3-12. A single-stub tuner is to match a lossless line of 400 N to a load of 800 - j300 N. The frequency is 3 GHz. a. Find the distance in meters from the load to the tuning stub. b. Determine the length in meters of the short-circuited stub.

3-12. A single-stub tuner is to match a lossless line of 400 N to a load of 800 - j300 N. The frequency is 3 GHz. a. Find the distance in meters from the load to the tuning stub. b. Determine the length in meters of the short-circuited stub.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.17MCQ

See similar textbooks

Related questions

Q: Q1) Use the analytical method, design a lossless L-section network to match a load impedance of…

A: Given that Load impedance =80+j10 ohms Characteristic impedance=50 ohm frequency =550MHz

Q: In a laboratory, we found that the static wavelength ratio was 2.0 as a result of an experiment…

A: Given :Z0 of T.L =50 ohm Standing wave ratio (s)=2.0The distance between succesive voltage minimum…

Q: By using appropriate equation, prove that the input impedance of a terminated Zz + jZ, tan BI Zo +…

A: Lossless Transmission Line A lossless transmission line is defined as a transmission line that has…

Q: The magnitude of the [A] parameter of a short transmission line is smaller than that of medium line.…

A: first we will write the expression for A constant for short and medium transmission line to judge…

Q: A load with an impedance of 424.3045° N is connected to a 100 N lossless line. Using the Smith Chart…

Q: 6. A 3000 transmission line is 0.8 m long and terminated with a short circuit. The line is operating…

A: z0= 300 ohm, wavelength =0.8m, length =0.8m

Q: lossless transmission line has a characteristic impedance of Zo=40N, load reflection coefficient is…

Q: A lossless 75Q transmission line is terminated by a load impedance of 90+j750. Using the Smith…

A: Since you have asked multipart questions, we will solve the first three subparts for you. If you…

Q: 10. A slotted line is used to measure VSWR of the load at 2 GHz by double minima method. If the…

A: Given f = 2GHz d2-d1 = 0.5 cm

Q: 27. A 50 N transmission line is terminated in a load that results in a reflection coefficient of…

A: given;Z0=50ΩΓL=0.5+j0.5ΓL=0.52+0.52ΓL=0.5ΓL=0.707a;load impedance…

Q: 4) When the transmission line is terminated by a matched load, what is the value of the VSWR?

Q: prove that a maximum power is transferred from a voltage source with an internal impedance Zg to a…

A: The equivalent circuit diagram for lossles transmission line length

Q: Two identical pulses each of magnitude 12 V and width 2 us are incident at i = 0 on a lossless…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: A transmitter delivers 50 W into a 600 Ω lossless line that is terminated with an antenna that has…

A: Brief description : Transmission line is a medium where we can transmit electromagnetic waves…

Q: The cutoff frequency for TE11 mode if the guide is filled with a lossless material having r = 2.25…

Q: With a neat diagram show the reflections occurring in a transmission line. Hence explain thec…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: A 376-2 lossless air transmission line is connected to a complex load composed of a 749-N resistor…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: At 3 GHz, a shorted parallel sideline will be used to match a 60 ohm transmission line to a load…

A: Given,f = 3 GHzZ0 = 60 ΩZL = 30-j60 Ω

Q: A 702 high-frequency lossless line is used at a frequency where 2 = 80cm with a load of 140+j91 2 a.…

Q: An AM radio station using double side band transmitted carrier system employs a carrier of frequency…

Q: A 5.2cm long, lossless 100Ω transmission line was terminated with a load of ?? = 30 + 50Ω. With the…

A: The load reflection coefficient is: So, the magnitude of the reflection coefficient is: 0.617 And,…

Q: Q1) Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming a…

A: Given: Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming…

Q: A 120-22 lossless line is terminated with 40- and 20- resistors in parallel. The voltage a the input…

Q: State the difference between high and low frequency signals travel in typical transmission lines.

A: Travelling wave in the transmission lines are the voltage and current wave from the sending end to…

Q: A 376-2 lossless air transmission line is connected to a complex load composed of a 749-2 resistor…

Q: The static wave ratio in a 300 ( N) lossless transmission line terminating at an unknown load…

A: GIVEN DATA:

Q: Example 1: For the lossless TL shown in below with length l, let Zg = 0 and ZR = 3Z9. Use Zig-zag…

A: 1)

Q: Find the characteristic impedance and signal velocity for a transmission line consisting of two…

A: Given: A transmission line consisting of two parallel strips with a width ω and a separation d.…

Q: Q4) Use the analytical method, design a lossless L-section network to match a load impedance of…

A: Load impedance ZL=150+j30 Ωcharacterstic impedanceZ0=50 ΩFrequency f=500 MHz

Q: A 100Ω lossless line connects a matched signal of 100kHz to a load of 25Ω. Calculate the reflection…

Q: Antenna with impedance 40 +j30 2 is to be matched to a 100 Q lossless line with a shorted stub.…

