3.9. Use the analysis equation (3.95) to evaluate the numerical values of one period Specify two different signals that satisfy these conditions. the Fourier series coefficients of the periodic signal x[n] Z {48[n – 4m] + 88[n – 1 – 4m]}. m=-00

3.9. Use the analysis equation (3.95) to evaluate the numerical values of one period Specify two different signals that satisfy these conditions. the Fourier series coefficients of the periodic signal x[n] Z {48[n – 4m] + 88[n – 1 – 4m]}. m=-00

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The following is the response of a second-order control system to a unit-step input. Identify t, tp,...

Q: ki, I R

Q: For the network of Fig. 12.80, the switch is closed at t = 0 s. a. Determine vL at t = 25 ms. b. Fin...

Q: 2. Calculate the equivalent resistance Rab in the circuit below. 10 Ω d 1Ω a 6Ω Rab 4Ω 5Ω 3Ω 12Ω b b

Q: A compound motor develops a torque of 271 lb-ft when it is operating at 1200 rpm, under which condit...

Q: 2A,0.942] ance and standstill o rings at standstill e rotor current and d to star-connected 0.16,7.7...

A: Please refer the attached images for the complete answer..

Q: Given:delta-delta(balanced),positive sequence Three phase load impedance per phase:0.7+0.11j la=13 a...

A: The solution is given below

Q: In common source configuration the input resistance of a JFET will be approximately____. a.500 Ohm b...

Q: The primary difference between BJT and FET types of transistor is;

Q: Q2 / For a current of r. m. s value 5 A, and frequency 2 kHz, write down the standard expression. He...

Q: Q1/A sinewave is shown in Fig. below. Determine its amplitude, periodic time and frequency

Q: RI 2Ω R2 {12 N |

Q: Is there an Unstable system that is Memory? Give an example in either discrete or continuous time Ex...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Use the convolution integral to find the function h=(f*g) where f=t*u(t) and g=t^n*u(t) where n is a...

A: U(t) is the unit step signal exist for t>0 . Using convolution integral to find convolution of f ...

Q: Given the potential field in cylindrical coordinates, V = 100 + 50ρ + 150ρ sinΦ volts, and point P ...

Q: The charge on one plate tor is 0.12 uC. The energy stored in the capacitor is (i) 4.8 mJ 3 µF capaci...

A: The data given in the question are: C=3μF, Q=0.12μC The energy stored in the capacitor is given by t...

Q: Is there any “current law” for meshes? If so, what is it

A: Kirchoff's voltage law is used for calculating the current in the meshes and the loop. Thus the mesh...

Q: P-channel MOSFET is basically a following device. a. voltage operated O b. low-frequency operated O ...

A: MOSFET is controlled by the application of GATE pulse . GATE pulse controls the conduction state of...

Q: 2. The input to a full-wave bridge type rectifier with silicon diodes is V, = 10 Vms- Determine: a.)...

Q: For the following pass-band filter: a. Determine Qp (RL = ∞ , an open circuit). b. Find Qp (loaded) ...

A: GIVEN: a band pass filter R1=1KΩRl=10ΩXC=400ΩfP=20KHz FIND: ...

Q: 2. For an ideal silicon p-n abrupt junction with NA = 5 x1016 cm³ and Np = 5 x 1015/cm³, Calculate V...

A: Brief description : A PN junction diode is made up of two sides such as P & N. P this side is ha...

Q: z-7 +3z-1- 2z-3 +1 A right-sided sequence has a z -transfom X(z)= 3z-9 Find the index and the value ...

Q: Find the state-equation and output equation of the given RLC electrical network with the output equa...

Q: An engineer would like to use mesh analysis to analyze the circuit as shown above. The engineer find...

Q: Determine the percent modulation for an unmodulated carrier of 80 Vp-p if the maximum and minimum vo...

Q: Start Now > Combine PDF > Send Files > Store Files 3. A one sided p+/n silicon junction at 300K is d...

Q: Given G2(A,B,C,D) = Σm(3,4,13,15) + Σd(1,2,5,6,8,10,12,14) . Derive the POS and SOP

Q: Given G3(V,W,X,Y,Z) = Σm(0,2,4,6,7,8,10,11,12,13,14,16,18,19,29,30). Derive the POS and SOP.

A: POS(product of sum) and SOP(sum of product) both are complements to each other. POS represent with t...

Q: With reference to Fig. 4-19, E, = £3 – §2 + 22e, = 2€z, €z = 18€9, and the bound a surface charge de...

Q: N, Q3) A 10 HP 240 volt 1200 RPM DC Shunt Motor is operating at rated conditions. Determine the perc...

Q: What are the power in each sideband for an AM signal with 60% modulation and a total power of 50 kW?...

Q: QL/A-What is the relative increase or decrease in conductivity of a conductor if the area is reduced...

A: Consider the area is reduced by the 30%. Then, the new area is, A-0.3A=0.7A Consider the length is i...

Q: An engineer would like to use mesh analysis to analyze the circuit as shown in the figure above. Wha...

A: Given:

Q: 3.5. Let x1(t) be a continuous-time periodic signal with fundamental frequency wj and Fourier coeffi...

Q: For proper operation of an N-channel JFET the gate voltage needs to be _____ with respect to the dra...

A: in JFET current through the device is controlled by the application if gate current . There are two...

Q: TUBULAR OR COMPACT FLOURESCENT LIGHT PINLIGHT WITH COMPACT FLOURESCENT BULB THE ELECTRICAL INSTALLAT...

