.0mm
Evaluate the stability of the 3 m wide x 5 m deep (into the page) x 2 m tall block with a SG of 0.5 shown below in water by determining the displaced depth and the height of the metacenter.