#3 Impedance in a Series RLC Circuit A 120 Q resistor, a 50.0 µF capacitor, and a 85.0 µH inductor is subject to an EMF with an angular frequency given by w = 1.25 x 106 s-1. What is the value of the impedance Z of the RLC combination? Recall that Z = VR² + (X1 – Xc)² where Xc = (wC)-! and Xµ = wL

#3 Impedance in a Series RLC Circuit A 120 Q resistor, a 50.0 µF capacitor, and a 85.0 µH inductor is subject to an EMF with an angular frequency given by w = 1.25 x 106 s-1. What is the value of the impedance Z of the RLC combination? Recall that Z = VR² + (X1 – Xc)² where Xc = (wC)-! and Xµ = wL

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 105PE: An RLC series circuit has a 200 (resistor and a 25.0 mH inductor. At 8000 Hz, the phase angle is...

See similar textbooks

Similar questions

An RLC series circuit has a 1.00 k(resistor, a 1.50 (H inductor, and a 25.0 nF capacitor. (a) Find the power factor at f = 7.50 Hz. (b) What is the phase angle at this frequency? (c) What is the average power at this frequency? (d) Find the average power at the circuit’s resonant frequency.
An RLC series circuit hag a 1.00 k(register, a 150 (H inductor, and a 25.0 nF capacitor. (a) Find the circuit’s impedance at 500 Hz. (b) Find the circuit’s impedance at 7.50 kHz. (c) It the voltage source has Vrms = 408 V, what is Irms at each frequency? (d) What is the resonant frequency of the circuit? (e) What is Irms at resonance?
An RLC series circuit has a 2.50 (resistor, a 100 (H inductor, and an 80.0 (F capacitor. (a) Find the circuit's impedance at 120 Hz. (b) Find the circuit’s impedance at 5.00 kHz. (c) If the voltage source has Vrms = 5.60 V, what is Irms at each frequency? (d) What is the resonant frequency of the circuit? (e) What is Irms at resonance?
Consider a series RLC circuit with R = 25 , L = 6.0 mH, and C = 25 F. The circuit is connected to a 10.-V (rms), 600.-Hz AC source. (a) Is the sum of the voltage drops across R, L, and C equal to 10. V (rms)? (b) Which is greatest, the power delivered to the resistor, to the capacitor, or to the inductor? (c) Find the average power delivered to the circuit.
A series RLC circuit has resonance angular frequency 2.00 103 rad/s. When it is operating at some input frequency, XL = 12.0 and XC = 8.00 . (a) Is this input frequency higher than, lower than, or the same as the resonance frequency? Explain how you can tell. (b) Explain whether it is possible to determine the values of both L and C. (c) If it is possible, find L and C. If it is not possible, give a compact expression for the condition that L and C must satisfy.
Review. A radar transmitter contains an LC circuit oscillating at 1.00 1010 Hz. (a) For a one-turn loop having an inductance of 400 pH to resonate at this frequency, what capacitance is required in series with the loop? (b) The capacitor has square, parallel plates separated by 1.00 mm of air. What should the edge length of the plates be? (c) What is the common reactance of the loop and capacitor at resonance?
An RLC series circuit has a 200 (resistor and a 25.0 mH inductor. At 8000 Hz, the phase angle is 45.0°. (a) What is the impedance? (b) Find the circuit’s capacitance. (c) If Vrms = 408 V is applied, what is the average power supplied?
An AC source operating at 60. Hz with a maximum voltage of 170 V is connected in series with a resistor (R = 1.2 k) and an inductor (L = 2.8 H). (a) What is the maximum value of the current in the circuit? (b) What are the maximum values of the potential difference across the resistor and the inductor? (c) When the current is at a maximum, what are the magnitudes of the potential differences across the resistor, the inductor, and the AC source? (d) When the current is zero, what are the magnitudes of the potential difference across the resistor, the inductor, and the AC source?
An inductor (L = 400 mH), a capacitor (C = 4.43 F), C1 and a resistor (R = 500 11) are connected in series. A 50.0-Hz AC] source produces a peak current of 250 mA in the circuit, (a) Calculate the required peak voltage Vmax (b) Determine the phase angle by which the current leads or lags the applied voltage.
A 60.0-ft resistor is connected in series with a 30.0-F capacitor and a source whose maximum voltage is 120 V, operating at 60.0 Hz. Find (a) the capacitive reactance of the circuit, (b) the impedance of the circuit, and (c) the maximum current in the circuit. (d) Does the voltage lead or lag the current? (e) How will adding an inductor in series with the existing resistor and capacitor affect the current? Explain.
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
An LC circuit like the one in Figure CQ32.8 contains an 82.0-mH inductor and a 17.0-F capacitor that initially carries a 180-C charge. The switch is open for t 0 and is then thrown closed at t = 0. (a) Find the frequency (in hertz) of the resulting oscillations. At t = 1.00 ms, Find (b) the charge on the capacitor and (c) the current in the circuit.