30.) A 4-ohm resistance is connected in series with the parallel connection of 8 and 16 ohms. If the battery source is,rated 12 V, determine the current through the 16-ohm resistor. Express in four decimal places.

30.) A 4-ohm resistance is connected in series with the parallel connection of 8 and 16 ohms. If the battery source is,rated 12 V, determine the current through the 16-ohm resistor. Express in four decimal places.

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter27: Service-entrance Equipment

Section: Chapter Questions

Problem 33R

See similar textbooks

Related questions

Q: *7. Determine the level of V, for each network of Fig. 157. Si Ge 2 k2 +10 V Si 1.2 kQ 12 V o Vo 10 ...

Q: What is the simple interest on 12,500 at 8% for 9 months? John borrowed 15,000 for 2 years and 6 m...

A: 1. Principle amount is given, P = 12500. Rate of interest r = 8% Time is given, t=9 months =912=0.75...

Q: V2 7 R3 R4 10 V1 5 R1 R2 20 15

A: We need to find out current through the given resistance

Q: Design a clipping circuit using below waveform. -6 V -21 V

A: The Clipper circuit consists of a diode, a resistance, and sometimes a voltage source to provide the...

Q: A 75 Ω lossless line is terminated in error with a 93 Ω resistor. A generator sends 100 mW down the ...

Q: There are five cells combined in series to form a battery. A light bulb with a resistance of 4 ohms ...

Q: using K-map,minimimze the function f(x,y,z)=sop(1,2,4,6,7)

Q: 2) DC transistor analysis: Find the indicated DC values: Vbase, Vemitter, Vcollector, Icollector Voc...

Q: 2 ohms 10 ohms 12 ohms eo 16 V 8 A 6 ohms

A: Given

Q: Perfendicada 3. a. For the capacitors shown, find the potential difference across each of the capaci...

A: The answer of the questions are

Q: Q2. Determine whether the transistor is biased in cutoff, saturation or linear region. (a) Rp= 75KN ...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: PROBLEM 3: Four capacitors are connected in parallel with a battery shown in the figure. Simply the ...

A: We need to find out voltage, charge and energy for each capacitor in the given circuit

Q: 3. Determine the instantaneous frequency (expressed both in rps and cycles/sec) of the signal x(t) d...

Q: Problem1) Determine the signal space representation of the four signals s (1), k = 1,2, 3, 4, shown ...

Q: Q. 3 Use any method of your choice and find the values of v, and i, in the circuit shown in Figure f...

Q: Solve, correct to 2 decimal places, the equation 21n.x+x=2 using the method of bisection.

A: The solution is given below

Q: terminals in the circuit of Fig. 4.30. Then find I. 6Ω a ww Answer: V-Th = 6 V, RTh = 3 N, I = 1.5 A...

Q: Rectifier Circuit. 1. What is V1 reading? a. 110V b. 220V c. 0V d. 146.67V 2. What is V2 reading...

Q: Find the Norton equivalent circuit of the circuit in Fig. 4.45 at terminals a-b.

Q: Problem 3 What should be the value of R such that maximum power transfer can take place from the res...

A: According to guidelines we are allowed to do only first question. Post again for remaining one

Q: Q1: For the parallel network find the unknown quantities: E, R1, and 13. 12.3 A E R1 R2 20 Ω R: 4Ω 1...

A: As per bartleby guideline for more than one question asked only first is to be answered please uploa...

Q: What publication is being used to update onboard charts and other publications? A) Admiralty tables ...

A: Generally we use Admiralty tables , to the update onboard charts and other publications. These are...

Q: What is forward bias and reverse bias in PN junction diode?

A: We need to tell about forward bias and reverse bias for a diode .

Q: Example: If the analog signal to be quantized is a sinusoidal waveform, that is x(t) = Asin(2 x 10³n...

Q: R1 R2 a b 20 Vs1 11 Vs2 -12V 2A 20V

A: From the given digram, your are asking the supply voltage value of Vs2 = ?

Q: modulated by a 2-kHz sine wave between

Q: discuss an application that uses a transistor amplifier for its operation. It would be best to inclu...

A: DISCUSS: application that uses a transistor amplifier

Q: If a person wants to reach for book on the table, closed loop system can be represented as in Fig. 0...

Q: How many lines are there in an NTSC signal? a) 1024 b) 1856 c) 625 d) 525

A: We need to select correct option for given statement.

Q: Rectifier Circuit for nos. 1 to 7. Determine the reading of each meter and PLave. A! A2 3:2 VI 220v ...

Q: 2. Calculate the power factor of the entire circuit of Fig. as seen by the source. What is the avera...

A: The detailed solution is provided below.

Q: Laplace transform

A: Delta Function- It is also known as the unit impulse function. It's value is equal to zero everywher...

Q: Find Norton equivalent circuit: 20 300 2 4 2 42 6 V 40 2V

Q: I 42 J22 42 J252 2 10.8: For the circuit shown, Find the currents w.r.t voltages equations (Y-Parame...

A: Apply KVL in two loops to find two equation in terms of voltage V1 and V2. According to KVL sum of v...

