Answered: 3. Using Current Divider to find the…

3. Using Current Divider to find the voltage, current and power associated with each element in the circuit. 120 AO nR 30 AO 0R R, 30 A( 4

An Introduction to Physical Science

14th Edition

ISBN:9781305079137

Author:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Publisher:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Chapter8: Electricity And Magnetism

Section: Chapter Questions

Problem 18E: A 100-W light bulb is turned on. It has an operating voltage of 120 V. (a) How much current flows...

See similar textbooks

Related questions

Q: The second Kirchhoff’s rule state that the sum of the potential differences across all elements…

Q: Which among the following is not a base unit? O a. Ampere O b. Kelvin Oc. Candela Od. Newton

A: Which among the following is not a base unit ? (a) Ampere (b) Kelvin (c) Candela (d) Newton

Q: 2- For the circuit shown below, determine the unknown currents: 2 A 7 A 3 A

Q: Whenever current flows through anything with an electrical resistance what happens?

A: When the electrons flow through the conductor, the ions of the conductor collide with the electrons,…

Q: 7Name the process of charging a conductor by bringing it near another charged object without…

Q: 5. Consider the circuit shown below, with four diffe: A

Q: 19. A current of 25.0 mA is measured in the circuit below. what voltage must the battery supply?

Q: What does it mean that it is a parallel circuit?

Q: 5- Calculate the currents in the three branches of the circuit shown below. 14.0 V 4.0 2 10.0ν 6.0 Ω…

Q: How are the two types of circuit arranged differently?

A: To connect the two or more electrical devices in a circuit with an energy source, there are two main…

Q: 9. obtain the equivalent resistance across terminals a and b for the given circuit below. a 30 Ω bo

A: Let labelled the given diagram:

Q: 23. In a parallel circuit with 3 light bulbs, one light breaks. What happens to the intensity of the…

A: When the 3 light bulbs are connected in parallel connection the voltage difference across all the…

Q: 9. obtain the equivalent resistance across terminals a and b for the given circuit below. a o 30 2…

A: Lets label the circuit diagram as follows: All resistors are of 30 Ω.

Q: 7. Determine the current flowing through the circuit 3 seconds after closing the switch. A. 12.25 A…

Q: Why Is Tungsten Metal Used In Bulbs But Not In Fuse Wires?

A: The following properties of tungsten are desirable for the filament of electric bulb: High Melting…

Q: _21. In order to effectively perform dynamic and in-circuit testing of equipment, testing electronic…

A: Note : Since there are multiple questions, as per guidelines we can give solution to first question,…

Q: Why is there no effect on other branches in a parallel circuit when one branch of the circuit is…

A: In a parallel connection, every component of circuit gets equal voltage and also the current that…

Q: The diameter of 0 gauge copper wire is 8.252 mm. Find the resistance (in Ω) of a 7.06 km length of…

Q: Which among the following is not a base unit? O a. Newton O b. Ampere O c. Kelvin O d. Candela

Q: 9. For the circuit shown below, find (a) the equivalent resistance; (b) the currents through each…

A: Given, Resistance,R1=6Ω,R2=3Ω,R3=2Ω,R4=7Ω,R5=8Ω,R6=5Ω Internal resistance,r=1Ω Emf of battery,ε=120…

Q: How to charge an electroscope by contact and induction? Thanks!

Q: A soldering gun contains a transformer that lowers the 120 V from an outlet to a few volts. It’s…

A: A soldering gun contains a transformer that lowers the 120 V from an outlet to a few volts and It’s…

Q: 4- The resistance between A and B are in series with the resistance B and D. *

A: Answer Two resistors on the same path are in series. There must be nothing else in between. If the…

Q: 6. Which of the following SI units were named after famous scientists? Select all that apply. amps…

A: Amps :- Amps is the short form of ampere. Ampere is the SI unit of current. Ampere is…

Q: un U. 02. Deternmine Vo in the circuit shown in figure 3.31 using the 2 05 superposition principle.…

A: Vo = 0.15 V

Q: 201 series-parallel/ Parallel-series 1,1720 5:17-30 2~ IT سى ✓ Iz. 36~ ↓ Is ·5~ ↓IG 6w 14" solue for…

A: Please note : As per answering guidelines I can answer the first question only. Since, this is not a…

Q: 13. In Series Circuit, _remains same throughout the circuit.

