3.15.) In air conditioning unit, 71,000 cfm at 80°F dry bulb 60% th and standard atmospheric pressure, enter the unit. The air leaves the wait at 57°F dry bulb and 90% relative humidity. Calculate the following a.) Cooling capacity of the air conditioning unit, in Btu/h 6.) rate of water removal from the unit. C.) sensible heat load on the conditioner, in Btu/h וח (1

3.15.) In air conditioning unit, 71,000 cfm at 80°F dry bulb 60% th and standard atmospheric pressure, enter the unit. The air leaves the wait at 57°F dry bulb and 90% relative humidity. Calculate the following a.) Cooling capacity of the air conditioning unit, in Btu/h 6.) rate of water removal from the unit. C.) sensible heat load on the conditioner, in Btu/h וח (1

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 1RQ: The standard design conditions for air-conditioning systems established by the Air-Conditioning,...

See similar textbooks

Similar questions

The standard design conditions for air-conditioning systems established by the Air-Conditioning, Heating and Refrigeration Institute (AHRI) are outside temperature _____F, inside temperature ______F, with a humidityof____%.
Air at 24 °C dry-bulg and 15 °C wet-bulb enters a humidifier and leaves at 41 °C dry-bulb and 21 °C wet-bulb. How much moisture has been added per kilogram of dry air?
.- Air is cooled and humidified, initially at 90 °F BS and 70 °F BH is cooled and dehumidified, reaching 56 °F BS and 54 °F BH, 3000 CFM is supplied. Calculate: a) sensible heat b) latent heat c) total heat d) Lbs. moisture removed per hour e) determine the RH at the inlet and outlet
Hi please show working? Thankyou ! An air conditioner cools humid air Temperature 1 =25 celcius Temperature 2 = 10 celcius Relative humidity 1 = 70% Determine the final relative humidity (2) and calculate: 1) the energy removed 2) the water mass extracted from the air
Air enters a humidifier at 34.25°C and 30% RH. If the air leaves the humidifier at 70% RH. Determine: The exit dry-bulb temperature of the air in °C.The saturation effectiveness in %.
In single duct air conditioning system; 1 kg/s of outlet air at - 6°C db, 75 % RH mixes with 3 kg/s of the return air at 24°C db, 50% RH. The mixture air sensibly heated to 38°C db, then humidified (Twb =const.) to 24°C db. Draw the processes on the psychrometric 1. Heating coil capacity. 2. Quantity of the moisture
The following data are known for Libr-H₂O absorption system. The cooling capacity is 3.5 kW, generation temp. is 82°C, condenser temp. 40°C, evaporator temp. 6°C. Temp. of absorber is 34°C. Assumed saturation condition for strong solution entering generation, weak solution leaving generation and water vapor Leaving evaporator. Properties of solution or water at each point (p, t, h, x), Mass flow rate each point,(COP) act & (COP) tho, Relative COP and Energy balance for all cycle components.
f. A single-family detached residence of moderate construction has a total sensible load of 53,300 Btu/hr. The design humidity ratio is 0.021 lb of vapor/lb of dry air. Determine the total cooling load.
At 0°C, 60% relative humidity, the air entering with 2.2 m3/s comes out with 30°C, 50% relative humidity. In this air handling unit, the air at 10°C temperature and 60% relative humidity from the outside is blown inside at 30°C temperature and 50% relative humidity, after heating and humidification processes. The total pressure of the air taken from the outside is 100 kPa and the suction flow rate is 2.2 m3/s. According to this, a) What is the amount of moisture transferred to the air in the power plant? kg/h b) What is the thermal power transferred to the air in the power plant? is kW. NOTE: The total enthalpy of the air-water vapor mixture, with the mass of air ma and the mass of water vapor mv It is calculated by the relation h=ma1.005 T + mv(2501+1.82 T) (kJ/kg-dry_air). Tip: Calculate the masses of dry air and water vapor separately.
The standard design conditions for air-conditioning systemsestablished by the Air-Conditioning, Heating andRefrigeration Institute (AHRI) are outside temperature______°F, inside temperature ______°F, with a humidityof ______%.
Pls. Answer thank you! A 95°F dry bulb, 75°F wet bulb air passes through a cooling tower and leaves at 85°F dry bulb and 90% relative humidity. The enthalpy change per cubic foot of air is most nearly?
How high a relative humidity must a 35°C air have in order to obtain saturated airat 18°C by evaporative cooling? solve with complete diagram