3. For the following circuit find the value of I, and V +16 V Si • 4,7 ΚΩ -4V Si

Q: 8. A medium single phase transmission line 100km long has resistance/km 0.250, reactance/km 0.802,…

A: 8. Given Data: A medium transmission line with, Total Resistance R=0.25×100 ? Total reactance…

Q: What is the maximum resistance which can be made using five resistors each of 1/5 Q?

A: It is given that: R=15 Ω

Q: VIN ₂ VDD = 6V Ro=400€ YOUT k=3mA/V² V₂ = 1V 2 (a) Plot the vi characteristic for Vt <VGS <50 and 0…

A: The given circuit diagram is shown below, Here,k=3mA/V2.VT=1 V.

Q: Assuming a constant antenna size, how would the radar beamwidth change if the frequency increases…

A: In this question we need to choose a correct option

Q: v¡(t) I CCT1 R₁ R₁ CCT2 Li www 00000 L2 R₂ Rf OA1 OA2 R I I ip#, Vp#_ in#, Vn# Rd Ra CCT3 OA3 Ro +…

A:

Q: The switch in the circuit has been in position a for a long time. At t=0 the switch is moved to…

A:

Q: Problem 6: + | For the following network find, 뮤 I 20 105 T=

A: Given:

Q: vi(t) CCT1 R₁ R₁ CCT2 Li voooo = ooooo 0000 L2 R₂ Rf OA1 + OA2 R 1 I Rd Ra ip#, Vp#. in#, Vn# CCT3…

A:

Q: List the type of study to be undertaken in the design of hydropower scheme and indicate the…

A: Given: List the type of study to be undertaken in the design of hydropower scheme and indicate the…

Q: Q2\ A continuous-time linear control system is described below, where u, x. and y are the input, the…

A:

Q: The current in the circuit in (Figure 1) is known to be io 50e 8000 (cos 6000t + 2 sin 6000t) mA =…

A: Answer : given that  resistance R = 360 ohms current io = 50e-8000t(cos6000t+2 sin6000t)  mA to find…

Q: When a bipolar junction transistor, in common emitter configuration, is in the active mode, it can…

A:

Q: The aggregated supply and demand for a particular hour of a day-ahead market of a two-sided auction…

A: Given: Supply:           Cs=10+0.2V+0.3V2 Demand:         Cd=100-0.3V-0.02V2

Q: 3 5 How many degrees out of phase are the current and voltage in Question 2? 6 Refer to the formulas…

A:

Q: v¡(t) CCT1 R₁ R₁ = CCT2 Li ooooo L2 5 L₁ R2 R Rf 1 OA1 + + OA2 R ip#, Up# in#, Vn# Ra Rd CCT3 OA3 Ro…

A:

Q: If a potential difference of 2.15 volts is applied to an unknown resistance and the measured current…

A: We need to find out error for given resistance and current . The potential difference between two…

Q: use nodal analysis to solve the circuit and show that the power dissipated in the circuit is equal…

A:

Q: A 230 V DC Shunt motor runs at 700 r.p.m. and takes armature current of 40 A. Find resistance to be…

A:

Q: Assume the zener diodes are all ideal in the circuit below and let V1-3.7 V, R1-935 S2, R2=1,0472,…

A:

Q: Consider a system with a reference, disturbance, and noise inputs denoted as R(s), D(s), and N(s),…

A:

Q: 2. Determine the inverse Fourier transform of: a. X (ω) = 2πδ(ω) + πδ(ω – 4π) + πδ(ω + 4π) b. X₂(w)…

A: We need to find out the inverse Fourier transform of given signal.

Q: Refer to Figure 2. What is the voltage across R1? 3.375v none in the given choices 8.8125v O6.1875v

A: We need to find out Voltage across R1 .

Q: 5. For the circuit shown below, assume ideal Op-Amp and Vin = IV. Find the value of the current ix:…

A: We need to find out unknown current for given circuit.

Q: Find the Inverse Fourier Transform of the following functions: (a) F(x) (b) F(a) = = -2iw 3+4iw-w²…

A: In this question We need to determine the inverse Fourier transform of the given signals.  We are…

Q: I am confused on current drawn by R2, also power dissipated by R2

A:

Q: In differential amplifier differential gain is 20000 and CMRR is 80 dB. Find common-mode gain? (take…

A: It is given that: Ad=20000CMRR=80 dB

Q: 5.32. (a) Find the drain current for the transistor in Fig. P5.32 if λ = 0. (b) Repeat if λ = 0.05…

A:

Q: 120V E R₁ ww 4022 Ο Α) 13.3 Ω Q2 OB) 30 2 C) 17.1 Ω D) 50 22 www Calculate the Norton resistance in…

A:

Q: For the network, determine re for a voltage gain of Ay = -200.

