3. Given below is the technical description of Lot 2081, Cebu Cadastre. N Show your complete solution. DISTANCES (m) 22.04 LINES BEARING S 32° 17' W N 36° 25' W N 15° 47 W N 73° 07' E 1-2 2-3 10.00 3-4 4-1 5.00 19.95

3. Given below is the technical description of Lot 2081, Cebu Cadastre. N Show your complete solution. DISTANCES (m) 22.04 LINES BEARING S 32° 17' W N 36° 25' W N 15° 47 W N 73° 07' E 1-2 2-3 10.00 3-4 4-1 5.00 19.95

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Fill in the blank

A: In geodetic survey the surface of earth is considered to be curved . This type of survey is very…

Q: Whatis he length of a 2 ine given a scale of 1:40?

A: Given: The measured length of the line is 2”. The scale is 1:40.

Q: How many "varas" are there in a single ruler measurement?

A: A single ruler is the standard ruler which has measurements given in inches or mm. It is used to…

Q: Define Bearings?

A: Bearing: It is defined as the angle which is measured between the reference meridian and the survey…

Q: A plan drawn to a scale of 1:2500 was measured by mistake by a scale of 1:3000. What are the…

Q: Define The required diameter

A: A diameter is a chord that runs through centre point of circle. The centre of circle is at midpoint…

Q: The term *blank* refers to included measurements and *blank* refers to the boundaries identified in…

A: ASKED: To choose the correct option to complete the given statement. Given statement: The term…

Q: a. Differentiate between following term:- a)Base line and a check line b) Main station and Tie…

A: Since we answer one question at a time so we will answer the first one. Please resubmit the another…

Q: Given below is the technical description of a lot 2081, Cebu Cadastre. Bearings S 32°17' W S 36°25'…

Q: 2.107 How many bridge hands are possible contain- ing 4 spades, 6 diamonds, 1 club, and 2 hearts?

A: Given, number of spades =4 number of diamonds =6 number of club =1 number of hearts =2 Total cards =…

Q: Define Peclet number.

A: It is defined as the ratio of the rate of advection of a physical quantity by the flow to the rate…

Q: The areas in cut of two irregular sections 45 m apart are 44 m^2 and 66 m^2 respectively. The base…

A: Given values: Area of 1st cut, A1 = 44 m2 Area of 2nd cut, A2 = 66 m2 Distance between the cuts, L =…

Q: An area was measured on the plan by a rule as 250×175mm.calculate the ground area in square metres…

Q: An area was measured on a plan by a rule as 250 by 175mm. Calculate the ground area in square meters…

A: Given that: Area measured on plan, A = 250x175mmScale is: (a)1:2000 (b)1:500

Q: The scale of a plan is 1:4. If a square on the plan measures 3 by 3units. What is the corresponding…

A: Scale of a plan=14=length on plan length on groundand side of square at plan = 3 unitsArea of…

Q: Last two digit 30

A: yn=1m R=yn=1m ( for wide rectangular channel)

Q: 10 divisions of vernier scale are equal to 11 divisions of a main scale of each 0.1 mm. What is the…

A: Given data- 10 divisions of vernier scale=11 divisions of main scalemain scale one division=0.1 mmTo…

Q: Given the technical description of a triangular lot. Compute the area and perimeter of the lot. LINE…

A: we can find the area of a lot by DMD method and DPD method . I have find this area of lot by DMD…

Q: A scale of a plan is 1:200.The distance between two points x and y on the plan measures 435mm.…

Q: what is the usual drawing paper size in preparing a lot plan ?

A: The drawing sizes for the construction plans will come in the different formats — with 18” x 24” and…

Q: Define Anchorage

A: The constructions made up of steel as a construction material requires connects of nuts and bolts to…

Q: What exactly is a CompactFlash (CF) card?

A: A Compact Flash card (CF card) is a memory card format that was developed by SanDisk company in the…

Q: You must lay out a rectangular commercial building 96.50 ft wide and 178.00 ft long. If the steel…

Q: surveying

A: Given I=30020'(a)Length =PT-PC=(1450.4)-(1260.5)=190Length=L=πRI180190=π(R)(30°20')180R=358.885Given…

Q: some examples of the term OFFSET

Q: What is sumps?

A: Sump collects building up underground water so that it can be pumped aside from a finished building…

Q: Calculate cost of premium. Rating of Area: 1 Class: A Building: $90,000 Contents: $30,000

Q: answer

Q: Road construction specifications

A: The asphalt is in road construction, wherever it is used as the glue or binder mixed with…

Q: Define and Explain what is Gardner and Windsor Equation. Show illustration

A: Gardner and Windsor Equation

Q: Creates a leader and annotation O DIMLINEAR МТЕXT O MLEADER O QLEADER

A: QLEADER- It creates a leader and leader annotation.