A: Every electrical equipment and devices are represented by the symbols for easy to understandable and...

Q: loop transfer function T(s) = C(s) State the nature of the unit step response of the system. R(s) 3 ...

Q: The charge on one plate of a 3 µF capacj- tor is 0.12 uC. The energy stored in the capacitor is (i) ...

A: Given, Charge, Q = 0.12 μC Capacitance, C = 3 μF

Q: Consider a continuous-time ideal lowpass filter S whose frequency response is H(j@) = { 1, 100 When...

Q: 2- For the above motors, draw the graph T/n. 3- Draw n/I, for the shunc motor. 4- Draw n/V, for the ...

Q: If A = 4a, + 3ap – 5a, the component of A parallel to the surface o = 27 is; Select one: O -4ap О 4а...

Q: The ----- terminal of the JFET is the equivalent of the base terminal of a BJT. O a. Drain O b. Gate...

A: ....terminal of the JFET is equivalent to the base terminal of a BJT.

Q: INSTRUCTION: Determine the internal resistance (and its uncertainty) of the battery, also plot a gra...

A: A table with the results of voltage and currents for four circuits is given in the question. We need...

Q: At every point in the space ar x ag = 1 Select one: O Incorrect, a O Incorrect, it is -ag O None of ...

Q: Explain the THREE (3) main advantages of Digital Control System.

A: Control system- A control system manages, commands, directs, or regulates the behavior of other devi...

Q: qe im or to K(s + 4) G(s) = s(s + 1.2)(s + 2) range of K that keeps the system stable. e value of K ...

Q: 6. Obtain I, in the circuit of Fig. 2.45. 2/0° A 10/90° V j2 Ω -j4 2 1Ω 4/0° A 1Ω Fig. 2.45

Q: H.W. In the network in Figure shown below, Vo is knovn to be 8 45°V. Compute Vs: -j22 V.

Q: Design a sequential circuit that counts in the sequence 0, 1, 2, 3. Use JK flip-flops. Draw the log...

A: The solution is given below

Q: In cylindrical coordinate system, p = 2, ø = defines a; Select one: O Vector Surface Point Line O No...

Concept explainers

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.

Question

4. JoTx(t)|² dt = 1.
Specify two different signals that satisfy these conditions.
3.9. Use the analysis equation (3.95) to evaluate the numerical values of one
the Fourier series coefficients of the periodic signal
period a
x[n] = > {48[n – 4m] + 88[n – 1 – 4m]}.
m=-00

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In signal Processing, what is the purpose of Fourier Series on ECG Signals? Cite at least 3
a. Which of the following is true? The Fourier transform of a unit rectangular pulse is A. real. B. not oscillating. C. complex. D. neither real nor complex. b. Which of the following is true? For system and signal operations, the symbol “*” is typically shared between A. convolution and complex conjugate. B. linear combination and complex conjugate. C. orthogonality and complex conjugate. D. multiplication and complex conjugate. c. Which of the following is true? The Fourier transform is based on A. The Fourier series by substituting the signal x(t) into Fourier coefficient’s expression. B. The Fourier series by substituting the Fourier coefficient’s expression into a random signal which is periodic over a defined period. C. The Fourier series by substituting the Fourier coefficient’s expression into x(t). D. The Fourier series because this is a logical process.
Calculate the frequency bin width of a 1024-point Fourier vector for whichthe data is sampled at 512,000 Hz. Explain how the roots of unity are derived and how they are used
1. The sequence length of the DFT (Discrete Fourier Transform) calculation of a signal is the same as the sequence length of the signal. True or False? 2. Inverse DFT or X(k) for 0
Consider the periodic signal ?(?) given by the expression x(t) = (2 + 2j)[e^(−j3t)] – 3j[e^(−j2t)] + 5 +3j(e^(j2t) + (2 – 2j)e^(j3t) . a) What is the fundamental frequency of x(t)? b) Find and plot the magnitude and phase of the Fourier series coefficients as a function of frequency. c) Is x(t) a real signal? Why? d) Compute the total power of x(t) using Parseval’s relation.
a. Show that 2-D discrete Fourier Transform of a M × N digital image is periodic.That is, you must prove that F(u + M, v + N) = F(u, v). b. Suggest two methods to bring the frequency origin of a discrete Fourier Transform of an image to the center ofthe 2-D array of frequency plane.
Find the Fourier series representation of the even extension of the function Then, find the value of an if c = 3.95, b = 4, n = 6.
Representing a signal (image) in a Fourier series representation with a complex exponential function. Also draw the magnitude plot and phase plot of the resulting Fourier series coefficients. (Using Simple ways, use he Euler Formula)
Type using Kepord or will dislike can anyone explain what the discussion could be make from the graphs respectively ? question : the fourier transform of the rectangular function numerically by sampling it 256 times over the time interval 0<= t < 0.2.
The message given in the figure is given as c = 4, b = 3 for the signal m (t). Fourier Transform of the message signal m (t) given in the figure is given as L = 140 Hz in the signal M (f). This message signal is a sinusoidal signal with a carrier frequency of 6000 Hz and amplitude Ac = 1, and frequency modulation with a frequency sensitivity of kf = 0.4 . Calculate the bandwidth of the frequency modulated signal produced according to Carson's rule.
An analog signal xa(t) has a continuous fourier transform that follows the attached image. If the signal is sampled at 600 samples/sec, the DTFT is the second image. What's the sketch of the spectrum Xa(F) of the origial analog signal?
2. Determine the Fourier series of full wave rectified signal whose amplitude is Vm and periodis π