Which of the following descriptions isconsistent with a constant decrease in the29.current through a uniform piece of a conductor?No of electronsper unit volumeA UnalteredB DecreasesC UnalteredIncreasesDrift velocity ofelectronsIncreasesunakteredDecreasesDDecreases

Current is charge flowing through a conductor per sec. I=qt To decrease in current we have to…

29. Which of the following descriptions is consistent with a constant decrease in the current through a uniform piece of a conductor? No of electrons per unit volume electrons Drift velocity of A. Unaltered Increases B. Decreases C Unaltered D Increases unaktered Decreases Decreases

29. Which of the following descriptions is consistent with a constant decrease in the current through a uniform piece of a conductor? No of electrons per unit volume electrons Drift velocity of A. Unaltered Increases B. Decreases C Unaltered D Increases unaktered Decreases Decreases

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter11: Magnetic Forces And Fields

Section: Chapter Questions

Problem 93AP: The density of charge carriers far copper is 8.471028 electrons per cubic meter. What will be the...

See similar textbooks

Related questions

Q: A current of 8.00 A flows in a conductor for 7.0 s. How much charge passes a given point in the…

Q: A charge of 20 C flows out from a battery in 8 s. How much current passes through the lamp

A: We have to find the current passed through the lamp Current is defined as the rate of flow of charge…

Q: How many electrons have passed through a light bulb during one hour if a current of 8 x 10 -2 A is…

Q: Discuss the relationship between the potential difference across a resistor and the current through…

A: According to ohm's law, the voltage across a resistor is directly proportional to the current while…

Q: 7. A current of 2.0 A exists in a conductor whose terminals are connected across a potential…

A: *** The Three questions (7,8 & 9) are not connected to each other, so according to the bartleby…

Q: A conductive wire with a cross section of (6mm) through which a current of (30A) passes. Find: - The…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: C. 12-gauge copper wire, 1 meter long D. 18-gauge copper wire, 1 meter long 4. Which wire will…

Q: 2. A person using electron current flow would imagine current in this circuit flowing a. counter…

A: "As per the guidelines i solved the first three question". 2. According to the electron flow theory,…

Q: 24.) Which of the following statements correctly explain why resistance increases with increasing…

Q: What current flows through the bulb of a 3.00 V flashlight when its hot resistance is 3.60 Q? The…

Q: What causes resistivity in ordinary conductors? Why (and in what way) does the resistivity change if…

A: Resistivity is a measure of a material's ability to oppose the flow of an electric current. It is…

Q: '3 Find the current through R1 = 29 kN and = 20 k2 from the figure given. Here E, = 9 V R2 %3D and…

A: R1 = 29000 ohm R2 = 20000 ohm E1 = 9 volts E2 = 14 volts Let the current through R1 = I1 , upwards…

Q: 02. How much charge passes a single point in a wire in 0.15 seconds if a current of 1.44 A is…

A: A charged object is the one having an unequal number of positive and negative charges. A neutral…

Q: Which of these are FALSE: 1. The reason why both conventional current and electric flow are…

A: We have to find the wrong statements from the given statements.

Q: 3. An electric motor winding uses 180 m of copper conductor with a cross-sectional area of 0.26 cm2.…

Q: 3. The resistance of a uniform copper wire 50.0 meters long and 1.15 mm in diameter is 0.830 ohms at…

A: Given, 3. Wire length L = 50 m diameter d = 1.15mm = 1.15 x 10-3 m Cross section area A = (pi) r2…

Q: 280 CHAPTER 6. ELECTRONICS .6.17 How many electrons will pass through a cylindrical copper wire of…

A: We know current density J =I/A Where I = current flowing coper wire A = area of copper wire But…

Q: A typical lightning bolt may last for 0.197 s and transfer 1.13 x 1020 electrons. Calculate the…

A: Time ( t ) = 0.197 s Number of electrons ( n ) = 1.13 * 1020 electron

Q: Which of these are TRUE: 1. Benjamin Franklin interpreted the negative terminal as an area where it…