Q: what is the value of the back bearing 50° 25' 20

A: Back Bearing (B.B)- Back bearing is the bearing of the line in the…

Q: Find All dimensions are in inches. Round answer to the nearest second 2.250 2.601 4.059

Q: Determine the number of linear feet needed for the shoe and double top plates for the building plans…

A: For plan 1 Total area of wall = (53 x 30) = 1590 ft2 For one shack and double top plates…

Q: Complete the partial multiviews provided belew, by filing in the miosing lines. NOTE: Missing lines…

A: given,

Q: what are the costs of plot maintenance?

A: Maintenance of plot is an important work in any society there are various cost to maintain the plot,…

Q: A contractor is to construct a tank to contain water for his construction project, given that the…

A: Given data: The tank height (h) = 2.4m…

Q: 2ft

A: Given Triangle of height 2ft Slope : 3H to 4V

Q: Determine the Departure Misclosure and Latitude Misclosure for the four sided parcel shown below.…

Q: 1. A contractor is to construct a tank to contain water for his construction project, given that the…

A: Given:- The height of the tank = 2.40 m The diameter of the tank = 2.80 m The dimensions of the GI…

Q: 17. Given below is the technical description of a lot 2081, Cebu Cadastre. Bearings S 32°17' W S…

A: Latitude and Departure of line 5-1 will be calculated by using the sum of latitudes = 0 and sum of…

Q: CALCULATE THE GROSS FLOOR AREA OF THE BUILDING

Q: 200 mm Figure ?

Q: I don't know how to set up my diagrams for this figures, it is confusing.

A: FBD of the wall section is shown below:

Q: SHOW SOLUTION AND DRAWING LABEL THE POINTS ACCORDINGLY

A: I have drawn a rough sketch, not to scale as in image scale won't be determined. Sufficient data to…

Q: Practice Problem No. 6 Roll bearings around the parcel shown below. Provide all checks. Note that…

A: Solution:- The given figure is shown below,

Concept explainers

Traverse Survey

Traverse surveying is a popular method of surveying. Traversing is that type of survey where several connected survey lines form a framework and the directions and lengths of the survey lines are measured with the help of a tool to measure angles and tape or chain respectively. Traverse networks involve placing survey stations in a queue or trail and using pre-tested points as a basis for looking at the next point. This type of surveying is different from Tacheometric surveying, where only angles are measured and the process of chaining is reduced.

Question

a) Plot the closed traverse based on the observed data.

3. Given below is the technical description of Lot 2081, Cebu Cadastre. N
Show your complete solution.
DISTANCES (m)
22.04
BEARING
S 32° 17' W
N 36° 25' W
N 15° 47 W
N 73° 07' E
LINES
1-2
2-3
10.00
3-4
4-1
5.00
19.95

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A triangle has an area of 14 sq ft and a base of 7 feet. What is the height of thetriangle?
1) An area measured on a plane by a ruler as ABCmm and EFG mm. Calculate the ground area in m2, if the scale is 1:500 2) An area AD,BCE cm2 was measured on a plan using the planimeter. Given that the scale 1:250, calculate the ground area in hectares 3) what is misclosure?
Do it in 10 minues.
Plot the Project Lot Area as per the Technical Description given below: Technical Description: STATION BEARING DISTANCE POINT 1 TO 2 S. 30° 09' W. 177.44 M. POINT 2 TO 3 N. 41° 47' W. 40.00 M. POINT 3 TO 4 N. 29° 43' E. 165.11 M. POINT 4 TO 1 S. 59° 45' E. 40.00 M.
1. What is the Total Lot Area (TLA) of the Lot in square meters? Dimension in drawings are in millimetres mm. 2. What is the Length of Perimeter Line 1-2 in meters? 3. What is the Length of Perimeter Line 2-3 in meters? 4. What is the Length of Perimeter Line 3-4 in meters? 5. What is the Length of Perimeter Line 4-5 in meters?
13. _________ is the process to determine the overall cost of project’s construction. Fill in the blank
hello put 58 in registration number
Question 8 is attached.
Don't copy from Google. What are the relationship of the Kings Road House (MAK Center)?
5 decimal places, no shortcut
Compute the area in acres of triangular lots shown on a plat having the followingrecorded right-angle sides:(a) 208.94 ft and 232.65 ft (b) 9 ch 25 lk and 6 ch 16 lk
Please show final answer in 3 decimal places thank youDetermine the length of course ABDetermine the length of course CD Determine also the lot perimeter and Determine the lot area using DMD