Answered: 3. A Pure Inductance of 3mh Carries A…

3. A Pure Inductance of 3mh Carries A Current Of The Waveform Shown in Fig. Sketch The Waveform Of V (t) And P(t). Determine The Average Value of Power current -10A time(sec)

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: 9.10 Find the steady-state expression for vo(t) in the circuit shown by using the technique of…

A: For the given circuit calculation of steady state expression for v0(t) using source transformation:…

Q: v06=La VOE USG=d. VS1 = Ey val= V02= ta = 182 V₁, V2, V3, V4, V5, V6, V7 U$1=78² Find: 120 v

Q: For step response of an under damped second order system, the settling times are given as: ts1: for…

A: Given for step response of a under damped system Settling time for 1% tolerance band: ts1 Settling…

Q: Vin = 10 V Te = 2.50 M R₁= 100 Q

A: We need to find out current and voltage for given circuit

Q: The logic circuit shown in the given fig.2 can be minimised to X Yo

A: A gate logic circuit is shown below. We have to minimize the gate logic circuit.

Q: 17. What is the share of renewable energies on the total electrical energy generated for 2019/2020?…

A: Introduction:. Electricity is produced using all sources of renewable energy. Geothermal steam is…

Q: Electrical Engineering Provide a list of products that can be used to keep a constant current on the…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 7.27. A linear time-invariant discrete-time system has transfer function 3z H(z) = (z+0.5)(z- 0.5)…

A: Given:- transfer function Hz=3zz+0.5z-0.5 Output response, yn=0.5n-3-0.5n+4un We have to find…

Q: 1) A coil composed of 100 turns has an inductance of 5 mH. If the number of turns is doubled without…

A: Given: A coil has following specifications, Initial turs, N1=100 Inductance, L1=5 mH Number of turns…

Q: What is the maximum modulating frequency allowed in commercial FM broadcastings? a. 40 KHz b. 75 KHz…

A: The correct option along with the explanation has been provided in the following section.

Q: 1. Construct a Routh table to analyze the stability of the following system, D(s) = s² + s² + 2s +24

A: Given system characteristics equation, Ds=s3+s2+2s+24

Q: 100V Find: R₁=5_22 P₁, P2, P3, P4, P5, P6 and TOTAL POWER R4=1512 R₂ = 5-2 R3=10_2 26 = 2012 Rs=2012

Q: Calculate the torque in newton-metre developed by a 440-V d.c. motor having an armature resistance…

A: Given data, Terminal voltage V = 440 V Armature resistance, Ra=0.25 Ω Speed N =750 RPM Armature…

Q: V1 R1 www www R3 R4 R2 ww www R5 Given: V1-5 volts. R1-502, R2-3000, R3-100062, R4-5500, R5-4400 d)…

A: Solution !!

Q: The contribution of current source /2 is now calculated by making /₁ open circuit. R₁ = 3.8 Q, R2 =…

Q: The reactance of O 100 Ohms 000 48.48 Ohms 87.46 Ohms 1.64 Ohms

A: Given data, Impedance is given, Z=100∠610

Q: Vs VA R₁ 1₁ R3 Vc VB R₂ 2 = 100 (2, R3 = 50 (2, R4 = 90 02, and Vs = 10 V. 01 Substitute the values…

A: This question belongs to circuit theory . It is based on the concept of mesh analysis in the circuit…

Q: What is the charge that passes th 100V Oa. 200 c O b. 150 C OC 300 C d. 250 C Ⓒe. 350 C

A: Circuit diagram is given,

Q: Drill 7,3 Repeat Example 7.2 if the 20-cm line is terminated in a 50-22 load instead of a short.…

Q: 11a) Give 5 different examples of field devices can provide digital input signals to a PLC. b)…

A: a). An input device is a piece of computer hardware equipment used to provide data, and control…

Q: Find the energy stored in the capacitor: 20 20V (a) + Vc T

A: Given data, Given circuit diagram is,

Q: image480

Q: Determine the magnetic field at (0, 0, 5m) due to 15 A current flowing in a circular loop of radius…

A: Given a circular loop in the magnetic field, Current, I=15 A Circular loop radius, a=3 m Magnetic…

Q: Next the multimeter will be used to measure the voltage VOUT_B for the second potential divider. The…

A: We need to find out output voltage for given circuit.

Q: For the following vector field calculate the flux at surface S. F= . surface S:{x² + y²+z²=9, x0,…

Q: 20 V 24 = 20-2 3R₁ = 10-22 · R3 =152 FR₂=15_22²} ind the 11, 12, 13, 14, 15, 16, 17, and Total Power…

Q: The Venus orbiter has a parabolic high gain communications subsystem with specifications provided in…

Q: Find the energy stored in the inductor: 24V 1H fig1 60 www + VR

Q: Q.65 (i) How many 128x8 RAM chips are required to provide a memory capacity of 2048 bytes. (ii) How…

A: Solution !!

Q: A moving coil instrument requires 20mA and 100mV for full-scale deflection. What is the value of the…

A: Given data, Full scale deflection current Im=20 mA Full scale deflection voltage Vm=100 mV Current…

Q: What are the 5 countries that have the greatest installed capacity for the generation of energy from…

A: Renewable Energy:- The energy that is produced by natural processes and constantly replenished is…

Q: 75. Copper resistance wire of certain length and is drawn out to three times its length without…

A: Let initial length is l1=l Now, length is drawn three times l2=3l1 Let cross section area is A1…

Q: 18. A current of 16 amperes divides between two branches in parallel of resistances 8 ohms and 12…

A: We need to find out current for given circuit

Q: For the circuit shown in the figure, in which the capacitor is initially fully discharged. If the…

Q: Please solve this one-step equations using the appropriate operation to balance it. Thank You !…

A: Given: One step equation, X-12=3

Q: tír(t), t≥0.

