Answered: 3. In a R-C parallel circuit, total…

Engineering

Electrical Engineering

3. In a R-C parallel circuit, total current is out of phase with the applied voltage. True False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.5MCQ

See similar textbooks

Related questions

Q: In a star 3 phase connection circuit, the phase current is equal to its line current. Select one:…

A: For a star connected circuit, the current IL=Iph i.e. Phase current is equal to line current.

Q: Q8. In symmetrical fault analysis, network impedances are governed by Transmission line impedances O…

A: Here it is given that in symmetrical fault analysis the network impedance is governed by what

Q: 2. Three equal impedances are connected in star across a balanced 3-phase supply, if connected in…

Q: A 112.5 kVA three phase transfer my head is secondary voltage to 480 V any percent piece of 4.1%…

A: For the Given 3 phase transformer whose kVA = 112.5 kVA V sec = 480 V %Z = 4.1% Short circuit…

Q: In a star connected system, the three phase currents are mutually displaced by 120 degree. Select…

A: In star connected systems each phase is differ by 120 degrees apart. Ex: Phase A current : Ia= Ia at…

Q: In a 390V, 57 Hz, three phase system, the value of the reactive power without capacitor bank is…

A: Given in the question: The system voltage is: V = 390V The system frequency is, F = 57Hz The…

Q: Impedance, inductance, and reactance are all measured using ohms. a) True b) False

A: IMPEDANCE-Impedance is a combinational of resistance and reactance.It is a measure of the ability…

Q: Write short notes on the following : (1) Distribution transformers. (2) 3-wire d.c. distribution.…

A: Terms Distribution transformers. 3-wire d.c. distribution. Primary distribution are related to the…

Q: In a delta connected system, the three phase currents are mutually displaced by 120 degree. Select…

A: In the question, Consider the delta connected system, Are the three phase currents mutually…

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

Q: 13. In parallel-connected ac circuit, the total current though the circuit is always equal to the…

A: According to the question we have to discuss the given statements are ture or false. 13. In…

Q: The balanced system below has a phase voltage of 120 V. It supplies a balanced load coil that is…

A: Given: V=120VR=3ΩL=.011HLet…

Q: Calculate the total complex impedance seen by the open terminals of the circuit below.

Q: phase impedance of the load is ( 3+j6) Ω, connected a cross a 200V, 50Hz mains in parallel with…

A: In this question we will find admittance , conductance , susceptance...

Q: The wire that carries current to equipment is called Phase wire. Select one: True False

A: There is two wire which carry current- 1.Live wire(Phase wire) 2.Neutral wire.

Q: "In a R-L series circuit, applied voltage is in phase with the total current." True False "In…

A: 1. impedance of RL circuit is R+jXL So, impedance angle ∅ = tan-1WLR So, current in Rl circuit…

Q: . A three-phase overhead transmission line is being supported by three-disc suspension insulators;…

Q: 22 (a) Three-phase generator consist of three set of single-phase generators, with voltages equal in…

Q: In a balanced delta connected 3-phase circuit, has resistance 16 ohm and inductive reactance 12 ohm,…

A: Given data, 3-phase, 230V, 50Hz supply voltage resistance = 16 ohm inductive reactance = 12 ohm

Q: In a star connected system, the three phase currents are mutually displaced by 120 degree. Select…

A: STAR-CONNECTION: The diagram below depicts a three-phase, wye or star connected system with balanced…

Q: Compute the angle of the voltage in units of degrees (enter value only, not units) for a componet…

Q: 2. (A) In a 440 V, 3-phase balanced AC-system, a wattmeter is connected as follows: curren- coil(CC)…

A: The solution is given below

Q: The real power consumed by a single phase pure capacitive load is equal to zero. Select one: O True…

A: In a purely inductive or a purely capacitive circuit that contains reactance, (X) the current will…

Q: 44) When doing delta-to-wye conversions A) if the resistances are equal in one configuration, then…

A: From the delta star conversion formulas decide which statement is correct.

Q: In a star 3 phase connection circuit, the phase current is equal to its line current. Select one: O…

A: Star Connection: This system is also known as Three Phase Four Wire System (3-Phase 4 Wire). This…

Q: 50. In AC circuit, Ohm's law proves that the phasor current though an element is equal to the ratio…

Q: The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical…

A: Given: Load-1:P1=950Wcosϕ1=0.5 LaggingLoad-2:P2=1.14Wcosϕ2=1Load-3:P3=760Wcosϕ3=0.5 leadingline…

Q: In a 3-phase star connected system, prove that VL = Vph by considering the line voltage (VYB = VY…

A: In cas of star connection Line voltage = √3 × Phase voltage

Q: Each phase of a star connected load consists of a resistance of 100 2 in parallel with a capacitance…

Q: 14. A single-phase AC supply has ac mains voltage of 230 V at 50Hz and feeder (source) impedance of…

Q: certain three phase star connected load draws a line current of 100 A when a 3-ph voltage of 400 V…

A: In this question , we will find power factor of load and reactive lower consumed by load..