A: Antenna with impedance 40+j30Ω is to be matched to a 100 Ω lossless line with a shorted…

Q: A lossless 75-N coaxial cable has a velocity factor of 0.67. For a shorted line at a frequency of…

Q: A sinusoidal signal of 1 W average power is transmitted down 10 m of coaxial cable. of 0.1 mW is…

Q: For 860 MHz carrier frequency and for the geometry and

Q: A 300ᘯ transmission line is 0.8 m long and terminated with a short circuit. The line is operating in…

A: A 300ᘯ transmission line is 0.8 m long and terminated with ashort circuit.The line is operating in…

Q: A coaxial cable with a characteristic impedance of 50 Ohm is used to deliver mi- crowave signal to a…

Q: An unmodulated carrier is 680 Vp-p. Calculate the %m when its maximum p-p value reaches 650, 850…

Q: 5. The short circuit load is connected to a transmission line. When the transmission line length is…

Q: 6. The standing-wave ratio on a lossless 300-2 transmission line terminated in an unknown ZL is S=…

Q: An extra high voltage transmission line of length 300 km can be approximate by a lossless line…

A: Given, An extra high voltage transmission line of length= 300 km Propagation constant, β= 0.00127…

Q: 2.7) True or False: Directional antennas provide poor efficiency of power transmission. 2.8) Fill in…

A: Given True or false question and few fill in the blanks based on antenna theory. Please find the…

Q: A 75 Ω lossless line is terminated in error with a 93 Ω resistor. A generator sends 100 mW down the…

Q: The following lossless network is powered by a f=9,7 GHz microwave source. A matching circuit is…

A: Given, f = 9.7 GHz ZL = 34 L = 270,77835273601

Q: What different types and modern usage areas of transmission lines and waveguides ? Explain and…

A: Transmission lines are used to transmit power from generating stations to distribution an dfrom…

Q: A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100…

Q: A 75 Q lossless transmission line is to be matched with a 100-j802 load using Single stub. Calculate…

A: Given :Z0=75 ΩZL=100-j80 ΩZL=128.06∠38.66° f=30 MHz

Q: What are (a) the values of the intercept points in the load line and (b) the slope of the load line…

Q: 4- Prove that the Transmission system behavior differs at low and high frequencies? *

A: At low frequencies, the transmission line can be dealt by normal network theory. The elements too…

Question

Microwave

3-12. A single-stub tuner is to match a lossless line of 400 to a load of 800 - j300 N.
The frequency is 3 GHz.
a. Find the distance in meters from the load to the tuning stub.
b. Determine the length in meters of the short-circuited stub.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Question)The coupling factor and isolation of a lossless, symmetric directional coupler are 8 dB and 20 dB respectively. Determine the scattering matrix of the directional coupler. Also determine the directivity of the device? This Question from Microwave systems course.
Derive an expression for sag in a transmission line of equal height poles
A 50Ω lossless transmission line is terminated with a load impedance valued ZL = RL + jXL.According to what is given, a) RL for Voltage Standing Wave Ratio to be 2What should be the relationship between XL and?b) If RL = 100Ω, find the value of XL.c) Find the voltage minimum point closest to the load on the line.
A 300ᘯ transmission line is 0.8 m long and terminated with ashort circuit. The line is operating in air with a wavelength of 0.8m and is lossless. (a) If input voltage is 10V, what is themaximum voltage amplitude at any point on the line? (b) Whatis the current amplitude in the short circuit?
What are (a) the values of the intercept points in the load line and (b) the slope of the load line given the circuit?
A lossless coaxial cable with L = 0.5 uH/ft and C = 100 pF/ft is terminated by a 100-ohm resistive load. What is the characteristic impedance of the quarter-wavelength line that can be used for impedance matching?
Question)The coupling factor and isolation of a lossless, symmetric directional coupler are 8 dB and 20 dB respectively. Determine the scattering matrix of the directional coupler. Also determine the directivity of the device?
A load has a reflection coefficient of 0.5 when referred to 50 Ω. The load is at the end of a line with a 50 Ω characteristic impedance.(a) If the line has an electrical length of 45 degrees, what is the reflection coefficient calculated at the input of the line?(b) What is the VSWR on the 50 Ω line?
At 3 GHz, a shorted parallel sideline will be used to match a 60 ohm transmission line to a load impedance of ZL = 30 - j60 ohms. What should be the length of the parallel lateral line, in mm? Calculate using the Smith diagram.
Find the median path loss using Hata model for d= 10 Km, hte = 50 m, hre = 5 m in a urban environment. If the base station transmitter at a carrier frequency of 900 MHZ. Need Handwritten with All Formulas Clearly Mentioning. Thank you
An extra high voltage transmission line of length 300 km can be approximated by a lossless line having propgation constant is 0.00127 rad/km. The percentage ratio of line length to wave length will nearly by ?
2. What is a carrier frequency?