3. A 120KVA, 0.65 lag pf is connected in parallel to a 150KW, 0.8 lead pf and to 300KVA, 120KVAR inductive load supplied by 3000V, 50hz source. Determine the total apparent power, PITIt = L: 120 kVA, 0.65 Pf lea 6, 44 Ko

3. A 120KVA, 0.65 lag pf is connected in parallel to a 150KW, 0.8 lead pf and to 300KVA, 120KVAR inductive load supplied by 3000V, 50hz source. Determine the total apparent power, PITIt = L: 120 kVA, 0.65 Pf lea 6, 44 Ko

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 10PP: In an R-L parallel circuit, ET=240 volts, R=560, and XL=330. Find apparent power.

See similar textbooks

Related questions

Q: 1. Determine the total resistance of the following resistors if they are all in a) series b) paralle...

A: GIVEN: resistance of the resistors R1: GREEN, YELLOW, BRAWN R2: BLUE, BRAWN, ...

Q: Find the total current of the circuit below. -j5 N 5Ω 3Ω 100/0° V(A, 5Ω j4 N O 55/29 - j80/29 A O 22...

Q: 3. Find for the total current in the circuit and the voltage across Vo.

Q: Two units are connected in parallel , are energized by an AC source. If the components are 10 and 14...

Q: find the electric field at P(6,-3,-4) due to Q1 = -30uc at (2,3,-6) a. -576 ax + 724 ay - 346 az V...

Q: Pt A 6v battey, delivers loMA to thvee resistors in paralkel, R, =1kr,R2 =2k2,R3%=Rx- Caleatates a) ...

A: Given: 3 resistance in parallelV=6VI=10 mA

Q: Assume the input signal to a rectifier circuit has a peak value of VM = 12 V and is at a frequency o...

A: The information given : The peak value of VM=12 V The frequency f=60 Hz The output load resistance...

Q: A long shunt compound generator is rated 22 kW at 220 V. Its armature, series field, and shunt field...

Q: Given: Common-Emitter Voltage-Divider Swamped Amplifier Configuration. +10 V Re 3.3 kО R 33 kN 1 µF ...

A: This is a basic problem of BJT The solution is given below

Q: 1. A building, supplied by a public utility, contains three balanced loads connected to the three-ph...

A: A building that contains three balanced loads connected to the three-phase lines - Load 1: Delta-co...

Q: Calculate the voltage across the 2-ohm resistor. Express it in polar form. Show your complete soluti...

A: We have to calculate the voltage across 2ohm

Q: A balanced three-phase circuit has the following characteristics: i. Y-Y connected i. The line volta...

A: Star-connected network: A star-connected network is made by connecting all the positive or negativ...

Q: Calculate the percent voltage drop in a 500 KVA transformer having 2% resistance and 4% reactance wh...

Q: An electrical firm manufactures light bulbs that have a length of life that is approximately normall...

Q: GIUEN Rz VIMU OR=20 %3D MOTA Rr ky= %3D 10A %3D notspilquA to Rc-42 3A RC YTO WAUTUB ADMO

Q: 20 w- 20. 102 4V( iz 8A 18 V

Q: 4. Consider the two sinusoidal signals X1(t) = 3cos(@t + t/2) and X 2(t) = (3+j2)cos(@t). Let P(t) b...

Q: A mA DC ammeter has an internal structure shown in Figure Q2(a) below. Given that the PMMC has an in...

Q: 34. Circuit schematics determines the corresponding circuit's function. (a) True (b) False

A: We can be able to determine the circuits function by observing the schematic of that circuit. Ther...

Q: TOPIC: Ohm's Law, Power and Generating Direct Current Direct Current Circuit Analysis Inductor, Cap...

Q: 2. A balanced, three phase circuit is characterized as follows: a. Wye – Delta connected b. Source i...

A: As the given system is balanced so we can convert three phase system to single phase equivalent circ...

Q: Consider the diodes D1, D2, and D3 type as Silicon, Germanium, and GaAs respectively. Calculate for ...

Q: Show that 1+ 5i 5 3+ 3' -3i

Q: Design a PLC program that will correctly execute the following industrial control process: A part is...

A: We need to draw and explain the PLC diagram for the given operation. The given operation and conditi...

Q: If all resistors has a value of 4 ohm and inductive reactances, are j82, what is the total resistanc...

Q: In the following circuit, what value of X will result in the load drawing no reactive power when att...

Q: Find i(t) for t> 0 in the circuit shown. 42 ww ww t=0 50 V (+

A: Transient analysis of capacitor and inductor When a voltage is applied across a capacitor initially ...

Q: A 25 ohm resistor connected in series with a coil of 50 ohm resistance and 150 mH inductance. The co...

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly re...

Q: A DC series generator delivers a load of 20 kW at 400 V. The armature and field resistances are 0.3 ...

Q: Explain with illustrations the following dynamic performance terms as applied to measument systems ...

A: Explain with illustration of following 1. Rise time 2. Time constant 3. Setting time

Q: In free fall motion, the velocity versus time graph is a straight line sloping upward. (A) True B) F...

A: 1. In free fall motion, the velocity versus time graph is a straight line sloping upward True of Fa...

Q: A three stage amplifier has the following gains and noise factor for each stage: 1st stage Gain=10 d...

Q: Express the unit vector a, in spherical components at the point: (a) r = 2,0 = 1 rad, ø = 0.8 rad (b...