A: The circuit diagram is given as  Given that , voltage gain is -200. We need to calculate the…

Q: Design a emitter bias circuit to get the Q point ICQ = 2.1 mA and VCEQ = 5V

A:

Q: Derive the stamps(modified nodal analysis) for the following circuit elements using minimum number…

A: The given circuit of the ideal transformer is shown below. It is asked to derive the stamps…

Q: 1. For the following circuit find the value of the current Ip, and the voltage V +8V 1.2kQ 4.7 k Si…

A:

Q: power delivered

A:

Q: If R1=60ohm and R2-15ohm in the circuit in the figure, what is the Vo/Vi gain? V₁ R2 ww R1 。Vo

A: Given circuit:   R1 = 60 ohm and R2 =  15 ohm Find   Vo/Vi ?

Q: Use mesh/loop analysis Given a = 2, b = 5, c = 2, d = 3, e = 4, f = 2 and x = 60, what is the phasor…

A: The given circuit diagram is shown below, Where,a=2,b=5,c=2,d=3,e=4,f=2,x=60.

Q: 14 200 ΩΣ 80 MF: 500

A: We need to find out current and voltage for given circuit.

Q: PRACTICE 10.11 Determine the admittance (in rectangular form) of (a) an impedance Z 1000+ j400 2:…

A: To determine the admittance (in rectangular form) of (a) an impedance Z =1000+ j400 Ω (b) a network…

Q: Here is the general instruction for your SA3 Submission. Generate the Truth table of the input and…

A: According to the question, For BCD to 5421 code and BCD to 2421 code, we need to find Generate the…

Q: 2) Draw a phasor diagram showing the supply voltage, the voltage across R, the voltage across L and…

A: In this question We need to draw the phasor diagram.  We know Current in the impedance Z, I= V/Z

Q: Determine the input and output impedances for the amplifier circuit below. Assume Q1) that…

A: Given data: AoL=100000 =105Zin=1 MΩZout=20 Ω Rf=80 kΩ Ri=80 kΩ To find out We have to determine the…

Q: For the operational amplifier circuit shown, the output saturation voltage are ±15 V. The upper and…

A: Given- An operational amplifier circuit- Output saturation voltage = ±15 V To Find- The values of…

Q: Q3. For the given continuous time Fourier transform, Y(w), find and draw y(t), using properties of…

A: We need to find out inverse Fourier transform of given signal.

Q: Find vo(t) in the circuit below, assuming vo(0) = 5V. 10 92 ww 10e ¹u(t) V (+ 10 Q2 www vo(1) 0.1 F…

A:

Q: 10 ΚΩ (a) Μ Ο 12. Using the superposition theorem, find the load current in each circuit of Figure…

A: Answer:  super position theorem “In any linear and bilateral network or circuit having multiple…

Q: Given v₁ (t) = 25cos (314.16t+25°) V and v₂(t) = 15sin(314.16€ +30°) V. (a) What is the frequency of…

A: In this question We need to determine the frequency of the signals.  We know period of the signs T=…

Q: A depletion mode MOSFET with room temperature parameters k = 4 mA/V^2 and V t = -3.1 V is connected…

A: The given MOSFET circuit diagram is shown below, Here,k=4mA/V2.VT=-3.1 V.ID=4.5 mA.VGS=-1.6 V.

Q: Calculate the I x current using the constant voltage model for the circuit in the figure. Calculate…

A:

Q: Consider the FET amplifier in the fig. for these V. = 2 V VGS = 1mA/V² = 4 V Find the current DC…

A: Given a FET amplifier with, Terminal voltage, Vt=2 V. Kn'ωL=1 mAV2. Gate to source voltage, VGS=4 V.

Q: A 230 V dc motor has an armature circuit resistance of 0.6 0. If the full load armature current is…

A: Given- Armature resistance, Ra = 0.6 Ω Full load Armature current, Iafl = 30 A No load Armature…

Q: 1. Find the maximum real power that can be transferred to an impedance ZL connected between…

A: Given circuit: To determine: The maximum real power that can be transferred to ZL