3) [Problem 2.7] A system is described by the following differential equation:d²y dy d³x+5 +ydtd²xdx+4dt²+6 +8.x.dt³ dt² dtd³ydt³+3Find the expression for the transfer function of the system Y(s)/X(s).

We need to find out the transfer function for given system .

3) [Problem 2.7] A system is described by the following differential equation: d²y dt² d³y dt³ +3 +5 dy dt d³x d²x dx +4 dt³ dt² dt +6 +8x. Find the expression for the transfer function of the system Y(s)/X(s).

3) [Problem 2.7] A system is described by the following differential equation: d²y dt² d³y dt³ +3 +5 dy dt d³x d²x dx +4 dt³ dt² dt +6 +8x. Find the expression for the transfer function of the system Y(s)/X(s).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A coil having a 240V source has a current of 10.5 A when the frequency is set to 60 Hz. When the…

Q: ) Find the branch currents ia through ie for the circuit attached. B) Check your answer by showing…

Q: Determine the total resistance, RT, and current, I, for the circuit in Figure Q1(b). 30V I RT 5092…

Q: H.W₂ = C = 1MF; if Ans: For the integrator op-Amp the input voltage is 015. Cos lopt, find, the…

Q: Give the truth table

Q: If the impulse response c (t) doesn't change sign, the system is over damped or critically damped.…

A: When the system is under-damped, the impulse response c(t) of the system oscillates about the origin…

Q: Solve for the mesh current 11, then give its magnitude (in Amperes). Use V-28V. (Give answer in 3…

Q: Do you have any idea what the connection is between a diode and an LED in terms of semiconductors?…

A: Introduction Diode: A p-n junction diode is a two-terminal electronic component that consists of a…

Q: 3. An input-output relationship of a discrete-system is given by: y[n] = 15x[2n+1] + 8 Say "Yes" or…

A: Given,The input-output relationship of a discrete system is given by,y[n]=15x[2n+1]+8

Q: Write a boolean expression for output Q based on inputs A, B, and C (Do NOT simplify): 入。 B U A

A: Given data, Circuit is,

Q: براير المائد A. How can we increase the bandwidth of frequency response? مار انسان فرما لرووك الدليل…

A: In the given questions we need to discuss about the property of operational amplifier regarding its…

Q: 9 For the circuit shown in Fig. 9.46, find Zeq and use that to find current I. Let ω = 10 rad/s. w…

A: Given an electrical circuit ω=10 rad/sec To find (a) Zeq=Z equivalent (b) Current I

Q: For the Low Pass Filter in figure 1, develop a differential equation for the voltage, Vout, based on…

A: Given the Low pass filter,

Q: Power Quality: Ensuring that the voltage and frequency of the power supplied to customers is of good…

A: We need to explain affect in power quality over next 100 years

Q: 32/0°V( Β) -j4 Ω ΤΣ 8 8 Ω j10 Ω m 1ο ΖΩ V₂ www j6Ω ν Vo 1Ω www 14 13 -j2 Ω V3 -j4 V

Q: Consider V= 11 V, the dependent source shown in the circuit given below is unfortunately installed…

Q: series RLC circuit.

Q: A 5 degree/step stepper motor rotate 40 steps counter clockwise, stop for a minute and rotate 55…

Q: hat is the value of V in

A: Given data, Circuit diagram is given as,

Q: Find the Y parameter y21 (in Siemen). Let R=0.83 Ohm. I₁ 0.392 R R ww 1₂ V₂ (Use 3 decimal places.…

Q: Ex) find the energy of the function f(t)=2 2 Cos (56) Sin 2 t At

Q: Given that V₁ = -15V and V₂ = 26V, what is V3? + V3 w V₁ V₂

A: Given data, V1=-15 V, V2=26 V. Circuit diagram is given as,

Q: Draw (by hand) the spectrum of the signal s(t) = 4sin(2πt) + 2sin(6πt) + 8/π sin(7πt). Also identify…

Q: A voltage generator with v, (t) = 4 cos (3m x 10ºt) V and internal impedance Z₂ = 50 N is connected…

Q: Problem 3. Find the transfer function, V₁(s)/V(s), for the electrical network shown in Figure 3,…

Q: Find the current that passes through the 12 resistor. A D 352 www 6V E www F 192 www 292 392 www 9V…

Q: X(t) = AS (2Tyt +Q) : Asalw²+0) Ladibide be lause of the good by Inlogadany. Soul wale اعلی core…

A: Please refer the attached images for the complete answer

Q: 6.23 The electric field of an electromagnetic wave propagat- ing in air is given by E(z, t) = x4…

A: A changing electric field produce magnetic field. A changing magnetic field produce electric field.…

Q: Determine internal bias voltage vont V-=-15 V+=15

A: Op-amp is multistage amplifier. The ideal op-amp have infinite input resistance and infinite gain.…

Q: 3-30. Figure 3P-30 shows the block diagram of a control system with conditional feedback. The…

A: This question contains a block diagram with conditional feedback with transfer function Gp(s) for…

Q: If Van = 220 260° V in the network of the following Figure, find the load phase currents LAB, IBC,…

Q: For the circuit shown determine Vx V2 R4 1k 11 VY

A: Given circuit,

Q: Evaluate the equivalent resistance of these circuits, give your answer to three significant figures.…

