Matlab DSP e. Demine the qu(25M)03/ Consider the analog signal x.(t) =3cos(100 a t) + sin(150 t).a) Determine the minimum Fs to avoid aliasing.b) Suppose that x, (1) is sampled at F-200HZ. What is the discrete-time signal aftersampling?04LA signal Y(1l is granhically shown below. Show the graphical representation of

Answered: Image /qna-images/answer/20072308-f4a3-47f7-8823-6f630e927bef.jpg

(25M) Consider the analog signal x,(t) =3cos(100 a t) + sin(150 t). a) Determine the minimum Fs to avoid aliasing. o) Suppose that x. (1) is sampled at F-200HZ. What is the discrete-time signal after sampling?

(25M) Consider the analog signal x,(t) =3cos(100 a t) + sin(150 t). a) Determine the minimum Fs to avoid aliasing. o) Suppose that x. (1) is sampled at F-200HZ. What is the discrete-time signal after sampling?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 25VE

See similar textbooks

Related questions

Q: Q1) Determine the output (in frequency domain) of a LTI System having impulse response of h(n) =…

A: Output of given x(n) and h(n) is {-1,3,-1,6,2}

Q: Consider a rate - ½, non-systematic Convolutional Code with g= { 1,0,1} and ge) = { 1,1,1 }.…

A: The solution for the above given question is given below:

Q: Task 2: Module: Digital Signal Processing 1. Determine the Z-transform of the following…

Q: B) Draw and find the BASK signal if maximum carrier amplitude is 14V and f.=0.1MHz and the input…

Q: Problem#2: A signal g(t) = sinc² (5xt) is sampled (using uniformly spaced impulses) at a rate of (i)…

Q: HW2: Given the following system: y(n) = y(n – 1) –y(n – 2) + x(n) 1) Determine the response of the…

A: The Answer is in step-2.

Q: Q1. A non-periodic composite signal contains frequencies from 15 to 50 KHz. The peak amplitude is 20…

A: The Answer is in given below steps

Q: (a) The message input of the Pulse Code Modulation (PCM) is given as follows: Am (t) = cos (20πt)…

Q: Consider the system described by the difference equation y[n] 1] – 0.1y[n – 2] + 0.1x[n] – 0.5x[n –…

A: MATLAB program is a script, which contains a set of commands exactly as you would type them at the…

Q: Obtain the normalized correlation on the two signals x[n] and y[n] X 1 2 3 1 3 2 -2 -1 3 4 3 3 2.

A: Given x=[1 3 -2 4] y=[2 3 -1 3]

Q: The standard spectrum of a regular telephone line that is used, via modems, to transmit digital data…

A: Given: The standard spectrum of a regular telephone line that is used, via modems, to transmit…

Q: The Nyquist sampling rate require to sample the signal x(t)= [sin?(700 t)] is equal to.

A: Solution Option D could be the answer 1400 Hz Detailed explanation is given below Nyquist sample…

Q: 2) Given P=110011 and M=11100011, use CRC technique to find FCS and transmitted frame. Note: FCS is…

A: As per our guidelines, only one question will be answered. So, please repost the remaining questions…

Q: Design Armstrong FM generator for the generation of WBFM signal with Af = 75 kHz and fe = 100 MHz,…

Q: 2. Assume that an HF communication link between two points on earth at a distance of 2500 km is to…

A: I'm providing you the d and e part of above mentioned. I hope this will help you.

Q: Find the Fourier transform of the rectangular pulse signal x(t) defined by x(t) = Pa(t) = {1 |t| a

A: Answer

Q: Q4: Consider the sinusoidal signal x(t) = 10 sin(at) where @= 2nfa, fa-analogue frequency, t-time…

A: Answer has been explained below:-

Q: Q4/ If figure (1) is the spectrum of the periodic signal answer the following for one period of this…

Q: 19. Four decoders are cascaded to form a 1-of-32 decoder. If decoder D1 has the outputs of Q0-Q7,…

A: Compression algorithms: This encoder is really a system that turns the n line of feed into 2n runs…

Q: Q7/ For an electronic circuit, a signal to noise power ratio of 30db and a bandwidth of 2.7kHz, the…

A: Here in this question we have given a Signal noise power ratio of 30 db. bandwidth = 2.7 khz Find…

Q: 2) For polar binary signaling at rate Fg = 1/TB, sketch and label the eye diagram before and after…

A: Just plot the graph points to find the polar signaling and full width rect pulse P(t)= rect(3T/Tb).