Q: An acb sequence balanced three-phase Y-connected source supplies power to a balanced, three-phase…

A: Given data, Voltage source of phase b sequence is V=240∠-450 Voltage of phase a lags the voltage of…

Q: |Q8. In symmetrical fault analysis, network impedances are governed by Transmission line impedances…

A: in symmetrical fault, we do not consider ground resistance.

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A: Since you have asked only for (ii) so I have posted solution only for (ii) . This question belongs…

Q: 12.57 Determine the line currents of the three-phase circuit in the figure. /-120°, V. = 110/120° V.…

A: The solution can be achieved as follows.

Q: In a star connected system, the three phase currents are mutually displaced by 180 degree. Select…

A: Three phase Star connected system

Q: In three phase star connected system, the phase voltage is equal to line voltage. Select one: True…

A: In three phase star connected system, the phase voltage Vph= ( line voltage)VL)/√3 But the phase…

Q: In a R-C parallel circuit, total current is out of phase with the applied voltage." True False…

A: Question 1 & question 2 both are same

Q: In a balanced delta connected 3-phase circuit, has resistance 25 ohm and inductive reactance 40 ohm,…

A: The total power delivered to lad will be both real and reactive power (since there is an inductive…

Q: The resistor, inductor and capacitor are connected in the parallel in each phase of star connected…

A: R=100 ohmL=1 HC=100Ff=50 HzVL=400 V

Q: 1. In a 3-phase overhead system, each line is suspended by a string of 3 insulators. The voltage…

A: Using relation between voltages across the units we will find ratio of capacitance. string…

Q: 1. Draw a phasor diagram depicting the relation between 50 Hz voltages in the phase domain to…

Q: In a 3-phase delta connected system, prove that IL =V3 Iph by considering the line current (I1 = IR…

A: In this question we need to prove that for delta connected system, IL=√3 Iph

Q: Calculate the total power factor,

Q: 10. In a R-L series circuit, total current lags behind the applied voltage. True False 11. In…

Q: 3. For the transformer circuit shown below having a load of X₁ = 16 ohms: (a) Determine the total…

A: Solution

Q: A 3-phase, 20 MVA, 10 kV alternator has internal reactance of 5% and negligi resistance. Find the…

Q: and inductance of 100mH is connected in a star with a 3-phase supply. The frequency is 50 Hz. Line…

A: The star connected load may have three wire or may have four wire as one wire is neutral. The…

Question

3. In a R-C parallel circuit, total current is out of phase with the applied voltage.

True

False

5. In a R-C series circuit, total current is out of phase with the applied voltage.

True

False

6. In series-connected ac circuit, the value of the equivalent admittance of the circuit is equal to the reciprocal of phasor sum of the reciprocal of the individual admittances.

True

False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
A single-phase source has a terminal voltage V=1200volts and a currentI=1530, which leaves the positive terminal of the source. Determine the real and reactive power and state whether the source is delivering or absorbing each.
For the single-phase circuit shown in Figure 122,I=100A. (a) Compute the phasors I1,I2, (b) Draw a phasor diagram showing I,I1,I2, and V
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Sketch the phasor diagram of the above circuit in terms of impedance, voltage, and the power triangle.
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
In parallel-connected ac circuit, the value of the equivalent admittance of the circuit is equal to the phasor sum of the individual admittances True or false
10. In a R-L series circuit, total current lags behind the applied voltage. True False 11. In parallel-connected ac circuit, the value of the equivalent impdance of the circuit is equal to the phasor sum of the reciprocal of the individual impedances. True False 12. In a R-C series circuit, R=10 ohms and Xc=10 ohms, the applied voltage is leading to the circuit total current by 45 degrees (assumed applied voltage is the reference). True False
A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a capacitor. At 60Hz, the resistance is 5 ohms, the inductive reactance is 3 ohms, and the capacitive reactance is 4 ohms. Compute: (a)load impedance at 60Hz (b) value of the capacitance and inductance Explain each step. Please recheck
Derive the equation for impedance and phase shift for series RLC circuit connected to the AC supply.Also draw an impedance triangle and voltage triangle.
In a R-C parallel circuit, total current is out of phase with the applied voltage." True False In a R-C parallel circuit, total current is out of phase with the applied voltage." True False In parallel-connected ac circuit, the value of the equivalent admittance of the circuit is equal to the phasor sum of the reciprocal of the individual admittances. " True False