33. What is the electric potential 25.0 cm from a 6 micro coulomb point charge? 34. Calculate the electrical potential of q, = 25.0nC at (a) 2.00cm, (b) 3.00cm.

Q: The current I, through a resistor is measured with a digital ammeter to be 0.50 ± 0.01 A. The uncert...

A: We have a current running through the resistor which measured by a digital ammeter giving I=0.50 A w...

Q: 2.18 What is the change in the viscosity and density of water be- tween 10°C and 70°C? What is the c...

A:

Q: In 2.0 s, 6.25 x 1018 electrons pass through a given point. How much current passes through this poi...

A: Given information: The number of electrons pass through the point (n) = 6.25×1018  The time taken (t...

Q: A block of mass m=2.50 kg is pushed a distance d=2.20 m along a frictionless, horizontal table by a ...

A: Given a block mass m= 2.5k Distance d=2.2 Force f=16 We have to find the work done on the block by t...

Q: During the Intramurals of a school, a volleyball player tosses the ball towards the opposite court w...

A:

Q: A copper wire of length 3-m and 1-mm diameter is subjected to a tension of 5-N. Calculate the elonga...

A: Given: The length of the wire is 3 m. The diameter of the wire is 1 mm. The tenson in the wire is 5 ...

Q: 444 N A uniform bar AB is resting in a horizontal position on smooth inclines as shown below. Determ...

A:

Q: 1. The drawing shows three charges, labeled q1, q2, and q3. Gunian surtace A Gaussian surface is dra...

A: (a) :- according to gauss theorem ,the electric flux through a closed surface depends only on enclos...

Q: 22.11 • A 6.20-µC point charge is at the center of a cube with sides of length 0.500 m. (a) What is ...

A:

Q: There is a ray of monochromatic light is traveling through air and is incident upon a block of trans...

A: Given: The angle of the incident is 76.1o. The refractive index of the material is 1.58.  

Q: A heat turbine can generate a maximum power of 250 MW. How much work can the turbine do in 7.8 min?

A: Given Power of turbine = 250 MW Time taken = 7.8 min We have to calculate work done by turbine durin...

Q: If two balls are released simultaneously from the same height, which one will hit the floor first, t...

A: Here Suppose initial velocity = u Final velocity =v acceleration due to gravity=g Height of ball dro...

Q: 6-m long ladder has a mass of 1Q kg, and its center of gravity is 2.4 m from the bottom along the la...

A: Given, Length of rod=6m Mass=18kg Ladder mass=72kg

Q: A drinking straw sits in a glass which is half full of water. When a child blows across the top of t...

A:

Q: A proton moves through a uniform magnetic field 2.0 µT at a speed of 5.00 x 106 m/s. (a) What is the...

A: Magnetic field (B) = 2 μT speed (v) = 5×106 ms  

Q: Consider 3 resistors with resistances 1.15 × 102 Ω, 2.1 kΩ, and 3.8 kΩ. What would be their resistan...

A:

Q: Problem 2: A block with a mass of m = 31 kg rests on a frictionless surface and is subject forces ac...

A: Givenm=31 kgF1=12 NF2=23.25 Nangle, θ=18°

Q: Two sound waves interfere with each other. One has a frequency of 445 Hertz, the other is 461 Hz. Wh...

A: Given  Frequency of first wave f1 = 445 Hz  Frequency of second wave f2 = 461 Hz  Speed of sound v =...

Q: 1. Katie, a 30.0 kg child, climbs a tree to rescue her cat who is afraid to jump 8.0 m to the groun...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: One hundred grams of aluminum (c = 0.22 cal/g° C) at 100° C is mixed with 100 g of water at 10 ° C. ...

A:

Q: What is the slope of the plot of R vs. sin 2α? What is the value of the acceleration due to gravity ...

A: Given:

Q: An elevator cab that weighs 28.6 kN moves upward. What is the tension in the cable if the cab's spee...

A: Given: Weight of elevator cab =28.6 kN  = 28600 N Weight = mass*g Mass of elevator cab =Weight/g Mas...

Q: Calculate the electric flux through a trapezoid, with measurements of 4 cm at the smaller base, 7 cm...

A:

Q: Problem 2: A block with a mass of m = 31 kg rests on a frictionless surface and is subject to two fo...

