3. A cylindrical water tank of radius 10 feet and height 30 feet is half filled with water. How much work is required to pump all the water over the upper rim of the tank? Note: the weight-density of water is 62.4. lb ft3*

3. A cylindrical water tank of radius 10 feet and height 30 feet is half filled with water. How much work is required to pump all the water over the upper rim of the tank? Note: the weight-density of water is 62.4. lb ft3*

Name: 3. A cylindrical water tank of radius 10 feet and height 30 feet is h
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: 3. A cylindrical water tank of radius 10 feet and height 30 feet is half filled with water. Howmuch work is required to pump all the water over the upper rim of the tank? Note: theweight-density of water is 62.43

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter15: Fluid Mechanics

Section: Chapter Questions

Problem 14P: Review. The tank in Figure P15.13 is filled with water of depth d. At the bottom of one sidewall is...

See similar textbooks

Similar questions

The left ventricle of a resting adult's heart pumps blood at a flow rate of 83.0 cm3/s , increasing its pressure by 110 mm Hg, its speed from zero to 30.0 cm/s, and its height by 5.00 cm. (All cumbers are averaged over the entire heartbeat) Calculate the total power output of left ventricle. Note that most of the power is used to increase blood pressure.
Verigy that the SI of hpg is N/m2.
Why is it difficult to swim under water in the Great Salt Lake?
A garden hose with a diameter of 2.0 cm is used to fill a bucket, which has a volume of 0.10 cubic meters. It takes 1.2 minutes to fill. An adjustable nozzle is attached to the hose to decrease the diameter of the opening, which increases the speed of the water. The hose is held level to the ground at a height of 1.0 meters and the diameter is decreased until a flower bed 3.0 meters away is reached. (a) What is the volume flow rate of the through the nozzle when the diameter 2.0 cm? (b) What does is the speed of coming out of the hose? (c) What does the speed of the water coming out of the hose need to be to reach the flower bed 3.0 meters away? (d) What is be diameter of nozzle needed to reach be flower bed?
Suppose water is raised by capillary action to a height of 5.00 cm in a glass tube. (a) To what height will it be raised in a paraffin tube of the same radius? (b) In a silver tube of the same radius?
, Water flows straight down from an open faucet (Figure 4.55). The cross-sectional area of the faucet is 1.8 10-4 ma, and the speed of the water as it leaves me faucet is 0.85 m/s. Ignoring air resistance, find the cross-sectional area of the water stream at a point 0.10 m below the faucet opening.
What pressure is exerted on the bottom of a 0.500-m-wide by 0.900-m-long gas tank that can hold 50.0 kg of gasoline by the weight of the gasoline in it when it is full?
Pascal’s Principle and Hydraulics 59. How much pressure is transmitted in the hydraulic system considered in Example 14.3? Express your answer in atmospheres.
. A certain part of an aircraft engine has a volume of 1.3 Ft3, (a) Find the weight of the piece when it is made of iron. (b) If the same piece is made of aluminum, what is its weight? Determine how much weight is saved by using aluminum instead of iron.
A large storage tank with an open top is filled to a height h0. The tank is punctured at a height h above the bottom of the tank (Fig. P15.39). Find an expression for how far from the tank the exiting stream lands. Figure P15.39
Water pressure inside a hose nozzle can be less than atmospheric pressure due to the Bernoulli effect. Explain in terms of energy how the water can emerge from the nozzle against the opposing atmospheric pressure.
A sump pump (used to drain water from the basement of houses built below the water table) is draining a flooded basement at the rate of 0.750 us, with an output pressure of 3.00105 N/m2. (a) The water enters a hose with a 3.00-cm inside diameter and rises 2.50 m above the pump. What is its pressure at this point? (b) The hose goes over the foundation wall, losing 0.500 m in height, and widens to 4.00 cm in diameter. What is the pressure now? You may neglect frictional losses in both parts of the problem.