answer question 1 A00O5525923592355210 ΩΣ5523552102152259235521592The following five questions pertain to the four circuits (A, B, C, and D) shown above.1. In which circuit do the three resistors have equal voltage drops but carry differentcurrent?2. In which circuit do the three resistors carry equal current but have different voltagedrops?3. Which of the circuits has the lowest equivalent resistance?4. Which of the circuits has the highest equivalent resistance?5. Assume that Circuits A, B, C, and D have identical batteries and convert all of theirpower to thermal energy. Which of the four circuits will produce the most heat?

Answered: Image /qna-images/answer/b2923880-7481-4fff-8fca-96d8415bc073.jpg

4 5Ω ΩΣ ΩΣ Ω ΑΛΛΑ 10 ΩΣ 5Ω{} 10 Ω 15 ΩΣ ΣΩΣ 15Ω Ω The following five questions pertain to the four circuits (A, B, C, and D) shown above. 1. In which circuit do the three resistors have equal voltage drops but carry different current? a 09 O Ω .

4 5Ω ΩΣ ΩΣ Ω ΑΛΛΑ 10 ΩΣ 5Ω{} 10 Ω 15 ΩΣ ΣΩΣ 15Ω Ω The following five questions pertain to the four circuits (A, B, C, and D) shown above. 1. In which circuit do the three resistors have equal voltage drops but carry different current? a 09 O Ω .

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 28PQ: The emf devices in the circuits shown in Figure P29.28 are identical. a. Redraw circuit 1 in figure...

See similar textbooks

Similar questions

A student in a physics lab mistakenly wired a light bulb, battery, and switch as shown in Figure 21.44. Explain why the bulb is on when the switch is open, and off when the switch is closed. (Do not try this-it is hard on the battery!)
Unreasonable Results Suppose you have a 40.0- galvanometer with a 25.0-A sensitivity, (a) What resistance would you put in series with it to allow it to be used as a voltmeter that has a full-scale deflection for 0.500 mV? (b) What is unreasonable about this result? (c) Which assumptions are responsible?
In this problem, you will verify statements made at the end of the power losses for Example 20.10. (a) What current is needed to transmit 100 MW of power at a voltage of 25.0 kV? (b) Find the power loss in a 1.00 transmission line. (c) What percent loss does this represent?
You have a faculty position at a community college and are m (caching a class in automotive technology. You are deep in a discussion of using jumper cables to start a car with a dead battery from a car with a fresh battery. You have drawn the circuit diagram in Figure P27.16 to explain the process. The battery on the left is the live batten- in the correctly functioning car, with emf and internal resistance RL where the L. subscript refers to live. Its terminals are connected directly across those of the dead battery, in the middle of the diagram, with emf and internal resistance RD where the D subscript refers to "dead Then, the starter in the car with the dead battery is activated by closing the ignition switch, allowing the car to start. The resistance of the starter is Rs. A student raises his hand and asks, So is the dead battery being charged while the starter is operating? How do you respond?
An electronic apparatus may have large capacitors at high voltage in the power supply section, presenting a shock hazard even when the apparatus is switched off. A “bleeder resistor" is therefore placed across such a capacitor, as shown schematically in Figure 21.50, to bleed the charge from it after the apparatus is off. Why must the bleeder resistance be much greater than the effective resistance of the rest of the circuit? How does this affect the time constant for discharging the capacitor?
Find the direction of the current in the resistor shown in Figure P20.16 (a) at the instant the switch is closed, (b) after the switch has been closed for several minutes, and (c) at the instant the switch is opened. Figure P20.16
A 240-kV power transmission line carrying 5.00x102. A is hung from grounded metal towers by ceramic insulators, each having a 1.00x 109- resistance. Figure 21.51. (a) What is the resistance to ground of 100 of these insulators? (b) Calculate the power dissipated by 100 of them, (c) What fraction of the power carried by the line is this? Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.
The emf devices in the circuits shown in Figure P29.28 are identical. a. Redraw circuit 1 in figure P29.28, including (and labeling) the current in each branch of the circuit. Apply the junction rule to write an equation in terms of the currents you have labeled. b. Repeat part (a) for circuit 2 in Figure P29.28. c. Simplify your equations if necessary, and compare your answers for each circuit. What can you say about the two circuits?
For the circuit shown in Figure P21.50, we wish to find the currents I1, I2, and I3. Use Kirchhoffs rules to obtain equations for (a) the upper loop, (b) the lower loop, and (c) the junction on the left side. In each case, suppress units for clarity and simplify, combining the terms. (d) Solve the junction equation for I3. (e) Using the equation found in part (d), eliminate I3 from the equation found in part (b). (f) Solve the equations found in parts (a) and (e) simultaneously for the two unknowns I1 and I2. (g) Substitute the answers found in part (f) into the junction equation found in part (d), solving for I3. (h) What is the significance of the negative answer for I2? Figure P21.50
Referring to Figure CQ21.4, describe what happens to the light-bulb after the switch is closed. Assume the capacitor has a large capacitance and is initially uncharged. Also assume the light illuminates when connected directly across the battery terminals.
The switch S in Figure 20.27 is closed at t = 0 and the current at a reference time tref 0 is Iref. If the circuit is changed as, described below and the switch is again dosed at t = 0, determine whether the current I at the same time would be greater than, less than, or equal to the original value of Iref. Indicate your answers wilt G. L. or E, respectively. (a) Both the battery voltage and the resistance R are doubled. (b) The inductance L b doubled. (c) The battery voltage . the resistance R, and the inductance L are each doubled. Figure 20.27 A series RL circuit. As the current increases toward its maximum value, the inductor produces an emf that opposes the increasing current.
The circuit on the right contains three resistors, A, B, and C, which all have equal resistances. The emf is 110V. Which resistor dissipates the most thermal energy after the switch is closed? (Resistor A, B, or C). Why? What other quantity is maximized to tell you that the energy is maximized?