3. The bars AB and AC are joined by a pin at A and a horizontal cable. The vertical cable carrying the 200- kg mass is attached to the pin at A. Neglect the weights of the bars. a. Determine the tension in the horizontal cable in N. b. Determine the reaction at support B and C in N. A 30° 60° 3 m 2 m B 200 kg

3. The bars AB and AC are joined by a pin at A and a horizontal cable. The vertical cable carrying the 200- kg mass is attached to the pin at A. Neglect the weights of the bars. a. Determine the tension in the horizontal cable in N. b. Determine the reaction at support B and C in N. A 30° 60° 3 m 2 m B 200 kg

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The uniform 22-m pole has a mass of 130 kg and is supported by its smooth ends against the vertical walls and by the tension T in the vertical cable. Compute the magnitudes of the reactions at A and B.
A uniformly distributed load on beam ABC in Figure P6.9 causes it to sag. To counteract this sag, a cable and post are added beneath the beam. The cable is ten- sioned until the force in the post causes a moment equal in magnitude, but opposite in direction, to the moment in the beam. Determine the forces in the cable and the post, and determine the reactions at A and C.
Calculate the reaction at support A and the value of tension in the cable BC. Take F = 80 N and M = 40 N.m
The 6-m pole ABC is acted upon by a 455-N force as shown. The pole is held by a ball-and-socket joint at A and by two cables BD and BE. For a =3 m, determine the tension in each cable and the reaction at A.
a. what is the degree of the moment curve at 2.5 m from the left support?b. calculate the maximum moment in the beam.c. calculate the vertical reaction at C.
A suspension cable is supported at A and B, 120 m. horizontally apart with B higher than A by 15 m. The cable subjected to horizontal uniform load of 10 kN/m and sags a distance of 10 m. measured from the chord joining A and B at the midspan, compute the horizontal reaction at the supports.
A pulley-and-cable assembly supports block W and requires a downward force at P for equilibrium. Knowing that the tension of cable FG is 61.2 N, calculate the mass of the block and the magnitude of the downward force P.
Can you solve reaction forces Dy, Ay, Ax, Dx, and the sag in the cable at point B,Yb
Calculate the components of reaction at the support A and also the tension in the cable BC. F = 80 N, M = 40 N.m
If the arch rib ABCDE in the three-hinged trussed arch shown in figure shown is to be funicular for a uniform dead load of 4 kN/m acting at the top chord, establish the elevation of the lower chord joints at B and D and compute the support reactions at A, C and E.
The 480 kg bent bar ABC of uniform cross section is supported by a pin at A and a vertical cable at c. Determine the pin reactions and the force in the cable.
determine the moment (m-kN) about point A due to the 3 kN and the two 17 kN forces.