A: Introduction: Electrical…

Q: *2. Find the convolution of the following two signals manually (using graphical sketch and…

Q: Capacitor bank energisation causes current and voltage transient operating states. Thus, the maximum…

A: Given Line to line voltage = VLine =6.6 kV System frequency =fs =50 Hz capacitor kVA rating is =kVA…

Q: #3. Find i(t) in the circuit shown below す。 v(t) = 220 cos (3774) lok VA PF = 0.9

A: Calculation of the current i(t) of the circuit shown below: From the circuit given:…

Q: A series RL circuit connected to a 110-V ac source. If the voltage across the resistor is 43 V, the…

A: Given,AC voltage source, Vs=110 VandVoltage across resistor, VR = 43 V

Q: 2. (Impulse - +) Calculate the following expressions by using the properties of delta function. a)…

Q: In Fig. A10, the current I is: 2 A 9 A 4 A 5 A 6 A 4

Q: a. Find the relationship between Vout and Vin in the Op-Amp below, and draw the diagram of Vout VS.…

A: Given: a. b. and c.

Q: 2.14 Determine currents / to Is in the circuit of Fig. P2.14. 18 V + 222 3A I 8ΩΣ 12 14 12Ω 4Ω 13…

A: The given circuit diagram is shown below,

Q: In detailed steps, describe how to measure a DC voltage with a digital multimeter?

A: Voltage : - Voltage is defined as the potential difference between two terminals is known as…

Q: 150 , Z02 50 , and For the transmission line system in Figure 2, and for the values of Z01 1 =…

A: Transmission Line:Z01=150ΩZ02=50Ωl=0.357 λ1To find SWR=?

Q: V(1) .2 R1 www +1 + R2 لا but (t)

A: Given:

Q: . For a typical silica fibre with D (@ λ = 1.3μm) = 2.5 nm ps/km and a semiconductor laser source…

A: Given: Typical silica fibre with D@λ=1.3μm=2.5nm ps/km Semiconductor laser source centered on…

Q: 2.19 From the circuit in Fig. 2.83, find I, the power dissipated by the resistor, and the power…

Q: 4. A full-wave bridge controlled rectifier has an AC input of 120V rms at 60Hz and 2012 load…

A: Given: Full-wave bridge controlled rectifier having,Vsrms=120 V,f=60 Hz,R=20 Ω,α=40°

Q: 2 Cπ 2π α 2 SVm² sin wt² dwt

Q: Problem 1: Let's define two systems by the following output-input relationships: y₁ (t) = x(t− 2) +…

A: Since you have posted multiple questions with multiple sub parts, we will provide the solution only…

Q: 45 A double-pole plate-switch, when used as an isolator for a shower circuit can only be installed:

A: A statement is given in the question. We need to complete the statement.

Question

3) [Problem 2.7] A system is described by the following differential equation:
d²y dy d³x
+5 +y
dt
d²x
dx
+4
dt²
+6 +8.x.
dt³ dt² dt
d³y
dt³
+3
Find the expression for the transfer function of the system Y(s)/X(s).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Different Types of System and Its Property

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q: Obtain Nyquist Plot of the following transfer function . Also verify your result theoretically? G(s)H(s) = (s+8) / s (s+3)9s+6)
The system defined by the equation a) Find the transfer function. b) Find the output y(t) of the system for ?(?) = sin(3?). c) Examine the stability of the system for the given input.
Problem 1: Find the transfer function, using the standard formula for a second order system. for a second order system. Establish the relative damping factor and the natural frequency. Tell whether according to the value ? the system is suitable.
Find the transfer function of the given electrical system below from the state equation. Assume v(t) be the input of the system and the voltage across C be the output of the system. Let X1 be the current flowing on L1, X2 be the voltage across C and X3 be the current flowing on L2.
Given the signal flow graph, apply Mason’s Rule to acquire the single transfer function, G(s). Express your transfer function in a form where the coefficient of the highest exponent of s in the denominator is equal to 1. If there is a numerical answer that is nonterminating, it should be expressed up to three (3) decimal places only.
Solve correctly please, with detailed explanation need. Show roughly how the Nyquist diagram of the transfer function given above will look like.
a) get the equation of motion by drawing the free body diagram of the given system.b) get the transfer function of the system. Ɵ(s)/T (s) = ?Show all decals in detail.
Derive the equation of C(t), Compute the time specifications & the maximum over shoot of the given transfer functions.
Write equation of motion from which the transfer function, G(s) = θL(s)/T(s),
4.Transfer function of the pulmonary system that represents alveolar pressure PAto Pao is given by ?(?)=0.8/?2+4?+1. How much is PAfor Pao = 5 mmH2O, at steady stateinmmH2O? The original of the problem is attached.
Given the linear mechanical system below:Determine the transfer function ?3(?)/?(?). Express your answer as a single fraction andarrange the degree of variables in descending order.
1. The CT signal x(t)=3cos (600πt) + 6cos2 (mπt) is critically sampled (Nyquist rate)by fs=4000 Hz. Find:i. The value of m.ii. The frequency components of the signal.iii. The frequency resolution (Δf) of the output spectrum if the sampled signal isprocessed by 64 point-DFT.iv. Define frequency resolution.