3-phase, 50Hz, 415V motor develops 100 H.P.(74.6kW), the power factor being 0.85 lagging and efficiency of 95%. A bank of capacitors are connected in delta across the supply terminals and power factor is increased to 0.96 lagging. Each of the capacitance units is build of four similar 100 V capacitors. Determine the capacitance of each capacitor.

Q: A supply of 250 V, 80 Hz is connected across an inductive load and the power  consumed is 2 kW, when…

A:

Q: 4. An induction motor draws 4.5 A at a 0.75 lagging power factor from a 208V, 60 Hz source. a) What…

A: Only one question is to be answered according to bartleby policy.

Q: A 5000KVA, 6600V, 3 star connected alternator has a resistance of 0.75 per phase Estimate by ZPF…

A:

Q: 3. A 3-phase, 50 Hz, 3000 V motor develops 600 H.P. (447-6 kW), the power factor being 0-75 lagging…

A: Given power factor 1 = 0.75 lagging raised power factor = 0.95 lagging

Q: 23. A 150- microfarad capacitor is connected to a 220 V, 60- cycle source. Calculate a. The…

A:

Q: A 230V, 50Hz, single phase motor takes a current of 4A and has a PF of 0.6 lagging. A capacitor in…

A:

Q: An industrial plant consisting primarily of induction motor loads absorbs 500 kW at 0.6 power factor…

A: In this question we need to find a KVA rating of shunt capacitor and overall power factor when…

Q: A synchronous generator, with synchronous reactance of 4 ohm, is connected directly to an infinite…

A:

Q: 1. What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines…

A:

Q: What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines B.…

A: The explanation is as follows.

Q: R1 L1 ww 50Q 10mH V1 C1 220 Vrms 10uF 60 Hz 0° Computed Values Compute the expected power factor of…

A:

Q: Problem 2 A capacitor is used to correct the power factor of the load of the following figure.…

A: Capacitance value not given It might be 50 Hz or 60 Hz  So taking both the cases... It is a simple…

Q: 2) A single-phase electrical installation, supplied by a voltage of 220V;50Hz, includes in parallel:…

A: Active Power is the time rate of change of energy. Its SI unit is watt.   Reactive power is an…

Q: Two loads are placed in parallel across a 120Vrms 60Hz line. The first load draws 150VA at a Lagging…

A:

Q: An ac motor with impedance Z, (4.0 A40) O is supplied by an RMS value of 220-V, 60-Hz source. You…

A: According to question: The real power taken by the load is calculated as

Q: Problem 11.6: Determine the capacitor rating in KVAR and also in farad to improve the load pf from…

A: Given: A power factor of the load is improved from 0.75 lagging to 0.95 lagging in a 3-phase, 60 Hz,…

Q: Q1. A 550-V is supplied to a plant comprising of a parallel-connected induction motor drawing 75 kW…

A: NOTE: Since you have asked multiple questions, we will solve the first question for you. If you want…

Q: Calculate the current drawn from the source with and without the capacitor connected. Determine the…

A:

Q: A 127 uf capacitor is connected to a 125V 50 cycle source . Calculate (a) the capacitive reactance…

A:

Q: For a driven series R⁢L⁢C circuit, the voltage amplitude V0 and frequency f of the voltage generator…

A:

Q: 1. A load has the following information: o Line Voltage: 220V o Line current: 5A o Frequency: 60 Hz…

A: The solution is given below

Q: When connected to a 120-V (rms), 60-Hz power line, an inductive load absorbs 4 kW at a lagging power…

A: Given as per the circuit,Power factor = 0.8cosϕ1=0.8ϕ1=cos-1(0.8) = 36.87°where ϕ1 is the phase…

Q: A 40 kW induction motor, with a lagging power factor of 0.76, is supplied by a 120 V rms 60 Hz…

A: The solution is given below

Q: pure capacitor

A: Conductor-Materials which have free electrons in valence which can flow when comes under any…

Q: Q3 A three-phase induction motor has the following data: 50 hp and V440 and 50HZ operating at full…