Q: The yearly load duration curve of a certain power station can be approximated as straight line; the ...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: 2 V(1 2 2 2 4 V 4 V 2 3.

Q: A digital communication link carries binary-coded words representing samples of an input signal, ...

A: It is given that: xa(t)=3cos⁡(600πt)+2cos⁡(1800πt)

Q: Why do we need 3 types of cascaded amplifiers?

A: Cascaded amplifiers A two-port network in which amplifiers are connected in a series. The output of ...

Q: Rocker switch (SPST) Push Button Switch (Push to make)

A: SWITCH Switches are an integral part of electronics device. Which almost every electronic device has...

Q: Two loads are connected to your standard 110V(rms), 60HZ outlet; Load 1: R = 2002 in series with L= ...

Q: ind current thru the 5 ohm resistor (at the middle of circuit). 5Ω : 3Ω |-j5 2 100/0° V(A 1 10/30A. ...

Q: 30 Q 25 Q 10 Q 20 Ω a o 15 N bo

Q: 3. A lightning bolt strikes an airplane with 3OKA for 2ms. How many Coulombs of charge are deposited...

Q: 5. The R-L series circuit shown below has source (E) frequency is 4-KHz. Determine: (a) the magnitud...

Q: 2-4) Find the number of poles in the left half-plane, the right half-plane, and on the jw-axis for t...

A: Routh hurweitz criteria used to determine poles in left side, right side and jw axis.

Q: The atomic radius of a BCC crystal if a is the sides of the cube is? Select one:

A: Given: Side of the cube=a. Let the atomic radius be 'r'.

Q: 2 the Tx 2 3

Q: peak /cie, instantaneous voltage v at the following angles: (a) 30° , (b) 120° , (c) 220° , (d) 210°...

Q: 11. A thermocouple generates (a) small voltage (b) small resistance (c) small current (d) small heat

Q: (a) A CIRCUIT HAS IN SERIES AN ELECTROMOTIVE FORCE 40 V CONSTANT, A 10 Q RESISTOR AND A 0.2 H INDUCT...

Q: 13.80 When an input voltage of 30u(1) V is applied to a circuit, the response is known to be (50e-80...

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

3. A 120KVA, 0.65 lag pf is connected in parallel to a 150KW, 0.8 lead pf and to 300KVA, 120KVAR inductive load supplied by
3000V, 50hz source. Determine the total apparent power, PHT,I1 :
L: 120 kUA, 065 Pf lea
6,
49 40

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
In an R-L parallel circuit, ET=240 volts, R=560, and XL=330. Find apparent power.
A voltage v = 311 sin (377t + 600) is applied across a circuit having an inductance of 0.34 H. What is the magnitude of the impedance in ohms?
A capacitor of 3.18 microfarads is connected in parallel with a resistance of 2000 ohms. The combination is further connected in series with an inductance of 795 mH and resistance of 100 ohms across a supply given by e=400 sinwt + 80 sin( 3w+60). Asusme w=314 radians per sec. Determine the circuit power factor.
A 3- phase , 50 Hz, 400 motor develops 100 H.P. ( 74.6 kW ), the power factor being 0.75 lagging and efficiency 93%. A bank of capacitors is connected in delta across the supply terminals and power factor raised to 0.95 lagging . Each of the capacitance units is built of 4 similar 100 V capacitors . Determine the capacitance of each capacitor .
A 200 – ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in parallel across a 120 – V, 60 – Hz AC line. Calculate the following: a.) RESISTOR CURRENT b.) INDUCTOR CURRENT c.) CAPACITOR CURRENT d.) TOTAL CURRENT e.) PHASE ANGLE f.) TOTAL IMPEDANCE DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES.
Three star-connected equal inductors take 5 kW at 0.7 pf when connected to a 400 V, 50 Hz three-phase three-wire balanced supply. Calculate the line currents when, i) all inductors are properly connected ii) if one of the inductors is disconnected andiii) if one of the inductors is short circuited. ...
A coil having an inductance of 0.2H and a resistance of 10 ohm is connected across a 100V a.c. supply, calculate the phase difference between the supply voltage and the current when the frequency 470Hz; (Give your answer in degrees)
A 3-phase, 50Hz, 415V motor develops 100 H.P.(74.6kW), the power factor being 0.85 lagging and efficiency of 95%. A bank of capacitors are connected in delta across the supply terminals and power factor is increased to 0.96 lagging. Each of the capacitance units is build of four similar 100 V capacitors. Determine the capacitance of each capacitor.
Three identical capacitors are connected in star to a 415 V, 50 Hz, 3-phase supply. If XC = 15 ohms, then the value of the capacitance is, 0.212 F 212.2 μF 212.2 F 2.12 μF
A 440-V, 60-Hz,36.7 HP induction motor has power factor of 0.75 (lagging). Three Δ-connected capacitors are installed to improve the power factor to 0.95 (lagging). Calculate the kVA ________________ of the capacitor bank, and the capacitance of each capacitor (in microfarads) __________________. (please answer with 3 decimal, and clear solution!)
A series circuit composed of a resistance of 24 ohms, an inductance of 0.09 henry and a capacitance of 8 microfarad, is connected to a 120-volt 50-Hz supply. Calculate the (a) power factor of the circuit, (b) total reactive power, (c) voltage drop accross the inductor.