3. A Styrofoam cooler has total wall area (including the lid) of 0.80 square meter and wall thickness 2.0 cm. It is filled with ice, water, and cans of Omni-Cola, all at 0°c. a. What is the rate of heat flow into the cooler if the temperature of the outside wall is 30°C? b.How much ice melts in 3 hours?

3. A Styrofoam cooler has total wall area (including the lid) of 0.80 square meter and wall thickness 2.0 cm. It is filled with ice, water, and cans of Omni-Cola, all at 0°c. a. What is the rate of heat flow into the cooler if the temperature of the outside wall is 30°C? b.How much ice melts in 3 hours?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter14: Heat And Heat Transfer Methods

Section: Chapter Questions

Problem 17PE: (a) How much heat transfer is necessary to raise the temperature of a 0.200kg piece of ice from...

See similar textbooks

Similar questions

In 1986, a gargantuan iceberg broke away from the Ross Ice Shelf in Antarctica. It was approximately a rectangle 160 km long, 40.0 km wide, and 250 m thick. (a) What is the mass of this iceberg, given that the density of ice is 917kg/m3 ? (b) How much heat transfer (in joules) is needed to melt it? (c) How many years would it take sunlight alone to melt ice this thick, if the ice absorbs an average of 100W/m2, 12.00 h per day?
A person inhales and exhales 2.00 L of 37.0C air, evaporating 4.00102g of water from the lungs and breathing passages with each breath. (a) How much heat transfer occurs due to evaporation in each breath? (b) What is the rate of heat transfer in watts if the person is breathing at a moderate rate of 18.0 breaths per minute? (c) If the inhaled air had a temperature of 20.0C, what is the rate of heat transfer for warming the air? (d) Discuss the total rate of heat transfer as it relates to typical metabolic rates. Will this breathing be a major form of heat transfer for this person?
(a) How much heat transfer is required to raise the temperature of a 0.750kg aluminum pot containing 2.50 kg of water from 30.0C to the boiling point and then boil away 0.750 kg of water? (b) How long does this take if the rate of heat transfer is 500 W 1watt=ljoule/second(lW=lJ/s) ?
Integrated Concepts One 30.0C day the relative humidity is 75.0%, and that evening the temperature drops to 20.0C, well below the dew point. (a) How many grams of water condense from each cubic meter of air? (b) How much heat transfer occurs by this condensation? (c) What temperature increase could this cause in dry air?
To help prevent from damage, 4.00 kg at 0C water is sprayed onto a fruit tree. (a) How much heat transfer occurs as the water freezes? (b) How much would the temperature at the 200kg tree decrease if this amount of heat transferred from the tree? Take the specific heat to be 3.35kJ/kgC, and assume that no phase change occurs.
(a) Calculate the rate of heat conduction through house walls that are 13.0 cm thick and that have an average thermal conductivity twice that of glass wool. Assume there are no windows or doors. The surface area of the walls is 120m2 and their inside surface is at 18.0C, while their outside surface is at 5.00C. (b) How many 1-kW room heaters would be needed to balance the heat transfer due to conduction?
Unreasonable Results (a) An automobile mechanic claims that an aluminum rod fits loosely into its hole on an aluminum engine block because the engine is hot and the rod is cold. If 1he hole is 10.0% bigger in diameter than the 22.0C rod, at what temperature will the rod be the same size as the hole? (b) What is unreasonable about this temperature? (2) Which premise is responsible?
(a) If a 500mL glass beaker is filled to the brim with ethyl alcohol at a temperature of 500C, how much will overflow when its temperature reaches 210C ? (b) How much less water would overflow under the same conditions?
A high-end gas stove usually has at least one burner rated at 14 000 Btu/h. (a) If you place a 0.25-kg aluminum pot containing 2.0 liters of water at 20.C on this burner, how long will it take to bring the water to a boil, assuming all the heat from the burner goes into the pot? (b) Once boiling begins how much time is required to boil all the water out of the pot?
A glass windowpane in a home is 0.620 cm thick and has dimensions of 1.00 in 2.00 in. On a certain day, the temperature of the interior surface of the glass is 25.0C and the exterior surface temperature is 0C. (a) What is the rate at which energy is transferred by heat through the glass? (b) How much energy is transferred through the window in one day, assuming the temperatures on the surfaces remain constant?
(a) Calculate the rate of heat conduction through house walls that are 13.0 cm thick and have an average thermal conductivity twice that of glass wool. Assume there are no windows or doors. The walls' surface area is 120 m2 and their inside surface is at 18.0 , while their outside surface is at 5.00 . (b) How many 1-kW room heaters would be needed to balance the heat transfer due to conduction?
Unreasonable Results (a) Calculate the rate of heat transfer by conduction through a window with an area of 1.00 m2 that is 0.750 cm thick, if its inner surface is at 22.00C and its outer surface is at 35.00C (b) What is unreasonable about this result? (c) Which premise or assumption is responsible?