Q: Determine the Fourier transform of the given signal. (i) x(n) = alnl, |a| < 1

A: The answer of this question is as follows:

Q: Problem # 3. Find the period of a periodic waveform whose frequency is a. 50 K Hz b. 100 MHz c. 60…

A: - We have to calculate the time period when the frequency is provided.

Q: 4. Plotting a Sampled-Signal. Suppose the continuous-time signal t) is sampled with a sampling…

A: Please check the step 2 for solution

Q: b) Given a binary Phase Shift Keying (PSK) system in which the allocated bandwidth is 25×C kHz.…

Q: F(x,y,w,z) = ∑m (0,2,5,7,8,11,13,15) Provide the following on each item given below: - Truth table…

A: 1. Truth table: X Y W Z F(X,Y,W,Z) 0 0 0 0 1 0 0 0 1 0 0 0 1 0 1 0 0 1 1 0 0 1 0 0 0…

Q: 1 (a) Explain the term duty cycle and determine the pulse duration of a Periodic pulse train whose…

A: The pulse duration is the time from the start of one pulse to the start of the next pulse. It is…

Q: The generator matrix of a LBC is given by: 1 0 0 1 1 01 10 0 [G]=|0 1 0 0 1 1 0 1 1 0 0 0 10 01 1 0…

A: The given question regarding generator matrix of a LBC.

Q: 2. A 500 Hz modulating voltage produces a frequency deviation of 2.25 kHz. What is the modulation…

Q: Problem 4. A channel encoder map blocks of two bits to five-bit (channel) codewords. The four…

Q: a- many methods are used for extracting the modulating signal from the frequency modulation…

A: A)ModulationA modulator is a modulating device or circuit. A demodulator is a circuit that…

Q: . The Nyquist theorem specifies the minimum sampling rate to be_______. a. equal to the lowest…

A: Nyquist theorem is also known by the name of sampling theorem.

Q: Qa) Determine the z-transform of the following signal and sketch the corresponding pole-zero…

A: Consider the following signal:

Q: There are 6 x 10 small picture elements in a video each having 8 distinguishable 4 levels of…

A: Given data Number of small picture element = 6×10…

Q: Q1) Find K and v(t) so that the system in Figure (1) produces AM signal without filtering. avf +…

Q: If the frequency spectrum of a signal has a bandwidth of 500 Hz with the highest frequency at 600…

A: I have given an answer in step 2.

Q: H.w/ find the 0/p of PCM for i/p signal x(t) the sampling frequency 5 kHz for 0<t< 0.1 s and eight…

A: Please find the attached solution belowIf you dont understand anything please do commentAll the Best

Q: EXAMPLE 8.4 For the analog transfer function 2 Ha(s) = (s + 1) (s+3) determine H(z) if (a) T = 1 s…

A: givenanalog transfer function is H(s)= 2(s+1) (s+3) H(z) is determined using impulse invariant…

Q: Find the lowest blind frequencies of a pulse-Doppler radar with carrier frequency of 6 GHz and a PRF…

A: Given: Find the lowest blind frequencies of a pulse-Doppler radar with the carrier frequency of 6…

Q: Exercise.14: Calculate the capacity of low pass channel with a usable bandwidth of 3 KHz and SNR=100…

A: Here in this question we have given Bandwidth =3 khz SNR= 100 Find - channel capacity in low…

Q: the frequency spectrum of a signal has a bandwidth of 500 Hz with the highest frequency at 600 Hz,…

A: Here have to determine correct option for sampling rate according to the Nyquist theorem.

