6. A 3000 transmission line is 0.8 m long and terminated with a short circuit. The line is operating in air with a wavelength of 0.8 m and is lossless. (a) If input voltage is 10V, what is the maximum voltage amplitude at any point on the line? (b) What is the current amplitude in the short circuit?

6. A 3000 transmission line is 0.8 m long and terminated with a short circuit. The line is operating in air with a wavelength of 0.8 m and is lossless. (a) If input voltage is 10V, what is the maximum voltage amplitude at any point on the line? (b) What is the current amplitude in the short circuit?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.31P: A 500-kV, 300-km, 6()-Hz, three-phase overhead transmission line, assumed to be lossless, has a...

See similar textbooks

Similar questions

An extra high voltage transmission line of length 300 km can be approximate by a lossless line having propogation constant β= 0.00127 radians per km. Then the percentage ratio of line length to wavelength will be given by ??
A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100 MHz. At an electrical length of 0.8 wavelengths, what is input admittance?
1. What is the necessary condition for matching transmission lines? In addition, what is a micro strip line? 2. For a distortion less line α = 0.02dB/m, Z0 (R0) = 60Ω and C = 0.2nF/m. Find the resistance and velocity of wave propagation. [Do not forget the units.] 3. For a finite lossless transmission line with open-circuit termination, sketch Xio vs l. Indicate where the sketch is inductive and capacitive.
Question)The coupling factor and isolation of a lossless, symmetric directional coupler are 8 dB and 20 dB respectively. Determine the scattering matrix of the directional coupler. Also determine the directivity of the device? This Question from Microwave systems course.
When a mobile node moves further away from a base station, what are two precautions the latter might take to ensure that the loss probability of a transmitted frame does not rise?
A 50Ω lossless transmission line is terminated with a load impedance valued ZL = RL + jXL.According to what is given, a) RL for Voltage Standing Wave Ratio to be 2What should be the relationship between XL and?b) If RL = 100Ω, find the value of XL.c) Find the voltage minimum point closest to the load on the line.
An extra high voltage transmission line of length 300 km can be approximated by a lossless line having propgation constant is 0.00127 rad/km. The percentage ratio of line length to wave length will nearly by ?
Describe the properties and use cases of satellite communication as an unguided transmission medium.
A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100 MHz. At an electrical length of 0.4 wavelengths, what is input impedance?
A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8 Henry/m inductance per meter. The diameter of the inner conductor as 0.8m, and the dielectric constant of the insulation as 4. Find the diameter of the outer conductor in cm. Assume the line is a lossless line?
Question)The coupling factor and isolation of a lossless, symmetric directional coupler are 8 dB and 20 dB respectively. Determine the scattering matrix of the directional coupler. Also determine the directivity of the device?
A lossless coaxial cable with L = 0.5 uH/ft and C = 100 pF/ft is terminated by a 100-ohm resistive load. What is the characteristic impedance of the quarter-wavelength line that can be used for impedance matching?