Answered: 3. Neglecting losses, find the…

3. Neglecting losses, find the discharge in gallon per minute through the venturimeter as shown below. Air 250 mm Water 150 mm diam (2) 300 mm diam

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Design girts in an industrial building for the following data Height of columns c/c Spacing of…

Q: In a series parallel pipe connections, pipe 1, 3, and 5 are in series while pipes 2, 3 and 4 are…

Q: Determine the allowable load capacity of the 0.4 m diameter pile shown in Figure 4. The fill is new…

Q: A symmetrical parabolic curve passes through point A whose elevation is 23.23m at a distance of 54…

Q: An aluminum pipe with a length of 60 m at a temperature of 10°C rests freely on the ground. An…

A: Thermal stress In mechanics and thermodynamics, thermal stress is mechanical stress induced by a…

Q: Find Potondial eneryy mls

Q: Q1 The cantilever beam shown below, supports a concentrated load of 4 kN, a concentrated moment of 2…

Q: What is the degree of curve at moment AB?

A: We will find reaction first.

Q: Also called as cost - benefit ratio Income Return Ratio Profitability Index

A: Answer - Profitability Index Option b

Q: A granular soil deposit is considered stiff if the unconfined compressive strength is between. 25-80…

A: LIES BETWEEN (150-400) KN/M^2

Q: For a case of plane stress, o. = 40 MN/m², Oy = 0, Ty = 80 MN/m2. What are the principal xy %3D…

Q: vay tm= 2.5 seconds (gap) in sQ = 200 vehicles per hour,

Q: Given the beam loaded as shown. 60 KN 3 m 50 kN/m 10 kN-m A D 1m 5m

A: GIVEN: TO CALCULATE: Maximum value of shear force (in KN) CONCEPT: • use Equilibrium Equation. •…

Q: 60 KN 3 m 50 kN/m 10 kN-m A 1 m 5 m

A: Given data:

Q: Define tack coat, concrete slab, plate bearing test, California design method, flexible pavements,…

A: There are different type of coating used in thr construction of the pavements. There are different…

Q: The flow from A to E is 0.280 cum/sec. Using n = 0.058 Pipe 1 (Diameter and Length): 450 mm, 300 m…

A: Assuming n as 4f n = 0.058 = 4f Total head loss From A to D is = 165.861 meters

Q: Find Potontiae eneryy mıs-

A: Given data, Height (H) = 3 m Mass (M) = 3 kg Acceleration due to gravity (g )= 10 m/s² To find…

Q: A 6 m x 9 m rectangular footing xarrying a uniform of 288 kPa is applied to the ground surface..…

A: Given: A 6 m x 9 m rectangular footing carrying a uniform of 288 kPa is applied to the ground…

Q: A rigid pavement is to be design for a wheel load of 50kN. If the tensile strength of the concrete…

A: Given, Wheel load (W) =50 kN or 50,000 N f'c = 21 MPa Tensile strength (σ) = 0.7 f'c

Q: sample of sand, 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a…

A: given data : diameter (d) = 5cm/2 = 0.25 cm length (l) = 15 cm = 0.75 m porosity = 60% height (h) =…

Q: Find the displacemnt value if work done is equal to 120 j and force applied on object 40 N

Q: A continuous beam ABC has fixed supports at A and C and a roller support at B. Assuming constant…

Q: 60 KN 3 m 50 kN/m 10 kN-m A B 1m 5 m

Q: A deposit of cohesionless soil with a permeability of 0.3 mm/s has a depth of 12 m with impervious…

A: Flow Net: The graphical representation of the flow of water through the soil mass is known as Flow…

Q: Given the tabulated measurement of a closed traverse with unknown length and azimuth of line DE,…

Q: Example: The beam is subjected to the concentrated loading shown. Determine the reactions of the…

Q: Soil shall be considered expansive if Plasticity Index (PI) is 10 15 12

A: More plasticity index means soil have high potential of shrinkage and swelling tedency and causing…

Q: В L A 40° 30°

Q: An aluminum pipe with a length of 60 m at a temperature of 10°C rests freely on the ground. An…

A: Given, αa = 23 x 10-6/C αs = 12 x 10-6/C

Q: Provide complete solution and illustration. The bearings of backward and forward tangents are S…

A: As per company policy, we are supposed to answer the first three questions of multiple subparts…

Q: An excavation is to be performed in a stratum of clay, 9 m thick, underlain by a bed of sand. In a…

Q: A bolted lap joint is shown in the figure. The bolts are 19mm in diameter. Effective diameter of the…

A: Answer we are given bolt diameter = 19 mm Effective diameter of holes = 23 mm Plate thickness = 12…

Q: For a roof truss system of an industrial building, following data is given Span of truss = 6m…

Q: Find the displacemnt value if work done is equal to 120 j and force applied on object 40 N

Q: E = 207GA Poisson's 12kN/m CROSS-SEcnON OF BEAM 4okN OKN rafio:03 C 14.27KN 10. 36KN 51-37 kN O. Im

A: Given data: b=0.1 m d=0.3 m E=207 GPa

Q: A 6 m x 9 m rectangular footing xarrying a uniform of 288 kPa is applied to the ground surface..…

A: ASKED: To determine the total vertical stress below the center of the rectangular footing at the…

Q: A wall footing 1 m wide carries a uniform load of 300 kN/m of wall length. Soil weights 16…