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 5- Calculate the currents in the three branches of the circuit shown below. 14.0 V 4.0 2 10.0 ν 6.0Ω…

Q: 16-In Europe, 220 V is used instead of 120 V in America. 60 W European bulb in America If used, what…

A: VE = 220 V VA = 120 V PE = 60 W PA = ?

Q: 2- Find the current through each branch of the network shown below. 10 25 10 20

A: considering the voltages given in the figure are, v1=10Vv2=20Vand let, the resistances are given in…

Q: 11. A portion of a circuit is shown, with the values of the currents given or some branches. The…

Q: 3. Using Current Divider to find the voltage, current and power associated with each element in the…

Q: Are there any gaps in the circuit?

A: Given: Circuit with bulbs, From the given figure compass needle deflected

Q: 23. A neon sign that requires a voltage of 11,000 V is plugged into a 120-V wall outlet. What turns…

A: Output voltage (Vs) = 11000 volts Input voltage (vp) = 120 volts

Q: 16. What does a dot in the intersection between two lines represent in a circuit? * no connection…

Q: 5) What happens to the reading of the ammeter if you reverse the connections? The voltmeter?

A: The ammeter has a very low resistance , which can pull of a large amount of current from voltage…

Q: 20. Three identical filament lamps are connected (a) in series, (b) in parallel acros: a 210V…

Q: As more lanes are added to toll booths, the resistance to vehicles passing through is reduced. How…

A: Given: Parallel circuit.

Q: 12) In the circuit shown below, if switch S is closed, then which light bulbs will remain on? L2…

A: When switch S is closed L1, L2, L3 will remain on

Q: An electric iron connected to a 110-V source draws 9 A of current. Show that the amount of heat it…

Q: 2) If the resistance, in the previous question, is increased while using the same battery, what…

Q: 4. If 10 C of charge passes a given point in a conductor every 2 seconds, how much current passes…

A: Since you have asked multiple question, as per our guidelines we will solve the first question for…

Q: 6) If we double the resistance in a circuit but keep the current in it constant, the power…

A: Given data, Final Resistance(R2)=2×Initial Resistance (R1) Final Current(I2)=Initial Current (I1)

Q: Mention two reasons on why tungsten is used for making filament of electric bulb.

A: Tungsten is used for making filament of an electric bulb due to the following reasons: Being an…

Q: 23. Why are short circuits and overloaded circuits dangerous?

A: If a circuit is short circuit, it allows to pass additional current through the appliances and thus…

Q: 5. In a parallel circuit, each resistor has a) the same current b) the same voltage c) the same…

A: In a parallel circuit, current is divided and voltage across each device is same.

Question

3. Using Current Divider to find the voltage, current and power associated with each
element in the circuit.
120 A (1) 30
nER, 30 A(
R2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In a dc circuit, how do electrons move? (8.2) (a) with a slow drift velocity (b) in alternate directions (c) near the speed of light (d) none of the preceding
Which is more likely to interfere with compass readings. AC current in your refrigerator or DC current when you start your car? Explain.
What are the two major hazards of electricity?
Give an example of a use of AC power other than in the household. Similarly, give an example of a use of DC power other than that supplied by batteries.
What would happen if you placed a voltmeter in series with a component to be tested?
A 100-W light bulb is turned on. It has an operating voltage of 120 V. (a) How much current flows through the bulb? (b) What is the resistance of the bulb? (c) How much energy is used each second?
Sometimes resistances in a circuit are described as being connected head to tail and all heads and all tails connected together. What is being described?
Find the resistance that must be placed in series with a 25.0-galvanometer having a 50.0-A sensitivity (the same as the one discussed in the text) to allow it to be used as a voltmeter with a 0.100-v full-scale reading.
Suppose you are using a multimeter (one designed to measure a range of voltages, currents, and resistances) to measure current in a circuit and you inadvertently leave it in a voltmeter mode. What effect will the meter have on the circuit? What would happen if you were measuring voltage but accidentally put the meter in the ammeter mode?
Consider the circuit shown below. Does the analysis of the circuit require Kirchhoff’s method, or can it be redrawn to simplify die circuit? If it is a circuit of series and parallel connections, what is the equivalent resistance?
The greatest equivalent resistance occurs when resistances are connected in which type of arrangement? (8.3) (a) series (b) parallel (c) series-parallel
What current flows through the bulb of a 3.00-V flashlight when its hot resistance is 3.60 O ?