3)The two-wattmeter method gives Pi=1200 W and P2=400 W for a three-phase motor running on a 240-V line. Assume that the motor load is wye- connected and that it draws a line current of 6 A. Calculate the pf of the motor and its phase impedance.

Q: Explain the working of a full wave bridge rectifier circuit. What are the disadvantages of center ta...

A: The main difference between full-wave rectifier and center tap full wave rectifier is the number of ...

Q: KHZ 2. 4) How to determene Cutoff froy. ond whih Crlut has Hhis characterestics ond why Vout Vaut

A:

Q: Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1800 rpm) is operating in parallel with alternator B (125 ...

A: In this question We need to determine the pf of load. If Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1...

Q: Q3) () It is required to set the operating point by biasing with collector feedback resistor at Ic =...

A: Emitter and collector- Emitter and collector, by their definitions before transistors existed, imply...

Q: 9. What resistance must be connected in parallel with a 20-N and a 600 resistor in parallel in order...

A: The solution is given below

Q: In a 4-bit arithmetic circuit if the given input numbers A & B are 1011 and 1001 respectively. Then ...

A: Given Inputs A=1011    B=1001     Control inputs are 011 and 110

Q: 4. Sketch Vo for the following circuit. C 120 V Ideal R E 20 V

A: We need to find output voltage and we need to draw output waveform

Q: 1. Find the gradient of the following scalar functions: а. Т%3D 5/ (х2 +z?) b. V = xy?z4 c. S = 4x³e...

A:

Q: c) Define RMS value and average value. Find the form factor and crest factor of the following wave s...

A:

Q: Ps: The differente equation of the Rillowing. dingram. is 3. -4

A: Block deduction- In control system, the whole system is represented in block form which are deduced ...

Q: 3. VD and Ip +

A:

Q: Draw the block diagram of a Displacement measurement system .Also identify the names of the  functio...

A: Displacement measurement system is a system which is used to measure a displacement by an object. It...

Q: Three point charges are located as shown in the figure 9-5 x 10-12 IC) and di 6 lem] -4 x 10-12 IC] ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: 3) What are the rise time, fall time, and average propagation delay of the NMOS gate in the below fi...

A:

Q: You are to asked to generate a 12 Hz, 10% duty cycle pulse wave using a 16 bit timer on the Arduino ...

A: The duty cycle is a measurement of the input signal's peak-to-average ratio over time. Although ampl...

Q: An analog voltage in the range 0 to 10.2 V is divided in 16 equal intervals for conversion to 4-bit ...

A: Given, Analog voltage range has, Vmax=10.2 VVmin=0 V It is divided into 16 equal intervals for conve...

Q: Consider the circuit. Find: a. Leg, i, (t)and iz(t) if i̟ = 3e¬tmA b. v.(t) c. Energy stored in the ...

A:

Q: (22)Use nodul analysıs to fin the power in (552) resis tor. [ 149.05 W) 15 i 252 Yu.52 125V- 8.2 55S...

A: The circuit are given as 

Q: VEE =-12V, VCC = 12V, R1=9800 ohm, R2 = 3300 ohm, RC = 1800 ohm, RE = 970 ohm, B = 100 Calculate,...

A:

Q: Problem 18. The decay of voltage, v volts, across a capacitor at time t seconds is given by v=250 e ...

A: The voltage function is an exponential decay function and the graph is given as:

Q: Eq Resistance Rad for C1 and Eq Resistance Rab for C2

A:

Q: The displacement is actual path of particle False True

A: The solution is given below 

Q: 2. A standard vapor compression system produces 25 Tons of Refrigeration using R 12 as refrigerant w...

A:   Vapour Compression Refrigeration Cycle- In VCR Systems like house refrigerators ,the compressor us...

Q: The breakdown voltage of a lot of transistors is assumed to follow a normal distribution. Ten sample...

A: Cpk is a measure of a system's output that how perfectly it meets the both upper and lower limit.

Q: Design and write a truth table using the Karnoff map What is the name of the resulting circle?

A:

Q: If R=4 N, L=0.2 H and C=80 µF are connected in series in the following figure, then Find out (i) wo,...

A: Given, R=4 ΩL=0.2 HC=80 μF

Q: (use Loug division) 2x'-3x*+リメ+5 X+ 2

A:

Q: G. In AC OPF the locational marginal price (LMP) for different buses could be different due to (a) s...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: In a biased limiter, is there any relationship between the amplitude of the output waveform and the ...

A: A bias limiter is also known as clipper circuit a clipper circuit is used to cut the input waveform....

Q: 2) For the wye-connected load of Fig. below, the line voltages all have a magnitude of 250 V and are...

A: Determine the value of the phase voltage. Vph=250∠03=144.33 V

Q: Vr. R, E=72V R 2

A:

Q: A germanium diode draws 32 mA with the forward bias 0.27 V. If T=300 K, calculate the reverse * .sat...

A: Given, In germanium diode Diode current, ID=32 mA Forward bias voltage, VD=0.27 V Temperature, T=300...

Q: A multimode step index fiber has a relative RI difference of 1% and a core refractive index of 1.5. ...

A:

Q: 23. For the network of Fig. 9.88: a. Determine VGS, and Ipo b. Find gm0 and gm- c. Calculate the mid...

A:

Q: 2-Explain the difference between a Wound and a squirrel -cage motor.

A:

Q: In the circuit shown in figure (3) V1 =12V find Vs : 4 kfl 2 kf V1 1 kn Vs 6 kl? Fig. 3 4 k 3 kn

A: The solution is given below 

Q: 34. In the circuit of Fig. 10.53, which is shown in the phasor (frequency) domain, I10 is determined...

A:

Q: . Determine the current through using 3Ω ww the circuit source transformation. ЗА 10 Ω 62 15 V .. Ap...

A:

Q: The number of the electric field lines, between two charged particles, is proportional to the amount...

A:

Q: 2. Discuss the idea of ELECTRICAL POWER as compared to HEAT or LIGHT in not less than 12 sentences.

A: Electrical Power Electrical Power is a form of energy that consists of moving electrons in a conduct...

Q: What is the circuit time constant? I kQ i(1) 1 mH ll

A: Given circuit,

Q: 12. Find the missing values in Fig-32. = ? I, = 3 A V = ? 4 0 12 0 Fig. 5-32

A:

Q: 2) While selecting the casing for switch, refer Termination options dimensions PCB layout dimensions...

A: It is asked to choose the correct option is to be referred while selecting the casing for switch.

Q: 10. A 12 V battery with an internal resistance of 10 ohms is connected to a 20 m long 50 ohm coaxial...

A:

Q: Using 220kVA and 11kV as base values, express 138kV, 2MVA, 60A, and 660Ω as per unit values.

A:

Q: calculate the magnitude of the Thevenin Voltage. Assume that the j3 ohm inductor is the load. 1 of 1...

A:

Q: 3. Is it possible to an element to have zero voltage but a current is not zero? Or an element has NO...

A: The solution is given below

Q: a) Deduce the expression for Y - A and A - Y conversions. Using such conversion, fir current I of th...

A:

Q: Using 3 capacitors with capacitance value of 3 farad, 6 farad, and 8 farad arrange them in: a. seri...

A:

Q: Q1) A 350 V shunt motor runs at its normal speed of 12 rev/s when the armature current is 90 A. The ...

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.