Q: The wistantanerus valkres of furo altemating curpente are grven by i,-voSmiot and i, =10 Sin (ot + )...

A: In this question, Two alternating current is given. Find the sum of the both current using the pha...

Q: 5. A coil RL is connected in series with a capacitor across the 220 V, 60 hz, AC supply. If this cir...

A: Use phasor diagram to find magnitude of voltage across the coil or voltage across the capacitor.

Q: A coil having an inductance of 50 mH and resistance 10 ohms connected in series with a 25 microfarad...

A: At resonance imaginary part of impedance is zero I.e, XL=Xc. Current at resonance =voltage/resistanc...

Q: I aystem, ir (t) - e[u(t) -u(e - 2)) Ae) = e[u(t) - u(t - 2)) %3! ye) 21) Sketch the system input x(...

Q: Two Alternators are operating in parallel supplying a common load of 4250KW at 85% power factor lagg...

Q: R1 2 Ohm R2 4 Ohm b I: Vs1 12V Is 2A -Vs2 A9

A: We need to tell about voltage source .

Q: A lossless transmission line has a capacitance per unit length of 90 uF/m (microFarad/meter) and an ...

A: Lossless transmission line A transmission line with no line resistance and no dielectric loss is kno...

Q: * The Probability density function (PA) of a stgnal is ginen by ke PCx) 2 Ix1 <4 othermse a) what th...

A: The solution is given below

Q: I WO 1oads are connected in parallel across a 12,470-V rms source. One load takes 23 kVA at 0.75 lag...

Q: R2 4 Ohm D: D: Is 5A R1 2 Ohm 4is 21:

Q: Activity 1: Try To Solve Me! Directions: Solve the following problems systematically. Write your sol...

Q: For the given network, calculate the resistance R3 if the current through it is 2A. R 12 n 120 V: 2 ...

Q: 3. Consider a bridge rectifier circuit which is fed by a sinusoid input, Vs with 1.5kN load, whose i...

Q: ... A B Do L

Q: Convert D216 to binary. Now, treating the number as an 8-bit two's-complement number, convert to dec...

A: Using different number conversion formulas find the equivalent number in decimal system.

Q: The Hall voltage is usually equal to a few volts.

Concept explainers

Star Delta Conversion

Find the input resistance between points A and B of the following resistive network:

Question

30.) A 4-ohm resistance is connected in series with the parallel connection
of 8 and 16 ohms. If the battery source is rated 12 V, determine the current
through the 16-ohm resistor. Express in four decimal places.
Your answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An electric boiler has two heating elements each of 230V, 3.5kW rating and contains 8L of water at 30 deg C. Assuming 10%loss of heat from the boiler, find how long after switching on the heater circuit, will the water boil a atmospheric pressure if the two elements of the heaters are in parallel
Compute the cost per hour at 7.50 pesos per kwh of electrifying the house. If the appliances inside the house are an electric fan with resistance of 25 ohms, television which requires 5 ampere of current to start, water dispenser with resistance of 3 ohms, all connected to 220V and on for 8 hrs.
Design a 25V solar PV panel system that can power a home that requires two 30-Watt lamps and four 15-Watt fans for 6 hours daily if the factors for the solar panel generation and the total energy losses respectively are2.92 and 1.3. Take the rating of the available solar PV cell as 5V, 5W
An electric boiler has two heating elements each of 230V, 3.5kW rating and contains 8L of water at 30 deg C. Assuming 10%loss of heat from the boiler, find how long after switching on the heater circuit, will the water boil a atmospheric pressure if the two elements of the heaters are in series.
Determine the current supplied by each battery (use the mesh method)
A house has the following electrical appliance usage: - One 32 Watt fluorescent lamp with electronic ballast used 6 hours per day. - One 75 Watt fan used for 3 hours per day. - One 100 Watt refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours. - The system will be powered by 12 Vdc, 110 Wp PV module. e) What is the Total Ampere-hours required for the battery in Ah for 3-day autonomy? (Round off your answer to three decimal places. Do not put comma in numerals)
2- Please I want answer of this Electrical Principles question. Thanks
The rating of a plant is as below: 325 MW of wind capacity, 215 MW of solar power, 750 MWh/day of battery storage. Cost of batteries: 189 $/kWh Calculate the LCOE of the battery system if the round trip efficiency is 95% and the battery life is 12 years. A. 545.06 $/MWh B.45.42 $/MWh C.0.045 $/MWh D.0.022 $/MWh *pls show work and ensure it matches with the multiple choice options provided above*
1. A 300W electric heater at 110-V with a safety fuse in the circuit handling 15A of current. How many heaters can be safely operated in the circuit? 2.A heater uses 20A when used in a 110-V line. If electric power costs 11.50 per kilo watt hour, the cost for running the heater for 10 hour is? Give the given and solution as well. thank you so much
Kindly help, Calculate the current and voltage drop across the 3-ohm resistor using Superposition Theorem. Thank You!
How do you connect an ammeter to determine the current in a resistor? How do you connect a voltmeter to determine the voltage in a resistor? Answer only in paragraph form. Thanks
The total power absorbed by a group of resistors is always equal to the power absorbed by its equivalent resistance. Choose the correct answer: A. True B. False