i need the answer quickly 38+1Given f (t) = L-¹ [3¹+43+(-3) if lim f (t) = 1, then the1-00value of k is1 O3 O204O

We need to find out the value of k for given final value .

Answered: 38+1 Given f (t) = L-¹ [3+43+(-3) ] if…

Engineering

Electrical Engineering

38+1 Given f (t) = L-¹ [3+43+(-3) ] if lim f (t) = 1, then the value of k is 10 3 O 20 4 O

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Calculate the voltage gain for this circuit. +16V 90km 카 10km -16.34 O -137.25 ○ -7.91 -84 2.1 ka…

A: We need to find out the gain for given circuit

Q: Q4: using super positions to find voltage in R=102. 30 www 10 www 201 www sa 5V

A: This question belongs to circuit theory . It is based on the concept of super position theorem .…

Q: Inductive sensors should not be used to detect _______ objects. A. odd-shaped B. fast-moving C.…

Q: Identify a possible input and possible output for a rotational generator of electricity

A: Give system as rotational generator of electricity.

Q: An averaging amplifier has seven inputs with RF = 36.51 kohms, what should be the value of each…

A: An averaging amplifier has seven inputs with RF = 36.51 k Ωhere we have to find the input resistance…

Q: 3. Which of the following statements IS NOT CORRECT ? * for two motors with equal output power,…

A: Motor: It is an electromechanical device. this takes the electrical input and converts this power…

Q: Q4: An angular displacement capacitance transducer use semicircular plated with 13 mm diameter…

Q: 1-6 Solve for ro- F I₁ Z₁ O 100 kohms O 40 kohms O 50 kohms O 2 Mohms 330 km2 To 12.7 ΚΩ Vcc HH hfe…

Q: dissipated in the 302 resistor for the network in Fig.3. 24 V 12 V 402 www (38 www 402 www 30 Fig.3…

Q: Convert the light brightness with luminance of 100 cd/m² as to lux for iso- tropic and surface type.

A: The illumination of the light can be measured by lux or lumen or candela. The illumination measure…

Q: Calculate the gain of a negative feedback amplifier having A = -2,368 and β = -0.075.

A: Given A = -2,368 and β = -0.075

Q: Q2) For the circuit in Fig.3 Find (R) if (ID2) is three times of (IDI) St Ge V. VIR R = 1-2-5-2² 10v…

Q: . A maintained push button will A. hold its position after it is pressed and released. B. open after…

Q: d.c. load line. It is the line on the output characteristics of a transistor circuit which gives the…

A: In this question we will write about DC load line and half wave rectifier.....

Q: 4.a. The stop control in a three-wire control scheme stops the motor by A. increasing the resistance…

A: DOL starter : A direct on line starter (sometimes known as an across the line starter) is a way of…

Q: Calculate the voltage gain (A = V/V) for the circuit below. Show the details of your work. Write…

A: Brief description: In the above given common emitter amplifier circuit we need to calculate the…

Q: current element currying 20 mA in a az direction lies along the entire z axis. Find H in rectangular…

Q: Choose the correct answer

Q: Find the equivalent resistance across the terminal 492 www 202 40 .892 www 202 892

A: For the above given question we need to calculate the value of equivalent resistance across the…

Q: Resistor 1 at 16.87 degrees Celsius has a value of 72.76 ohms. Resistor 2 at 30.47 degrees Celsius…

Q: An impedance coil absorbs 250 W when connected across 220 V, 60 Hz mains. It is then connected…

A: Impedance is nothing but AC resistance which opposes the flow of current.

Q: Feedback and control system Give a good examples of control system mechanized/component in your…

A: A feedback control system is a automatic control system which senses the output and do changes…

Q: The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical…

A: Given: Load-1:P1=950Wcosϕ1=0.5 LaggingLoad-2:P2=1.14Wcosϕ2=1Load-3:P3=760Wcosϕ3=0.5 leadingline…

Q: e Figure below, calculate Z₁.

A: MOSFET (Metal–oxide–semiconductor field-effect transistor)- It is a type if transistor which is…

Q: Refer to the Figure below, calculate Ay. Assume VGsQ = -2.2V. (VDD 12V, RD=4.1kohms, R$=0.9kohms,…

A: We need to find out the voltage gain for given circuit

Q: Determine the node voltages V1, D2, and the total power develop by the circuit. 2A + ww V1. 25 Ω Μ…

Q: The power input to a 500V, 50Hz, 6 pole, 3 squirrel cage induction motor running at 975 RPM is…

Q: 16. _______ is the mode of operation of a photoelectric sensor where at normal state, light is being…

A: A sensor is used to detect the light beam and reflected from the target, known as a photoelectric…

Q: R₁ Use block diagram reduction G4 H₁ GI R₂ 65 63 G₂

A: Block reduction: It is the technique to find out the transfer function of the system by reducing the…

Q: hour Write the mesh equations and solve them fa 2-2 252 www M 252 32.1222 G 3222 Fig. 1

Q: Indicate whether the following statements are true or false and correct the false statements are…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Q2) Calculate the current through and the power dissipated in the 2Ω resistor for the network in…

A: In this question we need to find a power dissipation and current through 2ohm resistance

