1) In the mononstable multivibrator using 555 timer, if the output Q = logic (0), what will happen to the capacitor and the transistor? a) The capacitor will charge and the transistor will be OFF. b) The capacitor will charge and the transistor will be ON. c) The capacitor will discharge and the transistor will be OFF. d) The capacitor will discharge and the transistor will be ON

1) In the mononstable multivibrator using 555 timer, if the output Q = logic (0), what will happen to the capacitor and the transistor? a) The capacitor will charge and the transistor will be OFF. b) The capacitor will charge and the transistor will be ON. c) The capacitor will discharge and the transistor will be OFF. d) The capacitor will discharge and the transistor will be ON

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Similar questions

Implement Four-to-one-line multiplexer with Logic diagram and Function table.
Book Reference Barry B Brey 8th edition. llustrate how external hardware interrupt on INTR pin of 8086/88 is tackled?
What is a transmission gate? Draw its circuit circuit diagram. How does it operate? What is the need for a transmission gate? What is it disadvantage?
Use any digital logic simulator Fill-in the blank boxes with the correct LOGIC GATE/ Full/Half Adder
Define a 2-bit demultiplexer to be a circuit whose single input line is steered to one of the four output linesdepending on the state of the two control lines (A, B). Draw its logic diagram (to the gate level) and specify the exactstate of A and B for each output line when that output line is selected.
Design 3 systems that represent minterm 30 for a 5-input system: 1.-using logic gates, with a maximum of two inputs each, which represent a low active output. Ensures efficient interpretation of the diagram 2.- exclusively using two-input NAND logic gates 3.- Using components at TTL level.
Draw the logic diagram and transistor implementation for a (2-2-2) AOI.
A question about 74LS04 IC (a Schmitt Trigger). The pictures show the 74LS04 logic, the connection required and data sheet. Question a)In order to light up the LED, what should Pin 1 and Point A connected to? Ans: Pin 1 connected to (5V / GND), Point A connected to (5V / GND). b)In this example, the power that lights up the LED comes from where? c)What is the current shown on the multi-meter? Is the current flowing out from Pin 2 or flowing into the Pin 2?
Perform the functions given below with the decoder given below and a suitable logic gate. ?1(?,?, ?) = ∑m( 3, 5, 6) ?2(?,?, ?) =∑m ( 1, 4)
1a. If an 8-bit binary number is used to represent an analog value in the range from 010 to 10010, what does the binary value 011001002 represent? 1b. If an 8-bit binary number is used to represent an analog value in the range from 32 to 212, what is the accuracy of the system? In other words, if the binary number is incremented by one, how much change does it represent in the analog value?
Discuss the pin diagram of any logic gate? Explain how the NAND gate can be used to derive the other logic gates.
Design a three bit synchronous binary counter that counts two by two with T-flipflops,continously. Output should be one when the counter equals maximum number.a. Draw the exitation table b. Draw the corresponding state diagram. c. Tabulate the state table for the sequential circuit. d. Draw the logic diagram of the circuit.