A: At the time t<0, capacitor was connected with the 10V voltage source as shown in figure it this…

Q: 2. 230V, 60 Hz I← 322 ww 18-22 0.0139 H -WM- ・18-2 0.025 H

Q: According to Carson's rule, Bandwidth B and modulating frequency fm are related a a. B = 2(Af + fm)…

A: According to Carson's rule,

Q: 4-Find the voltages across each resistor by using Voltage Divider Rule from the circuit shown below.…

A: Given circuit,

Q: 5. Using 2nd approximation, find current I. D₁, Si E₁ = 20 v R, = 2.2 kΩ M KH D₂, Si O E₂ = 4 v

A: We need to find current for given circuit

Q: 4. Find Req. 7 ohms 7 ohms 7 ohms: 7 ohms 7 ohms Req 7 ohms 7 ohms

A: Given: A network consisting of 7 Ohm resistances in variety series parallel combinations. We have…

Q: 1. Provide a block diagram and a function table for the NOR-Gate Latch. 2. Describe, with the aid of…

A: Since you have asked multiple questions, we will solve the first question for you If you want any…

Q: etermine the transfer function of the network below:

A: Given:

Q: 3. A Pure Inductance of 3mh Carries A Current Of The Waveform Shown in Fig. Sketch The Waveform Of V…

Q: Now short out source V₁ and calculate the voltage across R₂ due to V₂. V₁ = 9.8 V₁ V₂ = 9.9 V, R₁ =…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: In the following circuit find thevenin's voltage across terminals A and B. 4Ω 1964 B 8 Ω 7Ω 3Ω

A: Given data, Circuit diagram is given as,

Q: A three-phase induction motor with 72 stator windings is excited with a 50 Hz AC voltage source. The…

A: Given: A 3-phase induction motor has 72 stator windings. Excitation frequency, f=50 Hz Slip,…

Q: The slight sideward motion of a shaft is called end play. The end play in theshaft of a rotor for an…

A: The end play of the rotor of an electric motor should be, End play ≤132 inch The given motor has an…

Q: For a given transfer function

Q: To achieve 75 percent modulation of a carrier of V, 190 V, what amplitude of the modulating signal V…

A: Modulation index is given, m=75 %=0.75 Amplitude of carrier signal Vc=190 V

Concept explainers

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.

Question

3. A Pure Inductance of 3mh Carries A Current Of The Waveform Shown in Fig. Sketch The Waveform Of V (t) And
P(t). Determine The Average Value of Power
current
10 A
-10A
time(sec)
10

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A coil has a resistance of 50 ohms and an inductance of 0.5 Henry. What is the RMS value of current flowing in the coil if the supply voltage is Vt = 500sin377t.
In the inductor circuit, if the source voltage, V1, is 8.7∠10° Vp, what would be the voltage in RMS?
Calculate the R value in ohms, since the 13kHz frequency sinusoidal sign is observed at the output of the circuit in the picture. (C=10nF)
Consider a 760 W light bulb that requires an RMS voltage 21 V to operate normally. How large should an inductance be connected in series with the bulb if the combination is connected across a RMS voltage 255 V, 71 Hz line? (You may neglect the resistance of the inductor and the inductance of the light bulb.)
Using the phase shift of 72º from the Experiment, determine the inductance value, L, of the inductor shown. Vr(t) =3.7272 cos(4000 t - 72°) [V]
b) Find the rms current flowing in an AC capacitive circuit when a 4μF capacitor is connected across a 880V, 60Hz supply.
The capacitor of external defibrillator must be loaded at 1500V, in order to generate a two-phase wave of 150 J.Considering a transthoracic impedance is 80ohms and a capacitance of 30 000 uF. 3- What is the energy of the capacitor?4- What is the internal impedance of the defibrillator in the previous cases?
Consider the following sinusoidal plot of the instantaneous voltage of an inductor as a function of time.What is its root-mean-square voltage?
A 400 Hz sinusoidal voltage with a maximum amplitude of 100 Vat t=0 is applied across the terminals of an inductor. The maximumamplitude of the steady-state current in the inductor is 20 A.1. What is the frequency of the inductor current?2. If the phase angle of the voltage is zero, what is the phase angle ofthe current?3. What is the inductive reactance of the inductor?4. What is the inductance of the inductor in millihenrys?5. What is the impedance of the inductor?
An RLC circuit (has resistance and reactive elements) supplied by a 60Hz power source is found to have a lagging power factor (PF). What can you say about the relative contributions of the resistance (R), XL inductance, XC capacitance & resistance/reactance (ratio) utilized in this circuit at the 60Hz frequency? (min two statements – major reactive element & comparison to Resistive element)
What is the equation of the current in B in the function of sin given that Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags behind A by π/3 radians and the total linecurrent is 23.4 amp. (rms).
A pure inductance of L= 25mH has a current of i = 3 cos 2000t A. What is the angle theta (in degrees) of the equation below (include the sign if + or -)? V= V max sin ( 2000t ___ )