A: 1. According to Benjamin Franklin, by removing electrons the material becomes positively charged, by…

Q: 2- A copper wire of 3mm diameter with conductivity of 6.7 * 107 (0.m)1, and electron mobility of…

Q: (2) How would you expect the resistivity of a good insulator such as glass or polystyrene to vary…

A: (2) In case of insulator , resistivity decreases on increasing the temperature but for conductor…

Q: 2. Determine the loop currents Ia, Ip, and Ic. 100 100 100 100 100 Ib 55V 100 V la

A: As there are 3 loops, Lets write kvl equation in each and every loop:- In loop-a:- 100 - 10Ia -…

Q: 2. Complete the table below by identifying the effects on resistance and effects on current flow of…

Q: Over the course of an 8 hour day, 3.8x104 C of charge pass through a typical computer (presuming it…

A: Given: Charge, q = 3.8 x 104 C time, t = 8 hours = 8 x 60 x 60 = 28800 second

Q: 7. If diameter of a conductor is doubled, the drift velocity of electrons inside it will [ ] a) Be…

A: When the electric field is applied to the conductor, then the electrons get accelerated but after…

Q: 11. Consider a wire with conduction electron density 5.9 x 1028 5. If the diameter of the wire is…

Q: . An electric heater is constructed by applying a potential difference of 120 V across a Nichrome…

A: Question:-2) An electric heater is constructed by applying a potential difference of 120 V across a…

Q: 3. A conducting fluid is contained in the space between two concentric spherical electrodes. (A…

A: Current density is the current per unit area. Current remains same for both electrodes. Area of…

Q: 2. If current of I = 5.00 A flows through a wire, How many number of electrons flow througl a point…

A: Given Data : The current in the wire is given as I=5A

Q: 3. Determine the currents I. k and h in the branches of the network shown in the figure, arbitrarily…

Q: 34 - The value is the resistivity at some reference temperature T and is usually taken to be…

Q: 2.A flashlight requires two 1.5-volt batteries for it to light. The current that flows through it is…

A: Let I be the current through the circuit and t be the time taken by the charge.

Q: How many electrons are transferred in a 10.0 A current that runs for 3.0 s?

A: Given data: Current (I) = 10.0 A Time (t) = 3.0 s Required: Number of electrons passed in 3.0 s

Q: Which of the following statements is true about the current? A. Current is the flow of electrons on…

Q: Which wire has a bigger cross-sectional area? 7. Which wire allows greater current? A. 12-gauge…

A: two available copper wires are :A = 12 gauge copper wire having a length of 1 meterB = 18 gauge…

Q: What is the resistance of an immersion heater that increases the temperature of 1.0 kg of water from…

Q: What would happen to the drift velocity of electrons in a wire if the resistance due to collisions…

Q: 3. An 18-gauge copper wire (p = 1.72x10% 0.m) has a diameter of 1.02 mm and a cross- sectional area…

Q: 28. Which of the following is a symbol of fuse? b. -o d. all of the abo а. 29. Three 12ohms…

A: 28. A fuse consists of a small piece of wire that shut off the power when too much electric current…

Q: Why does the resistivity of superconductors become zero

A: In a superconductor, below the critical temperature, the electrical resistance falls to zero.

Q: 4. A small but measurable current of 123 pA exists in a copper wire whose diameter is 2.46 mm.…

A: Current density is given by J=I/A Drift speed is v=J/ne, where n is electron density (electrons per…

Q: A typical lightning bolt may last for 0.197s and transfer 1.19 ✕ 1020 electrons. Calculate the…

A: The charge of the electron is(e) 1.6*10-19 C Given that lightning bolt may last for(t) 0.197s and…

Q: 1. What current flows through a 0.50 mm diameter rod of Aluminum that is 20.0 cm long, when 22 V is…

A: Given data: Diameter of Aluminum rod is, d=0.50 mm=0.50×10-3 m. Length of rod is, L=20.0…

