•32 In Fig. 8-45, a chain is held a frictionless table with one- fourth of its length hanging over the edge. If the chain has length L = 28 cm and mass m = 0.012 kg, how much work is required to pull the hanging part back onto the table? Figure 8-45 Problem 32.

•32 In Fig. 8-45, a chain is held a frictionless table with one- fourth of its length hanging over the edge. If the chain has length L = 28 cm and mass m = 0.012 kg, how much work is required to pull the hanging part back onto the table? Figure 8-45 Problem 32.

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter7: Energy Of A System

Section: Chapter Questions

Problem 7.5P: A block of mass m = 2.50 kg is pushed a distance d = 2.20 m along a frictionless, horizontal table...

See similar textbooks

Similar questions

Apollo 14 astronaut Alan Shepard famously took two golf shots on the Moon where its been estimated that an expertly hit shot could travel for 70.0 s through the Moons reduced gravity, airless environment to a maximum range of 4.00 km (about 2.5 miles). Assuming such an expert shot has a launch angle of 45.0, determine the golf balls (a) kinetic energy as it leaves the club, and (b) maximum altitude in km above the lunar surface. Take the mass of a golf ball to be 0.045 0 kg and the Moons gravitational acceleration to be gmoon = 1.63 m/s2.
A block of mass m = 2.50 kg is pushed a distance d = 2.20 m along a frictionless horizontal table by a constant applied force of magnitude F = 16.0 N directed at an angle = 25.0 below the horizontal as shown in Figure P5.8. Determine the work done by (a) the applied force, (b) the normal force exerted by the table, (c) the force of gravity, and (d) the net force on the block. Figure P5.8
Consider a particle on which a force acts that depends on the position of the particle. This force is given by . Find the work done by this force when the particle moves from the origin to a point 5 meters to the right on the x-axis.
The surface of the preceding problem is modified so that the coefficient of kinetic friction is decreased. The same horizontal force is applied to the crate, and after being pushed 8.0 m, its speed is 5.0 m/s. How much work is now done by the force of friction? Assume that the crate starts at rest.
A 5.0-kg block is pushed 3.0 m up a vertical wall with constant speed by a constant force of magnitude F applied at an angle of = 30 with the horizontal, as shown in Figure P5.76. If the coefficient of kinetic friction between block and wall is 0.30, determine the work done by (a) , (b) the force of gravity, and (c) the normal force between block and wall, (d) By how much does the gravitational potential energy increase during the blocks motion? Figure P5.76
A 5.00-kg block is set into motion up an inclined plane with an initial speed of i = 8.00 m/s (Fig. P7.21). The block comes to rest after traveling d = 3.00 m along the plane, which is inclined at an angle of = 30.0 to the horizontal. For this motion, determine (a) the change in the blocks kinetic energy, (b) the change in the potential energy of the block-Earth system, and (c) the friction force exerted on the block (assumed to be constant), (d) What is the coefficient of kinetic friction? Figure P7.21
Repeat the preceding problem, but this time, suppose that the work done by air resistance cannot be ignored. Let the work done by the air resistance when the skier goes from A to B along the given hilly path be —2000 J. The work done by air resistance is negative since the air resistance acts in the opposite direction to the displacement. Supposing the mass of the skier is 50 kg, what is the speed of the skier at point B ?
A block of mass m = 2.50 kg is pushed a distance d = 2.20 m along a frictionless, horizontal table by a constant applied force of magnitude F = 16.0 N directed at ail angle = 25 below the horizontal as shown in Figure P7.5. Determine the work done on the block by (a) the applied force, (b) the normal force exerted by the table, (c) the gravitational force, and (d) the net force on the block.
A hummingbird is able to hover because, as the wings move downward, they exert a downward force on the air. Newtons third law tells us that the air exerts an equal and opposite force (upward) on the wings. The average of this force must be equal to the weight of the bird when it hovers. If the wings move through a distance of 3.5 cm with each stroke, and the wings beat 80 times per second, determine the work performed by the wings on the air in 1 m if the mass of the hummingbird is 3.0 g.
When a body slides down an inclined plane, does the work of friction depend on the body’s initial speed? Answer the same question for a body sliding down a curved surface.
Cite two examples in which a force is exerted on an object without doing any work on the object.
A block of mass m = 2.50 kg is pushed a distance d = 2.20 m along a frictionless, horizontal table by a constant applied force of magnitude F = 16.0 N directed at an angle = 25.0 below the horizontal as shown in Figure P6.3. Determine the work done on the block by (a) the applied force, (b) the normal force exerted by the table, (c) the gravitational force, and (d) the net force on the block. Figure P6.3