3. A 3kg block sits on a 32° ramp, as shown. It is attached by a rope to a wall at the top of the ramp, and the tension in the rope is 10N. a) Using the tilted coordinate system, as shown, fill in the force table. (Hint: read this page for advice.) Force b) Solve for the unknown values. x c) What values could us have? (That is, solve the inequality for it.) y 32° 10N

3. A 3kg block sits on a 32° ramp, as shown. It is attached by a rope to a wall at the top of the ramp, and the tension in the rope is 10N. a) Using the tilted coordinate system, as shown, fill in the force table. (Hint: read this page for advice.) Force b) Solve for the unknown values. x c) What values could us have? (That is, solve the inequality for it.) y 32° 10N

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 125 kg box is pushed up a ramp with a force of 100N applied at a 30 deg below the horizontal. Coefficient of static friction is 0.9. 1. What is the normal force on the box? 2. What is the friction force on the box? 3. What is the largest friction force could be?
1. Consider a plane of mass 50,000 kg in takeoff when the thrust for each of its four engines is 25,000 N. If the plane is facing an air drag force of 10,000 N; What is the acceleration of the plane? 2. Peter, who has a mass of 80 Kg is skateboarding at 5 m/s when he smacks into a brick wall and comes to a dead stop in 0.25 sec. What is his acceleration? What is the force acting on him? 3. A boxer punches a sheet of paper in midair and bring it from rest up to a speed of 20 m/s in in 0.02 sec. Mass of paper is 0.005 Kg. a.What acceleration is imparted to the paper? b.What force does the boxer exert on it? c. What force does the paper exert on the boxer? 4. If you stand next to a wall on a frictionless skateboard and push the wall with a force of 40 N, how hard does the wall push on you? If your mass is 75 Kg, what will be your acceleration? 5. What average net force is required to bring a 1200 kg car to rest from a speed of 25 m/s (90 km/h) in 10 seconds? 6. A 50 Kg toolbox is being…
Q1. A 750-pound boat sits on a ramp inclined at 60 degree, what force is required to keep the boat from rolling down the ramp?
3) I hate to burst your bubble, but this video is fake. There’s a battery powered skateboard hidden in the mop bucket. Assume the mass of the entire system is {43} kg, and gravity is 10 N/kg. (Maybe start with part d?) If the board can accelerate at 1.5 m/s2, how much net force is needed? If the skateboard motor can put out 300 N of force, how much friction (neglect air resistance combined) does the system have? What is the kinetic frictional coefficient for mop bucket on roadway?
In the very Dutch sport of Fierljeppen, athletes run up to a long pole and then use it to vault across a canal as shown in (Figure 1). At the very top of his arc, a 70 kg vaulter is moving at 2.9 m/s and is 5.5 m from the bottom end of the pole. What is the magnitude of the vertical force that the pole exerts on the vaulter? Express your answer with the appropriate units.
1. A 20,000 pound truck is parked on a 15° slope. Find the force required to keep the truck from rolling down the hill (that is, find the magnitude of the vector component of the weight of the truck that is parallel to the slope). 2.Determine the vector v with magnitude of 30 that makes an angle of 120° with the positive xaxis. State the vector in either ordered set or unit vector notation with components written as exact values (simplified radical form).
1. A large wrecking ball is held in place by two light steel cables as shown in the figure. If the mass m of the wrecking ball is 4200 kg, what are the tensions TB in the cable that makes an angle of 40° with the vertical and the tension TA in the horizontal cable? 2. If M = 1.5 kg, what are the tensions in string 1 and string 2?
I was given this problem, and I don't really know what to do about the fact that the normal force doesn't equal the weight for this problem. How am I supposed to find the kinetic friction coefficient now? A box of mass 2,463g is on level ground being pulled by a force of 6.41N at angle 47.2 above horizontal. If the block is moving with a constant velocity, what is the kinetic friction coefficient? (Hint: the normal force does not always equal the weight; it does not in this case.)
1. What is the importance of solving and learning about netforce
2. A 850kg elevator is designed to carry 10 people (m= 50kg) safely, and accelerate upwards at 0.3 m/s^2. What minimum tension should the cable be able to support.
Whirl a 7kg weight on a 1.8m rope the weight makes 1 rev in 1 second. A. What is the centripetal acceleration of the weight? B. What is the tension in the top?
1. You are tasked with designing the runway on an aircraft carrier. The minimum speed for the F/A18 Hornet is 200 mph. The Hornet weighs 40,000 lbf and its twin engines provide a thrust of ~40,000 lbf combined, providing a max acceleration of 1g.a. How long must the deck be to takeoff unassisted? Give the answer in ft. b. This is most likely longer than your typical ~450 ft carrier. What acceleration must you achieve with both the engines and with a catapult system together to reach the required minimum speed by the end of the deck? c. What net force (combined engines and catapult) must be applied to the plane to get the acceleration in b? d. Do you think the plane will be able to use disk brakes on its tires to stop when landing?Use your knowledge of friction to make your argument. Also know that their coefficient of friction is ~1.