A: ASKED: To determine the total increment in load at the edge of a wall footing at given depth.…

Q: For a reservoir having fetch of 36 km and wind velocity of 16 km/hr, the height of wave from top of…

A: given- reservoir area F=36 kmwind velocity V=16 km/hr

Q: In a framed connection an 1.S.L.B. 350 @ 485.6 N/m transmits an end reactiorn of 1Ju KIN and a…

Q: SITUATION: A footing, 2 m x 3 m in plan and 0.50 m thick, is designed to support a 0.60 m square…

Q: A homogeneous earth dam has a top width of 6 m and a height of 42 m with side slopes of 3 to 1 and 4…

A: Answer We are given Top width = 6 m Height = 42 m free board = 2 m Upstream Side slope 3 to 1…

Q: 15 A uniform T-shaped arm of weight W, pinned about a horizontal point C, is supported by a vertical…

Q: In a falling head permeability test, head causing flow was initially 50 cm and it drops 2 cm in 5…

Q: Capillary rise in a small tube is due to. cohesion adhesion both A and B neither A and B

A: Question is related to capillary action in small diameter tube.

Q: A vertical triangular plane area, submerged in water, with one side in the free surface, vertex…

Q: No. 3. Derive the formula for the maximum (+/-) shear and maximum (+/-) bending moment of the simple…

A: Applying Equilibrium equation to obtain Reaction at the support. As we assume a is more than b in…

Q: How many liters of water must be evaporated from 132 liters of a 25% salt solution to p a solution…

A: Given data- Total volume = 132 L Salt present = 25% % of salt = 40%

Q: The soil profile for a future building construction site is shown in the following figure. The…

Q: Example: The beam is subjected to the concentrated loading shown. Determine the reactions of the…

Q: A .05kg bullet is moving to the right with a speed of 450 m/s when it strikes a 20 kg box that is…

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

3. Neglecting losses, find the discharge in gallon per
minute through the venturimeter as shown below.
Air
250 mm
Water
1)
150 mm diam
2
300 mm diam

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Given Data

VIEW

Discharge through Venturi meter

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate length of the pipe required to bring down the concentration of chlorine from 6x105 CFU/L to the permissible value of 2500 CFU/L. It is given that the velocity of flow through the pipe is 0.7 m/s and the rate constant is 0.25 per min.
Calculate length of the pipe required to bring down the concentration of chlorine from 6x105 CFU/L to the permissible value of 2500 CFU/L. It is given that the velocity of flow through the pipe is 0.7 m/s and the rate constant is 0.25.
Water leaks from a cylinder with axis vertical through a small orifice in its base at a rate proportional to the square root of the volume remaining any time. If the cylinder contains 64 gal. initially and 15 gal. leak out the first day, when will 25 gal. remains? How much will remain at the end of 4 days?Ans. 3 days, 16 gal.
Calculate the volume flow rate of the water in m^3/s. * Show complete soln. Round off ONLY the final result to three decimal places as applicable. Indicate an appropriate unit for each of your final answers
A flow meter reads 23532 gal on June 1 and 6040872 gal on July 1. What is the average daily flow in gallons per day? (30 days = 1 month)
In a test to determine the discharge coefficient of a 50 mm by 12.5 mm Venturi meter the total weight of water passing through the meter in 5.0 minutes was 3420 N. A mercury-water differential gage connected to the inlet and throat of the meter showed an average difference during that time of 38 cm. Determine the meter coefficient. Assume your own meter fluid-specific gravity. Draw and label the diagram:
Calculate the discharge in liters per second thru a 100-mm diameter orifice under a head of 5.5 of water. Assume Cc=0.61 and Cv=0.98
Need asap. Please put explanation and be clear with your solution. Thank you. Answer on the book: 51 liters/s, 76 s. Problem:In Fig. H is shown a tank 1.5 m by 1.5 m horizontal section and 3 m high with two orifices (C=0.60) both 10 cm in diameter and 60 cm apart. (a) How much water must be supplied to the tank to keep it always full? (b) If this supply is cut off, how long will it take the water surface to lower 1.20 m?
2. The flow rate into a water tank is 25 m3/s. The outflow rate is 15 m3/s. The tank has a capacity of 5600 m3. How long would it take to fully fill up the tank? How much water would have been evacuated over that period? Also, calculate the time for 2/3 of full tank.
a circular orifice is located 5m below the water surface. if the tank is large and the diameter of the orifice is 5mm, calculate the discharge in cubic meters oer second if the coefficient of discharge is 0.60. a. 0.00012 b. 0.00812 c. 0.00140 d. none
PLEASE PUT ALL THE DECIMAL PLACES. THANK YOU The average hourly water consumption per person is 2.5 Liters anf there are 264 people in the area. Determine the following. a. the minimum rate of flow in L/s in the spring b. Total Daily water demand in L/day c. The daily yield is sufficient to the water demand of the community if the rate of flow is 0.182 L/s d. the height of the cylinder in cm thatt the minimum discharge can fill within 300 secs. diameter of the cylinder is 10 cm.
Determine the rate of flow of water through a pipe of diameter 10 cm and length 60 cm when one end of the pipe is connected to a tank and other end of the pipe is open to the atmosphere. The height of water in the tank from the centre of the pipe is 5 cm. Pipe is given as horizontal and value of f= 0.01. Consider minor losses.