A:

Q: A long silver metal rod with a circular cross-section has an estimated diameter of cross-section 1 m...

A:

Q: 1- The charge density between the two parallel 1m plates shown in the figure is given by p = 6y If V...

A: We have parallel plates with a separation with one plate at y=0 and one plate at y=1. The volume cha...

Q: It took an object 50 seconds to move from point A to B, then to C. If point B is 10 m, east of point...

A:

Q: 22.8 • The three small spheres shown in Fig. E22.8 carry charges 91 = 4.00 nC, 92 = -7.80 nC, and q3...

A:

Q: 3. Consider a thin, spherical shell of radius 12.0 cm with a surface charge density of 0.150 mC/m² d...

A:

Q: A truck of mass 10 000 kg pulls a trailer of mass 6 000 kg along a level road. The truck and trailer...

A: Let T be the connecting force between Truck and trailer

Q: A bag of potato chips contains 2.00 L of air when it is sealed at sea level at a pressure of 1.00 at...

A:

Q: What is the magnitude of the electric field 4.52 cm to the left of 8.15 mC negative charge? 3.45x101...

A: Answer:- (b) 3.59 × 1010 N/C  Given  Charge (q) = 8.15 mC = 8.15 × 10-3 C  Distance (r) = 4.52 cm = ...

Q: An object is located 26.0 cm from a concave lens with f = -14.0 cm. What is the image distance?

A: Given,object distance, u = 26.0 cmdocal length of the concave lens, f = -14.0 cm

Q: Given data : Mass=2 kg Acceleartion=3 m/s2 Determine the force required to produce acceleration

A: Given data : Acceleration=a Mass=m   To find : Force required to produce acceleration

Q: 3. C2 C3 find Cz and C 3

A:

Q: Question: How can a material acquire a "“net charge"? What type of charge? How much?

A:

Q: combine both equations and solve for 11 12 13 8.0 - エ,(icb) +エ。(220b)。 12.0V -I, (150b)-エュ(2205ーエる (...

A:

Q: In the figure here, a ball is thrown up onto a roof, landing 3.40 s later at height h = 21.0 m above...

A:

Q: A 6-m long ladder has a mass of 13 kg, and its center of gravity is 2.4 m from the bottom along the ...

A:

Q: A copper wire of length 3 m and 1 mm diameter is subjected to a tension of 5 N. Calculate the elonga...

A: Length = 3 m diameter = 1mm radius = 0.5 mm tension = 5 N Young's modulus of copper = 11×1010 Pa   

Q: Please draw diagram The electric field at a distance of 0.35 m from a very long line charge is 1250...

A:

Q: Two loudspeakers placed next to each other each emit a pure tone with the same amplitude. One speake...

A:

Q: Given the attached info: A. As it passes the origin, what are the strength and direction of the magn...

A: Given, Vx=1.0×10^7m/s

Q: & Civen there vectors : find QA? - B) •C

A:

Q: Average speed is distance over time. If the average distance is 4.4 m and time is 2.1 sec. What is t...

A: Given: Average distance, d = 4.4 m Time , t= 2.1 sec   To determine the average speed.

Q: See the diagram below. (a) Find the total capacitance of the 5 capacitors where Ci = { 3pf if i is a...

A: Answer:-  Given  Capacitor (C1) = 4 pf  Capacitor (C2 ) = 3 pf  Capacitor (C3 ) = 4 pf  Capacitor (C...

Q: Review I Constants Part A A 1.0-m-tall vertical tube is filled with 20°C water. A tuning fork vibrat...

A:

Q: Velocity. Rate of Change of Position. Due to west Anton drives with a speed of 35.0 mi/h for 30 mins...

A: Velocity in first interval of t1=30 min=0.5 h v1=35 mi/h, velocity in second interval of t2=2 h v2=6...

Q: At the instant a traffic light turns green, a car that has been waiting at the intersection starts a...

A:

Q: The drawing shows a uniform horizontal beam attached to a vertical wall by a frictionless hinge and ...

A: The beam is at rest and so the sum of the torques must equal zero. But we can choose about which poi...

Electric Charges and Fields

One of the fundamental properties is the electromagnetic property. Charge cannot be destroyed by any process and this contributes formally to the law of charge conservation.