Q: 2. If current of I = 5.00 A flows through a wire, How many number of electrons flow through a point…

A: Given I = 5.00 A t = 5.00 sec We know I = q/t - (1) Where…

Q: 5- A resistance and conductance values of 5 mA current flowing through a resistor due to 2.5 V…

Q: 3. Taking R = 1.00kN and ɛ = 250V in Figure, determine the direction and magnitude of the current in…

A: A circuit diagram or flow of current is shown below, By applying Kirchhoff law in loop cedc, By…

Q: In the Bohr model of hydrogen atom, the electron revolves around the nucleus in a circular path of…

Concept explainers

Microscopic view of current

In physics, the term current is expressed as the rate of flow of electric charges across the area per unit time (I=q/t). It propagates along in the direction of the motion of positive charges. When the current is caused by the motion of electrons, the direction of the current is opposite to the flow.

Question

Which of the following descriptions is
consistent with a constant decrease in the
29.
current through a uniform piece of a conductor?
No of electrons
per unit volume
A Unaltered
B Decreases
C Unaltered
Increases
Drift velocity of
electrons
Increases
unaktered
Decreases
D
Decreases

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

How can you decide if a wire is infinite?
A spherical shell with inner radius ra and outer radius rb is formed from a material of resistivity . It carries current radially, with uniform density in all directions. Show that its resistance is R=4(1ra1rb)
Draw a sketch of the situation in Figure 22.30 showing the direction of electrons carrying the current, and use RHR-l to verify the direction of the force on the wire.
The density of charge carriers far copper is 8.471028 electrons per cubic meter. What will be the Hall voltage reading from a probe made up of 3cm2cm1cm ( (LWT) ) copper plate when a current of 1.5 A is passed through it in a magnetic field of 2.5 T perpendicular to the 3cm2cm .
The immediate cause of many deaths is ventricular fibrillation, an uncoordinated quivering of the heart, as opposed to proper beating. An electric shock to the chest can cause momentary paralysis of the heart muscle, after which the heart will sometimes start organized beating again. A defibrillator is a device that applies a strong electric shock to the chest over a time of a few milliseconds. The device contains a capacitor of a few microfarads, charged to several thousand volts. Electrodes called paddles, about 8 cm across and coated with conducting paste, are held against the chest on both sides of the heart. Their handles are insulated to prevent injury to the operator, who calls Clear! and pushes a button on one paddle to discharge the capacitor through the patient's chest Assume an energy of 3.00 102 W s is to be delivered from a 30.0-F capacitor. To what potential difference must it be charged?
Can a wire carry a current and still be neutral-that is, have a total charge of zero? Explain.
The circuit in Figure P3 1.61 is located in a magnetic field whose magnitude varies with lime according to the expression B = 1.00 10-3 t, where B is in teslas and f is in seconds. Assume the resistance per length of the wire is 0.100 /m. Find the current in section PQ of length a = 65.0 cm.
The accompanied figure shows an arrangement for measuring mass of ions by an instrument called the mass spectrometer. An ion of mass m and charge +q is produced essentially at rest in source S, a chamber in which a gas discharge is taking place. The ion is accelerated by a potential difference and allowed to enter a region of constant magnetic field B q. In the uniform magnetic field region, the ion moves in a semicircular path striking a photographic plate at a distance x from the entry point. Derive a formula for mass m in terms of B0, q, Vacc, and x.
What does it mean to say that a certain current is 60Hz?
An electron is travelling at 100.0 km/s parallel to a long straight horizontal conductor a distance of 3.00 cm from the conductor. A current of 12.0 A runs through the wire as the electron travels parallel to it, in the same direction as the electron’s velocity. Find the strength of the external electric field that will prevent the electron from deviating from its original path. Express your answer in V/m
How much current is flowing in a wire 4.50 m long if the maximum force on it is 0.725 N when placed in a uniform 0.0850-T field?Express your answer to three significant figures and include the appropriate units.
The electric field inside a solid conductor in which there is no current is zero. Why?