A: first calculate total active and reactive power before and after compensation . reactive power…

Q: (b) A water pump (single phase motor) connected to 400 V, 50 Hz supply takes 35.8 A at a power…

A:

Q: Find: 1. Voltage at the source (no capacitors are installed) 2. Capacitors are installed at the load…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 186-V/120-Hz source is connected to an inductance L = 0.4 H and a capacitance C = 9 μF, the elements…

A: To solve this question we find the reactance value of inductor and Capacitor and connect them…

Q: Lance Smile operated two loads in parallel. The loads draw a total of 3kW at a 90% power factor…

A: Given that Total Load (LT) = 3kW @ 0.9pf lagging Given that Load 1(L1) = 1000W @ 0.8pf lagging…

Q: Find the value of parallel capacitance needed to correct a load of 120 KVAR at 0.75 lagging pf to…

A:

Q: A 440-V, 60-Hz,36.7 HP induction motor has power factor of 0.75 (lagging). Three Δ-connected…

A:

Q: (b) A water pump (single phase motor) connected to 400 V, 50 Hz supply takes 35.8 A at a power…

A:

Q: 1. Consider a composite load, powered from a 208 Vms ac line, that consists of the following four…

A: Calculate the real and reactive power delivered to load 1. PL1=5000 WQL1=0 VAR

Q: A three phase industrial plant is supplied by balanced three phase ac source: Vab = 571 V (rms)…

A: First we will calculate the total real and reactive power from source  with and without capacitor…

Q: A 3- phase , 50 Hz, 400 motor develops 100 H.P. ( 74.6 kW ), the power factor being 0.75 lagging and…

A:

Q: A load is consisting of induction motors is drawing 80 kW from a 220-V, 60-Hz power line at a power…

A: Referring to the given question, the load power (P) is 80kW. The power factor is given as 0.72.…

Q: Determine the apparent power, power factor & power factor angle when connected in a) series; b)…

A:

Q: A 235V, 50HZ, single phase motor takes current of 6A at a PF of 0.5 lagging. Determine the value of…

A: As per our guidelines, we can answer only first 3 sub parts, kindly repost the question with other…

Q: Electrical load that draws current whose impedance varies throughout the cycle of the input ac…

A: Correct option is TRUE we know that Non linear loads draws non linear current whose impedance is…

Q: 2. A 400-V, 3-phase induction motor load takes 900 kVA at a power factor of 0.707. Calculate the kVA…

A: Case I S= 900 KVA PF1= 0.707 PF1 = cos ϕ1 = 0.707 Φ1= 45° Real power P1 = S * PF1 = 900k * 0.707 =…

Q: A factory has a large induction heater operating at 1000 V, 50Hz. The current flowing into the…

A: Given V= 1000 V I =12.33 A True power  = 10 kW   Note: Load type (single phase or three phase) is…

Q: Circuit Diagram V1 R1 220 Vrms >50 Ω 60 Hz 0.⁰ L1 100mH Computed Values Compute the expected power…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A 230V, 50HZ, single phase motor takes a current of 4A and has a PF of 0.6 lagging. A capacitor in…

A:

Q: An 880 V A ,220V,50HZ, load has a power factor of 0.8 lagging What value of parallel capacitance…

A:

Q: A single-phase electrical installation, supplied by a volta includes in Two single-phase motors,…

A:

Q: A 3-phase, 50 Hz, 3300 V star connected induction motor develops 250 H.P. (186-5 kW), the power…

A:

Q: A source supplies power to the following three loads connected in parallel: (1) a lighting load…

A: Given a source supplies power to the following loads 1)Lighting load 10kw 2) Induction motor 10 KVA…

Q: A 110V(rms), 60HZ AC source is connected to a motor, which can be represented by a resistor and an…

A:

Q: A single phase motor connected to 400V, 50HZ supply takes 37A at a power factor of 0.8 lagging.…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: 1. A single-phase sinusoidal AC supply voltage defined as: V(t) = 220 sin(314t – 40°) is connected…

A: In this question we need to find current flowing through capacitor and we need to draw phasor…

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.