3.10 The earth is 146.9 million km from the sun, and receives light with an intensity of 1.36 kW/m2. Mars is 227.9 million km from the sun. a. Calculate the intensity of sunlight for a satellite that is in the vicinity of Mars. b. If the satellite has solar cells with an efficiency of 29%, what area is required to generate 1 kW of electrical power?

3.10 The earth is 146.9 million km from the sun, and receives light with an intensity of 1.36 kW/m2. Mars is 227.9 million km from the sun. a. Calculate the intensity of sunlight for a satellite that is in the vicinity of Mars. b. If the satellite has solar cells with an efficiency of 29%, what area is required to generate 1 kW of electrical power?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4. An aluminum conductor having a cross-sectional area of 1843 MCM is used to transmit power from a high-voltage dc (HVDC) generating station to a large urban center. If the city is 900 km from the generating station, determine the resistance of the conductor at a temperature of 20oC. (Use 1 ft = 0.3048 m.) *Round off to 4 decimal digits.
A small wind turbine with a blade of diameter 205 cm is subjected to velocity 11.3 m/s . Calculate the power and energy produced by the turbine per year. Efficiency is 31% and density of air is 1.3 Kg/m3
The construction of PV solar cells uses a number of critical elements. One is indium an ingredient of the transparent conducting coating on the surface of the cell. The average material intensity for indium in solar cells is approximately 0.05 kg/kWnom. Calculate the quantity of indium that would be required for a project that would provide PV solar power with capacity factor of 0.25, sufficient to meet one third of the present needs of the US, population 301 million, each using an average of 10.2 kW. The current world production of Indium is 600 tones per year. If the solar project were to be implemented over a 5 year time span, is it true that the supply of indium be adequate?
A copper transmission cable 43 km long and 5.1 cm in diameter carries a current of 12 A. How much electrical energy (in MJ) is dissipated as thermal energy in 9 hours? Note: p= 1.72x10-8 ohms m
a) A 500-watt Tungsten Halogen lamp has an efficacy of 20 lumens/watt. Calculate its mean spherical intensity. b) Two sources of candle power or luminous intensity 200 candela (cp) and 250 candela (cp) are mounted at 8 and 10 m, respectively? The horizontal distance between the lamp posts is 40 m, calculate the illumination in the middle of the posts.
An electric crane lifts two tons of mass to a height of 10m in 10 second. If overall efficiency of the crane and motor is 65%, calculate energy required by crane and motor input power.
Estimate the total land requirements for wind farms generating an amount of electric energy equal to 2008 US annual consumption (4.4 × 1012 kWeh) if individual units are rated at 2 MWe, have a rotor with a 100 m diameter, and are spaced 3 diameters side to side, 10 diameters front to rear in giant contiguous wind farms having an annual average capacity factor of 25%. Compare the required area to that of North and South Dakota (combined land area of 145,000 square miles), which have some of the best US wind resources. Discuss the factors that would favor or impede the practical implementation of a Grand Midwestern Wind Farm plan to provide the bulk of US electric energy by the year 2050.
A solar panel has a surface area of 0.5 m^2 and delivers maximum power at 2.5A, 19 V when in sunlight with incident radiation of 95 mW/cm^2. If the open circuit voltage is 25 V and the short circuit current is 3 A, calculate:(a) the power generated by the panel,(b) the fill factor, and(c) the efficiency of the panel. (d) Given that the solar panel is exposed to sunlight 6.5 hours per day (on average) and the energy used to manufacture the solar panel is 890 kWh/m^2, calculate the energy payback time of the solar panel.
If a PV cell will produce 7-9 watts per square feet, suppose if the rooftop area is 19ftX7 ft then how much power on average it will produce? Also, calculate the energy produced for one year if the effective time of utilisation is 6.5 hours?
Determine the wind energy per unit mass if the winds speed is 39 Km/Hr.
Regional Maritime University (RMU) campus has 200 classrooms and 400 faculty offices. The classrooms are equipped with 12 fluorescent tubes, each consuming 110 W, including the electricity used by the ballasts. The faculty offices, on average, have half as many tubes. The campus is open 240 days a year. The classrooms and faculty offices are not occupied an average of 4 h a day, but the lights are kept on. If the unit cost of electricity is GH₵ 0.082/kWh, determine how much the campus will save a year if the lights in the classrooms and faculty offices are turned off during unoccupied periods.
A three-axis stabilized satellite has two solar arrays. Each array has an area of 5m². At the beginning of life each of the solar sails generate 4kW of electrical power, which falls to 3.6 kW at the end of the satellite's useful lifetime. 1 kW of power is needed for housekeeping (running the satellite systems) and 3 kW is devoted to the telecommunication system. a. Calculate the efficiency of the solar cells at beginning of life. Assume an inci- dent solar power of 1.36 kW/m2, and normal incidence of sunlight on the sails. b. Caleulate the efficiency of the solar cells at end of life. E lfone of the solar sails fails and produces no power, how much power is avail- able to the telecommunication system.