3. A three-phase, three wire, CBA system with an a line voltage of 150 Volt, has three impedances of 5 – j 5 in Delta connection. Determine the line current, phase current, phase and line voltage,

Q: Calculate G. in the circuit of Fig. 2.41.

A: The circuit given is shown below:

Q: 10 Is 's jin n Iz 1/30° A -j1 0 +) 2/0° V Ig -

A:

Q: A 18µF capacitor and a 270 ohm resistor are connected in series with a function generator. The suppl...

A: When resistance is connected in series with capacitance and the whole network is connected to a supp...

Q: Design a Pl controller of the form C(s) = k(T;s+1) function P(s) = for the plant with transfer s+1 T...

A: A P.I Controller could be a feedback management loop that calculates a mistake signal by subtracting...

Q: 34. Which of the following is not a technique for FM demodulation? a) Phase locked discriminator b) ...

A:

Q: 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 20 Q 10Ω 20 Ω 4 Ig 10 Ω Vo 40 V...

A:

Q: 34. Which of the following is not a technique for FM demodulation? a) Phase locked discriminator b) ...

A: Phase locked discriminator :  Phase locked demodulator is used to demodulated the FM signal it works...

Q: 4. When supplied with current at 240-V, single-phase at 50 Hz, a certain inductive coil takes 13.62 ...

A:

Q: 3.22 Determine v, and vz in the circuit of Fig. 3.71. 8Ω 3 A v2 + V% 1Ω 12 V 4Ω Figure 3.71 두

A:

Q: perform the following division in binary 11111111/101

A:

Q: an alternating voltage of 10 V and frequency 50 Hz is applied to an inductor of 2H what is the r.m.s...

A: By ohms law , Current in impedance = (voltage across impedance)/ impedance.  Impedance =2×pi×frequen...

Q: A coil has a resistance of 14 Q at 50°C. If the temperature coefficient of resistance at 0°C is 0.00...

A:

Q: Two resistors of 100 kiloohms are connected in series and a supply of 200 volts DC is impressed acro...

A: When two resistors R1 & R2 are connected in series, their equivalent resistance is Req = R1 + R2...

Q: In a half wave rectifier, the input sine wave is 300 sin 100 Trt Volts. The average output voltage i...

A: Option b 95.5 v Just use the output wave form of half wave rectifier and integrate it over given tim...

Q: The gate terminal in a D-MOSFET is separated from the channel material by a thin layer of ___.  Cho...

A:

Q: 4. Figure shows a 1-0 system with power source that feeds a 120 kVA 12.47/2.4 kV transformer through...

A:

Q: (d) In a balanced three-phase wye-wye (Y-Y) system, V;< = 200210° Vrms. The load impedance per phase...

A:

Q: Using a single 7400 IC, connect circuits that produce the following gates. Use the diagrams below to...

A:

Q: (b) A balanced Y-connected load has phase voltage of 230 V and positive phase sequence. The impedanc...

A: Given data is 

Q: 6. A circuit takes a current of 8 A at 100 V, the current lagging by 30° behind the applied voltage....

A:

Q: 3. For each of the silicon diode shown in the Fig.1 & Fig. 2 below: determine whether The diode is F...

A: In this question , we will find that every silicon diode is forward biased or reverse biased.....

Q: 10 22 62 82 20V 24V

A:

Q: What input voltage is needed in a bridge rectifier circuit to have an output of 10Vp?

A:

Q: 49. Which of the following is true for first-generation wireless systems? a) Low rate b) Efficient c...

A: The first generation of mobile and wireless networks based on analog technology. The first-generatio...

Q: 1. Find the voltage between the open terminal A and B for the network shown in Figure-5 using Norton...

A: The Norton's resistance of the circuit is calculated by replacing the current source with an open ci...

Q: etween the line and phase value of currents and voltage, Q2 show that the active power input to a th...

A: The solution is given below 

Q: Sketch each of the following sequences for n= 0,1,2,3. а. х(п) %3D 65(п - 1) -108(п- 3) b. x(п) — би...

A:

Q: an n-channel JFET, the source-drain voltage must be connected so that the positive polarity is appli...

A: In an n- channel  mosfet the drain current is always flows from  drain to source terminals. Since , ...

Q: (d) (x + 2)(x + y)(z +y) (e) ā + 5+ abč (f) (a. b. č) + (č. d)

A:

Q: Find the half cosine-series of f(t) = t, 0 < t < 2. %3D

A:

Q: How is the output frequency of a frequency of a PLL synthesizer changed?

A: Frequency synthesizer is defined as it is a electronic circuit which generates variable frequency to...

Q: A 400hp induction motor and a 400hp synchronous motor both are operating at 90% efficiency. The indu...

A: The solution is given below 

Q: QUESTION 6 A motor with 15mH of inductance and an unknown internal resistance is connected to a 50V ...

A:

Q: A PMMC instrument with a 200 turn coil has magnetic flux density in its air gaps of B=1.2T. The coil...

A: We are given: N= 200 turns, B= 1.2T, D= 2cm or r= 1cm, L= 2.5cm, I  =2mA.  We need to find Td.  

Q: UT001010, determine the equivalent binary Q.1 Answer the following questions. Clearly show your work...

A:

Q: Complete the pizza_calories_per_slice() function to compute the calories for a single slice of pizza...

A: 1. totalCalories= pizzaCalories(pizzaDiameter); Explanation: As mentioned in question pizzaCalories ...

Q: QUESTION 15 For the step down transformer below the turns ratio is 5: 1, the primary voltage is 122 ...

A:

Q: Q2 (a) Based on the relationship between the line and phase value of currents and voltage, show that...

A:

Q: 49. Which of the following is true for first-generation wireless systems? a) Low rate b) Efficient c...

A:

Q: In the unbalanced bridge circuit of the given figure, find the potential difference that exists acro...

A:

Q: Re olanie Figure 2.143 Problem 18 Figre 2.14 Pobem 19 10 Vo 18: Vo-

A: Based on the biasing of the diode the connection will change. The output voltage Vo is based on the ...

Q: In the unbalanced bridge circuit of the given figure, find the potential difference that exists acro...

A: Given: The unbalanced bridge circuit,

Q: Boolean Expression and don't care conditions are provided. Simplify F as a product of sums using k-m...

A: In this question we will simplify given boolean expression using k-Map...

Q: 3.8 Using nodal analysis, find v, in the circuit of Fig. 3.57. 6Ω 20 Ω 60 V 4Ω : 20 Ω Figure 3,57 +

A:

Q: сараcity, log2(SNR), each extra bps/Hz requires roughly a doubling of transmit power. A) Suggest a s...

A:

Q: (b) Figure Q3(b) shows a magnetic circuit with two different material, with a mean cross- sectional ...

A:

Q: An ac supply of 220 V is applied to a Half wave rectifier circuit through a transformer of turn rati...

A: Given,The AC supply voltage is,Vrms = 220VThe transformer turn ratio is,N1N2=10:1

Q: What is the error in the ammeter which reads 3.25A in a circuit having a series standard resistance ...

A: % error = Actual computation - meter readingActual computationX 100 %

Q: A voltage v (t) =141.4 sin (314 t+ 10°) is applied to a circuit and a steady current given by i (t) ...

A:

Q: 1. The voltage applied to a coil having R=200 2, L= 638 mH is represented by e= 20 sin 100 n t. Find...

A:

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.