3. The coplanar force system in the figure consists of three forces and a couple. y 50N 90N 40° 50 N.m 400mm |300mm 800mm 4 3 100N a.) Determine the magnitude of the resultant force b.) Determine the angle that the resultant force makes with the x-axis. c.) acting at point O. c.) Determine the magnitude of the resultant moment шшо09 500тm

3. The coplanar force system in the figure consists of three forces and a couple. y 50N 90N 40° 50 N.m 400mm |300mm 800mm 4 3 100N a.) Determine the magnitude of the resultant force b.) Determine the angle that the resultant force makes with the x-axis. c.) acting at point O. c.) Determine the magnitude of the resultant moment шшо09 500тm

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter13: Universal Gravitation

Section: Chapter Questions

Problem 13.4CQ

See similar textbooks

Similar questions

Competitive divers pull their limbs in and curl up their bodies when they do flips. Just before entering the water, they fully extend their limbs to enter straight down. Explain the effect of both actions on their angular velocities. Also explain the effect on their angular momenta.
1. Replace the two forces by a single equivalent force R and find the angle Ɵ between R andthe X-axis. 2. Calculate the moment of the 400N force about point O.
Sanjay and Ting, each with a mass of 25 kgkg, are riding opposite each other on the edge of a 150 kgkg, 3.0-mm-diameter playground merry-go-round that's rotating at 21 rpmrpm. Each walks straight inward and stops 35 cmcm from the center. Part A What is the new angular velocity, in rpmrpm?
Four forces F1,F2,F3 and F4 are being applied on a plate as shown in Figure 1. F1 = 1.2 kN, F2 = 2.3 kN, F3=2.3kN and F4 = 4.5 kN. Find the moment at ? due to F4 using scalar formulation. Then, using vector formulation find the resultant moment at point P.
Determine the moment of the force F about point A.
Problem 03 Show the drawing A force T passing through points A and B, has a counterclockwise moment of 400KN-m about point O, if the coordinates of points A and B are (0,6) and (8,0) in meters compute the value of force T.
A small ball of mass 0.50 kg is attached by a massless string to a vertical rod that is spinning as shown below. When the rod has an angular velocity of 6.0 rad/s, the string makes an angle of 30° with respect to the vertical. (a) If the angular velocity is increased to 10.0 rad/s, what is the new angle of the string? (b) Calculate the initial and final angular momenta of the ball. (c) Can the rod spin fast enough so that the ball is horizontal?
Plz help! A ring of mass 2 M and radius 2 R rotates in a CCW direction with initial angular speed 2 w. A disk of mass 2 M and radius 2 R rotates in a CW direction with initial angular speed 2 w. The ring and disk "collide" and eventually rotate together. Assume that positive angular momentum and angular velocity values correspond to rotation in the ccw direction What are the moments of inertia for the ring and disk? Write your answer in terms of MR?. What is the initial angular momentum for the ring? Write your answer in terms of MR^2w What is the initial angular momentum for the disk? MR^2w What is the initial angular momentum L(ring +disk) of the system?MR^2w What is the final angular velocity wf of the ring + disk system? Write your answer in terms of w
1. What is the difference of linear momentum and angular momentum. (COMPARE THEM) pls the handwriting, make sure it's readable. Better the writing is not cursive thank you. Also use your own words cause i'm checking it in grammarly.
Determine the magnitude of moment of a force F=-40i+70j-40k (lb) about point A. Express your answer in Ib.ft.
Determine the sense of the moment of the 800 N force about point A in Figure 1.
DETERMINE THE MAGNITUDE OF THE MOMENT OF THE FORCE F = {300i -200j +150k} N ABOUT THE OA AXIS.