5. For the circuit shown below, assume ideal Op-Amp and Vin = IV. Find the value of the current ix: (a) -2.167 mA (b) 1.67 mA (c) 0.5 mA (d) - 1.67 mA (e) 1.167 mA Vin 2 ΚΩ ww +1₁ 10 ΚΩ ↓. 3 ΚΩ

Q: 2. Determine the total charge (a) on line 0<x<5m if p₁ = 10x³mC/m and (b) within the sphere r=3m if…

A: (a) line charge density ρL = 10x3 mC/m    Find Q  from 0 &lt; x &lt; 5. (b) Volume charge density…

Q: 3.) Find the frequency spectra of the signals below: x(t) a-) b.) -100 - 10 -50 -5 2 -5 X₂(t) 10 So…

A: Given Signals   To determine: Fourier transform of each of the signal

Q: a loss angle of Example 4.9 An 11 kV 50 Hz, single-phase cable has a diameter of 20 mm, and an…

A: It is given that: εr=2.4R=15r=10f=50 HzV=11 kVδ=0.031l=2.5 km

Q: Consider the given circuit under dc conditions, where R= 23 Q. 292 www 3 A www R + VC 2 F 592 iL 0.5…

A: The given circuit diagram is shown below, Where,R=23 Ω.

Q: The process of changing a half-wave or a full-wave rectified voltage to a constant dc voltage is…

A:

Q: Let S = Ena" where |a|<1. The value n=0 of a in the range 0<a<1, such that DU2290010 S = 2a is

A: It is given that: S=∑n=0∞nαnwhere,α&lt;1Also, S=2α                                  ...... 1

Q: 6. Find the s-domain expressions for the y-parameters of the two-port circuit shown below. 1F it 21…

A:

Q: In differential amplifier differential gain is 20000 and CMRR is 80 dB. Find common-mode gain? (take…

A: Given, A differential amplifier is having CMRR = 80 dB; Differential mode gain, ADM= 20,000; We need…

Q: Calculate the current through each resistor in the figure if each resistance R = 1.28 k and V = 12.0…

A:

Q: The three-phase average power rating of a mainframe computer is 19,374W. The three-phase line…

A: Given: The value of average power is P = 19374 W. The three-phase line voltage is VL= 296 V (rms).…

Q: 10. What is the total resistor equivalent of the circuit? Find the voltage across each resistor…

A:

Q: Calculate the Velocity of Propagation of a signal if it has anInductance of 0.75mH/meter and…

A: In this question We need to determine the Velocity of Propagation of a signal.  We know Velocity of…

Q: In the circuit shown below, the voltage VR equals to 30 V. The value of current i is V i 3Ω elle m…

A: Given- Voltage- VR=30 V To Find- The value of current.

Q: Question 1: Use Block Diagram Reduction Reduce the system shown in Figure to a single transfer…

A: In above block diagram we have to reduce it into the Transfer function T(S)=C(s)/R(s)  . This we…

Q: Q.12 In a two port network, Z₁₁ = 29, Z12 = Z21 = 592, The value of h₁2 is Z22=192 =1Ω

A: Given- A two port network- Z11=2 ΩZ12=Z21=5  ΩZ22=1  Ω To Find- The value of h12.

Q: What equation did you use to separate I1 and I2?

A: Given:

Q: Q.12 In a two port network, Z₁1 = 2 22, Z12 = Z21 = 5 S2, Z₂2 = 192 Ω The value of h₁2 is

A:

Q: v:(t)u(t) + R 00000 R с vo (t) See the dynamic RLC circuit shown above. It has a time dependent…

A:

Q: Problem 3 Find the Norton equivalent circuit for the circuit below at the terminal a-b.

A: The Norton's equivalent circuit can be obtained by calculating the short circuit current and the…

Q: Using iterative solution, find the first four output signal sample values for the following linear…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: An AC waveform completes one cycle in 0.8 ms what is the frequency of the waveform

A: Given: Time Period, T = 0.8ms, need to calculate the frequency

Q: Find I in the circuit below using loop analysis. 2 mA + V₂ ww 2 ΚΩ 51 ΚΩ 1 ΚΩ I +1 V.

A: We need to find out current for given circuit by using loop analysis .

Q: Question No.11 Save The insulation resistance of a piece of 10 km long single core underground cable…

A: Given: Length of cable, l1 = 10 km. Insulation resistance of the cable, R1=10 MΩ. When length of…

Q: For the circuit in Fig. 7.113, i, (t) = 5u (t). Find v (t).

