3. A programmable unijunction transistor (PUT) is programmed by choosing the a. gate resistors b. RC time constant c. Cathode resistor d. power supply voltage

Q: What is the maximum conversion time for a 16-bit dual-ramp converter using a 1-MHz clock frequency?…

A: The maximum conversion time is calculated by using the expression as shown below: Plugging the…

Q: Diode Logic Gates - OR, NOR, AND, Not, & NAND Circuit diagram and explain it Using this link:…

A:

Q: ° Can transistor can be used as a switch? ° What happens when the switch is off in a transistor

A: In this question,   We need to explain that Can transistor  be used as a switch?

Q: 4) Draw a diagram of a single line analog CMOS switch.

A:

Q: It is desired to determine the operating point by drawing the DC load line of the transistor. (B =…

A:

Q: Q1. 220V, 200, 100mH are represents data information for a two-level VSI feeds an inductive load. If…

A: Impedance parameter or open circuit parameter is explained as the electrical behavior of linear…

Q: In a PCM system, if maximum frequency of the input analog signal is 5 KHz and number of levels in…

A:

Q: Implemet using diodes the logic gates for OR, NOR, AND , NAND

A:

Q: Draw a block diagram of successive approximation ADC and explain its operation briefly.

A: Block diagram of successive approximation ADC

Q: The circuit below is a two inputs BJT logic gate. Logic ʻ1' voltage is 5V and logic 0' voltage is…

A: It is given that: a circuit of BJT logic gate having two inputs. When the logic is 1, the voltage…

Q: Can transistor can be used as a switch? ° What happens when the switch is off in a transistor? ° Why…

A: Reason  BJT is a current controlled Device in which base current control the mode of operation of…

Q: Q3) A single phase half bridge inverter has R=1002 and the de input voltage is Vdc =75v determine…

A:

Q: Difference between active high and active low pin?

A: The solution can be achieved as follows.

Q: Give the Circuit diagram for Logic Circuit (OR, NOR, AND ,NAND ) in Diode Logic and Resistor…

A:

Q: i. Draw the circuit diagram of 4-bit Ripple Carry Adder.

A: To draw the circuit diagram of 4 bit ripple carry adder 4 full adders are connected one after…

Q: Q4-A) For single phase voltage source bridge inverter: 1- Draw the circuit. 2- With R=102 , L=50mH,…

A: 4. It is given that: R=10 ΩL=50 mH=50×10-3 Hf=50 HzVs=400 V

Q: high switching frequency?

A: Given: The high switching frequency makes input and output voltage more effective and also improving…

Q: Find the RMS voltage expression of output phase voltage of a balanced three-phase square wave…

A: Balanced three-phase square wave inverter: Consider a 3-phase voltage source inverter (VSI) feeding…

Q: Q. How the serial communication is performed in 8086 and draw and explain each block of internal…

A: In serial communication one bit is transferred at a time. Serial communication of 8086 is…

Q: be the Sampling PCM system is 60000HZ and the maximum number that represents cach sample is 15?

A: Given parameters are: The maximum Bandwidth of a PCM system is BWmax=60000Hz The number of…

Q: Q5. A general analysis of the switch-mode inverter shown in the figure below is to be done. The…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: What is the appropriate display type (common anode/common cathode) that must be used with 7447…

A: LED display can be broadly classified into two types  (i) Common Anode  In common Anode type display…

Q: How do transistors amplify signals?

A: Transistor act as an amplifier if it's increases the strength of input signal. By using biasing we…

Q: OB: The full bridge inverter has a switching sequence that produce a square wave voltage across…

A: INVERTER: An inverter (sometimes known as a power inverter) is a power electronics device that…

Q: Briefly explain the basic concepts of transistors and diodes can function as logic gates!

A:

Q: Industrial Motor Controls 18.a. The PLC motor speed control system you are working on has an analog…

A: A Programmable Logic Controller is abbreviated as PLC. These are used for programmable variety of…

Q: 1) In the mononstable multivibrator using 555 timer, if the output Q = logic (0), what will happen…

A: Answer: 1 ) The capacitor will charge and the transistor will be OFF is correct and remaining…

Q: If Vin exceeded Vref in a real ADC IC, would it actually damage the IC? If not, what would the…

A:

Q: How to conduct freezing techniques in troubleshooting transistor.

A: How to conduct freezing techniques in troubleshooting transistor.

Q: 1-GTO needs very large reverse gate current normally ____________ of anode current

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Which module of the microcontroller will definitely be used if an analog signal needs to be read in…

A:

Q: v. The DC supply of single phase bridge inverter is 350V. For quasi-square wave output voltage with…

A:

Q: A thyristor has a maximum average gate power dissipation limit of 0.2 watts. It is triggered with…

A: The information we have : The maximum average gate power dissipation is 0.2 watts. Pulse frequency,…

Q: A single phase half-bridge voltage source inverter (VSI) has a resistive load of 2.4Ω and input dc…

A: Single phase half bridge is a voltage source inverter. The input power of the inverter is a DC…

Q: frst second 1 00 AA' third 110

A: ASM chart there are three components. They are i) state box, ii) Decision box, iii) condition box.…

Q: Please answer the following, what identifies a circuit as a diode digital logic AND gate? as a diode…

A: 1. Diode digital logic AND gate The logic circuit of AND gate will be Truth table A B D1 D2 Y…

Q: 58 Which criterion is used to determine the MAXIMUM fuse size allowed in a PV source circuit? Total…

A:

Q: Diode Logic Gates - OR, NOR, AND, Not, & NAND Circuit diagram and explain it

A:

Q: Diode Logic Gates - OR, NOR, AND, Not, & NAND Give Circuit diagram and table  and explain it

A: There are many types of logic gates, namely NOT gate OR gate AND gate NAND gate NOR gate EXOR gate…

Q: Describe the operation of binary ripple counters

A:

Q: transistor logic (discuss)

A: The explanation is as follows.

Q: Draw the V-I characteristics of SCR,MOSFET,IGBT

A:

Q: 1- The thyristor holding current is defined as:* the minimum thyristor current that holds the…

A: there are multiple questions. as you haven't specified which one is to be solved. so I am solving…

Q: Single -phase full-bridge inverter has a resistive load of R=5 Ohm and the input dc voltage is 220…

A:

Q: For the ALU circuit shown below, what should be the control word (S251SO) to perform the (sl A)…

A: According to the question, for the given circuit as shown below We need to find the condition for…

Q: The circuit below is a two inputs BJT logic gate. Logic ʻ1’ voltage is 5V and logic 0' voltage is…

A: Here, we have given a circuit of BJT logic gate having two inputs.  When the logic is 1, the voltage…