3. Radiation Intensity (U) Example: The power radiated by a lossless antenna is 10 watts. The directional characteristics of the antenna are represented by the radiation intensity of a) U = Bocos² (0) b) U = Bocos³ (8) For each, find the maximum power density (in watts/square meter) at a distance of 1m?

3. Radiation Intensity (U) Example: The power radiated by a lossless antenna is 10 watts. The directional characteristics of the antenna are represented by the radiation intensity of a) U = Bocos² (0) b) U = Bocos³ (8) For each, find the maximum power density (in watts/square meter) at a distance of 1m?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The normalized radiation intensity of a given antenna is given by(a) U = sin θ sin φ (b) U = sin θ sin2 φ(c) U = sin θ sin3 φ (d) U = sin2 θ sin φ(e) U = sin2 θ sin2 φ (f) U = sin2 θ sin3 φThe intensity exists only in the 0 ≤ θ ≤ π, 0 ≤ φ ≤ π region, and it is zeroelsewhere. Find the(a) exact directivity (dimensionless and in dB).(b) azimuthal and elevation plane half-power beamwidths (in degree
For an Omni-directional antenna, the measurements show the Half Power Beam Width (HPBW) in vertical and horizontal planes are 30 degree and 20 degree respectively. If this antenna has a loss resistance of 25ohm and efficiency n=0.8, calculate:i. Antenna’s gain in dB;ii. Radiation resistanceiii. How the efficiency of this antenna can be improved? Support your answer with applicable equations and results.
The radial component of the radiated power density of an infinitesimal linear dipole of length is given by Wav=ar Wr =arAmsin2(theta)/r2 W/m2 Where Am = Peak value of power density; theta = usual spherical co-ordinate and ar = radial unit vector. Calculate the directivity of the antenna.
An electric ﬁeld strength of 10 µV/m is to be measured at an observation point θ = π/2, 500 km from a half-wave dipole antenna operating in air at 50 MHz. (a) What is the length of the dipole (b) Calculate the current that must be fed to the antenna (c) Find the average power radiated by the antenna (d) If a transmission line with Z0 = 75 ohm is connected to the antenna, determine the Γ and SWR.
Q. Calculate the radiation resistance of a short dipole (with a triangular current distribution) of length 0.3 m operating at 100 MHz. If the total resistance of the antenna is 2.2 Ω, calculate the maximum effective area and the radiation efficiency of the dipole. Calculate the open circuit voltage induced at the terminals of the dipole if it is oriented along the z - direction and the incident electric field at the dipole is Ei = (ax 4 + ay 3 + az 5) V/m.
A screen, having a Screening Effectiveness (S) of 31.62 at 100 MHz, is located 5 m from a 2 cm radius conductor loop that carries a signal current of 7.5 mA at a frequency of 100 MHz. Determine the maximum electric field strength transmittedthrough the screen (Et, µVm-1) resulting from radiated emissions emanating from the conductor loop.
A λ / 2 dipole , with a total loss resistance of 1 ohm , is connected to a generator whose internal impedance is 50+ j25 ohms . Assuming that the peak voltage of the generator is 2 V and the impedance of the dipole , excluding the loss resistance , is 73+ j42.5 ohms , find the power ( a ) supplied by the source ( real ) ( b ) radiated by the antenna ( c ) dissipated by the antenna
A 0.48520λ0 dipole antenna is made to work at 4 GHz. The antenna is then connected to a 12 V voltage source which has an internal resistance of 25 Ω) a) Make a diagram of the above system, b) Is an impedance matching circuit needed? If yes, where should the impedance circuit be inserted and make a diagram of the system with the adjusting circuit, c) How many cm is the length of the dipole antenna above, d) How much power is emitted when not using the adjusting circuit and e) How much power is emitted when using the adjusting circuit. Solve subparts D,E max 20 minutes ASAP
A slab of dielectric material has a relative dielectric constant of 3.8 and contains a uniform electric flux density of 8nC/m^2. If the material is lossless; find: The average number of dipoles per cubic meter (n) if the average dipole moment is p=10^-29Cm
A half wave dipole antenna is having a length equal to half of the wavelength. If the efficiency of radiation is 25%, then estimate the loss resistance of the system.
Please show all steps A parabolic dish antenna has a diameter of 5 meter, operating at 30 GHz frequency.a) What is the effective area Ae of the antenna? b) What is the antenna power gain in ratio and in dBi?
How the radiation resistance of a dipole antenna varies with its effective length? Find out the radiation resistance of a dipole antenna which is operating at 300 MHz.