Q: The effective aperture of a 144.0cm-diameter parabolic reflector antenna is 6m of the physical…

A: Given:

Q: 2. Evaluate the digital modulated signal given below and develop an output equation of the modulated…

A: The above digital modulated signal is BPSK The signal is represented by For binary "0" for Binary…

Q: Example 1: The voice signal with maximum frequency of 3KHZ . is to be transmitted with a sampling…

A: Given:

Q: ges from 20Hz-20kHz. However, any sound below 250Hz is considered to d and any sound above 4500Hz is…

Q: 1- Find and plot the output signal of the following system:

A: MATLAB : MATLAB is a programming platform designed specifically for engineers and scientists to…

Q: For the following system: 3 G(s) s2 +s+ 4 Find the response for: 3-Triangular signal'

A: t=[-30,0,30];G=3./(t.*t+t+4);plot(t,G)

Q: There are 6 x 10 small picture elements in a video each having 8 distinguishable 4 equiprobable…

A: Given Data : Number of picture elements = 60 Number of levels = 4 * 8 = 32 Rate of frames = 20 /s…

Question

Matlab DSP

e. De
mine the qu
(25M)
03/ Consider the analog signal x.(t) =3cos(100 a t) + sin(150 t).
a) Determine the minimum Fs to avoid aliasing.
b) Suppose that x, (1) is sampled at F-200HZ. What is the discrete-time signal after
sampling?
04LA signal Y(1l is granhically shown below. Show the graphical representation of

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Fundamentals of Boolean Algebra and Digital Logics

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

a) Draw the graph of the NRZ-I, Manchester & differential Manchester using data stream01010101, assuming that the last signal level has been positive
Consider a convolutional code with k = 1, n = 3 and L = 3. The encoder generators aregiven by 91 = [110], 92 = [001] and 93 = [011].Assume the Viterbi algorithm is used for decoding at the receiver and considerthe received bit sequence at the input of the channel decoder being [10 0100110011].Answer the following questions.(a) What is the decoded information bit sequence? (b) What is the value of the cumulative metric (i.e., Hamming distance) of thefinal survivor path of the decoding process?(c) Draw the final survivor path of the trellis for the decoding process.Instruction for Part (c): An example of drawing a path in the trellis is shown below.
2.Consider the bit stream 01101101. Draw the waveforms for following line codes.(i)(ii)Biphase Manchester codingBiphase Differential Manchester codingPolar PSEUDOTERNARY(iii)(iv)Multilevel -8B6T(v)Multilevel-2B1Q Assume that the signal level for the most recent preceding 0 bit (pseudoternary) has a negative voltage.
Draw the graph of the NRZ-L scheme using each of the following data streams,assuming that the last signa11evel has been positive. From the graphs, guess thebandwidth for this scheme using the average number of changes in the signal level.Compare your guess with the corresp.onding entry in Table 4.1.a. 00000000b. 11111111c. 01010101d. 00110011
The basic principle of differential coding techniques like Differentil PCM (DPCM) and Adaptive Differential PCM (ADPCM) is to transmit information _____. A. about the changes in sample value B. approximation to the input signal C. using artificial signal D. of the actual sample values themselves
Implement MATLAB program that plots channel capacity vs signal to noise ratio for 2-PSK,4-PSK,8-PSK modulations
answer with proper explanation and step by step solution. Question: d the x-intercept (s) and y-int ercep f(x)=(4x-7)/(2x^(2)+1)
Q3: By means of DTFT and IDTFT, show that the output response of an LTI system h(n) = a"u(n) to the input x(n) = B"u(n), where |a| < 1, |B] < 1, and a # ß is given by
Q1 If a signal has a frequency of 30KHZ what is the period in Microseconds?
Discuss the following outdoor propagation Longley-rice model Okumura model Hata model Explain in detail about types of small-scale fading based on multipath time delay spread
Consider a (127, 92) linear block code capable of triple error corrections.(a)What is the probability of message error for an uncodedblock of 92 bits if the channel symbol error probability is10－3?(b)What is the probability of message error when using the(127, 92) block code if the channel symbol errorprobability is 10－3?
#45.! Consider the following bit stream-a. 00000000 b. 11111111 c. 01010101 d. 00110011 Draw the graph of the i. Manchester using each of the given data streams, assuming that the last signal level has been positive. From thegraphs, guess the bandwidth for this scheme using the average number of changes in the signal level... .