Q: 220 sin (wt + 30°) and draws a current I = 10 sin (wt – 30°). What is the average power and power…

Q: A transistor connected in common base configuration has O O a low input resistance and high output…

Q: A 3-phase, 15 MVA, 10 kV alternator has internal reactance of 6% and negligible resistance. Find the…

A: In this question we need to find a external reactance per phase to be connected in series with the…

Q: VD=Volt 1.33 13.3 133 0.133 VB= -------Volt 14 1.4 0.7 0.14 1B= -------- А. 12A 0 12 Micro A 12 MA 0…

Q: Three balanced three-phase loads are connected in parallel. Load 1 is Y-connected with an impedance…

A: Given star connected load is: =400+j300Ω/ϕ Convert delta load in equivalent star. Delta load is 3…

Q: To convert a 2 mA meter with internal resistance of 120 ohm into an ammeter of range 0-200 mA, the…

A: Given: Meter resistance, Rm=120 Ω Meter current, Im=2 mA Measured current, I=200 mA

Q: 4- The polarization loss factor of a mismatch antenna is PLF=1.

A: In the given question they want to know the correctness of the given statement. By the use of…

Q: Find the equivalent resistance across the terminal www 202 60- .892 www 202 892

A: Given A resistor circuit,we need to find the equivalent resistance. Please find the below…

Q: What is peak voltage? I 60 V O 84.85 V Ⓒ600.0 V D42.43 V Ⓒ60.00 V m 10 ohms

Q: 3.) (Based on Neaman, Problem 4.1) - Calculate the intrinsic carrier concentration at T= 200 K, 400…

A: We know that,ni2=NcNv T3003 e-Eg/0.0259T/300a For silicon,Putting value Nc=2.8×1019 cm-3,…

Q: Evaluating the Maxwell's Mesh Current Analysis equations will yield the magnitude of 12 as 40 24V C…

Q: 6. The air gap MMF (magneto motive force) * O increases when we increase the air gap O reduces when…

A: In this question we will write about air gap mmf.....

Q: A 25 kva 220-volt three phase alternator delivers rated kva at 0.84 power factor. The effective ac…

Q: Q4: Find the current in the resistor (30) by using thevnin theorem? 8 ww 24 V 5 V D (a) www B

A: Given An electrical circuit,we need to use Thevenins theorem to find the current through the 3 ohm…

Q: 1. A PT100 RTD has a positive temperature coefficient (a) of 0.00392 0/°C. It is being used to…

A: It is given that: α=0.00392 Ω°CR=115Ω

Q: Find v using source transformation. 8V ΞA(+ M 16 Ω + 20 Ω Μ 6Ω 3Ω >12 Ω 3A Vo + 10 Ω 7Ω

Q: Calculate the number of parity bits required in order to code an information consisting of one…

A: In the above given question we need to calculate the number of parity bits required for the given…

Q: An impedance coil takes 10A and absorbs 250 W when connected across a 220V, 60Hz source. What power…

A: Power :- Active power P=VIcosφ Reactive power Q=VIsinφ Apparent power S= VI

Question

i need the answer quickly

38+1
Given f (t) = L-¹ [3¹+43+(-3) if lim f (t) = 1, then the
1-00
value of k is
1 O
3 O
20
4
O

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the circuit shown below, switch S1 is closed at t = 0 s, and switch S2 is opened at t = 3 s. Find the i(2) and i(4).
Imagine we have a function f(t)=2u(t)+2r(t-1)-4r(t-2)+2r(t-3): a) Determine whether the function is Even or Odd or none of them?b) Find the Ev{f(t)} and Od{f(t)}c) Draw the even part and the odd part.
Please solve be careful and true by step step.
Suppose the system x'= Ax has the solution; Find x1 (t), x2 (t) and x3 (t). Please clearly ans.
A series RL circuit with R = 39 Ω has a constant voltage E = 168 V applied at t = 0 by the closing of a switch. Find L if at t = 1.15 s, i = 2.27 A.
Determine T(s)=I(s)/V(s) if R, L, and C=2.
The parameter values for the circuit are as follows: R=1 kΩ, L=12.5 H, C=2 μF, and Idc=30 mA.1. Find vo(t) for t≥0.2. Find io(t) for t≥0.3. Does your solution for io(t) make sense when t=0? Explain.
Given a Routh table below, is it stable or unstable? Explain why. (It's sign changes, poles etc.) s4 1 35 264 s3 1 5 0 s2 30 264 0 s1 -263 5/6 0 0 s0 -30.01 0 0
1) Find zeros and poles of the system.2) Show them onto the S-Plane (the complex plane)3) Discuss the BIBO stability of the system. Ignore the box below. Upload your handwritten question and solution to the Microsoft Teams assignment. Don't forget your name and signature. Warning: If your solution contains numbers that don't belong to your question, you get 0.
Find which of the following signals are causal or non-causal? Justify your answer (a) x(n) = (1/3)nu(n+2) (a) x(t)=u(1-t)
I'm trying to minimize the function F=A' B C' + AC + AB' into F' (A,B,C). I believe I need to use de morgans law? but I keep mixing it up. Thank you.
Please solve i(t) for t>0 by hand