A: The required parameters can be calculated by analysing the circuit at t less than 0 and time t at…

Q: A graded indexed optical fiber has a parabolic refractive index profile (a = 2). If the fiber has a…

A: Given: Parabolic refractive index profile α=2,Numerical Aperture=0.22,Wavelength=1310 nm. Required:…

Q: At inversion,

A:

Q: Learning Goal: Consider the circuit in the diagram, containing two identical. resistors, RA and Rn,…

A:

Q: 1. Design CMOS circuit for F = (AB) + C + D using PUN and PDN. Do not simplify the function.

A: Since you have posted the multiple questions so we are supposed to answer 1st one.

Q: For the circuit shown find the impedance phase angle Z (in degrees) i = 0.02 sin(157t +40) V=2547.4…

A: In this question We need to find out the phase of impedance. We know Impedance Z= V/I

Q: How many H must the inductance L be for the reactive power to be zero in 1 the circuit in the…

A: Given data, Circuit diagram is given as,

Q: In a Young's interference experiment, the distance between two slits is 0.5 mm and a perpendicular…

A: Given,In a young's interference experiment,Distance between two slits, d=0.5mm.Perticular distance,…

Q: Match Current (Torque) Control with Improper Pole-Zero Cancelation case to the resulting impact on…

A:

Q: When a bipolar junction transistor, in common emitter configuration, is in the active mode, it can…

A:

Q: 14 A high-reflectance stack of alternating high-low index lay- ers is produced to operate at 2 um in…

A: To calculate the reflectance produced by a high-reflectance stack of alternating high-low index…

Q: For the circuit shown below, find and io, vo and i for all time, assuming that the switch was open…

A:

Q: 2. A load draws 10 A from a 120-V line at a power factor of 0.8 lagging. a) Draw the power triangle;…

A: 2. Answer: given that   load draws  10 A current at  0.8 lagging power factor  voltage from the…

Q: V, (+) V2 (+) Rd Rd www Ro Ro + What kind hats the Volt) is this of configuration input-output…

A:

Q: A 50-KVA, 13,800/208-V Delta-Star distribution transformer has a resistance of 1 percent and a…

A: In this question we need to find the voltage regulation of the given transformer.

Q: VI R ww www R VB D₁ D₂ ww R www R Vo

A: Given Circuit: Given data: VB=1 V Ideal diodes To determine: Relation between input and output…

Q: Opamp is 741 with Vcc = 15V and VEE = -15V Calculate the pulse width T of the circuit. Plot Vo

A:

Q: 1. Answer the following questions: a) F (w, x, y, z) = (1, 3, 7, 11, 15); which has the don't-care…

A: it is asked to solve given logical function and to express given function as sum of min terms

Q: Using the current divider rule, find the unknown currents for the networks below. 6A 8 Ω 8 Ω 6Ω 6Ω 4…

A: We need to find out the current for given circuit.

Q: 2. Estimate the gate capacitance of PMOS transistor (W = 0.36u, L = 0.18u). Gate oxide thickness is…

A:

Q: How could I get the thevnin voltage from this using the transfer funciton and the lookback method?

A: Given: Required: How to get Thevenin's voltage by using the transfer function and the lookback…

Q: Ⓒet R₁ M e(t) C + (3c) e(t) roo + ec L iz R₂

A:

Q: Problem 6. Find vo(t) for t> 0 in the network shown. 3 ΚΩ Χ 1 = 0 3 ΚΩ 4V(X, ΚΩ 200 MF 2 ΚΩ + Ult

A: In this question We need to determine the voltage Vo  for the t&gt;0. We know Capacitor act as open…

Q: Find all the prime implicants and essential prime implicants from the K-map below. be Prime…

A: We need to find out the prime implicants and essential prime implicants.

Q: Three similar coils are connected in star taken at a total power of 1.5KW at a P.F of 0.2 lagging…

A: Given data, Line voltage VL=400 V. Power P = 1.5 KW. Power factor cosϕ=0.2 ( lagging ). Frequency f…

Q: A battery with & = 7.00 V and no internal resistance supplies current to the circuit shown in the…

A: The required resistor value can be calculated by applying kirchhoff's voltage law to the circuit at…

Q: Draw the phasor diagram of an induction motor showing applied voltage magnetizing.core loss, load…

A: To draw the phasor diagram of an induction motor showing applied voltage magnetizing.core loss, load…

Differential amplifier

There are two amplifying stages with common degeneration in a differential amplifier.