(4) all öf th The refrigerant supplied to a compressor must be (a) superheated vapour refrigerant (c) a mixture of liquid and vapour refrigerant (d) none of these (b) dry saturated liquid refrigerant ant compressor is called

(4) all öf th The refrigerant supplied to a compressor must be (a) superheated vapour refrigerant (c) a mixture of liquid and vapour refrigerant (d) none of these (b) dry saturated liquid refrigerant ant compressor is called

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter46: Room Air Conditioners

Section: Chapter Questions

Problem 15RQ

See similar textbooks

Related questions

Q: ated liquid-vapor mixture of water at 225 kPa. Initially, one-quarter of the m ce, and a current of…

A: Given that , m=5.6kgmvapour+mliquid=5.6kg Initially , mliquid=0.25m=1.4kgmvapor=4.2kgx=4.25.6=0.75

Q: Fill in the blanks: The ratio of volume at the end of expansion to the volume at beginning of…

Q: The hot fluid is cooled by cold fluid without mixing in each other in Throttling valve .a O…

A: hot fluid is coold by cold fluid without mixing each other in??

Q: 5. A refrigerator with tetrafluoroethane as refrigerant operates with an evaporation temperature of…

Q: 9. For the LiBr-water machine shown below, determine: a. The heat required at the generator…

Q: and 20 MW steam turbine c. two gas turbines 40 MW each, and 20 MW steam turbine d. two steam…

A: Question : 60 MW new combined power plant typically it consists of............ Answer : a) a two…

Q: A vapour compression refrigeration syste vaporator temperature of 263 K and a conde sed is R-12 and…

A: *Disclaimer*: “Since you have posted a question with multiple sub-parts, we will solve the first…

Q: (B) A liquid subcooler as shown in the Figure receives To high-stage liquid ammonia at 30°C and…

Q: Q1) 1Pout (3) R1344 Condenser T; - 70°C (2) P, 1.2 MPa T, = 40°C T,., = 30°C Adiabatie W in0.15 kW…

A: Given,

Q: EVAPORATOR OUHET ENTHALPY = 514.34 CONDANSER OUTLET ENTHALPY = ENTROPY = EVAPORATOR OUTLET ENTROPHY…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: A steam boller plant consists of an economiser, evaporator and a superheate and steam Is generated…

A: As per the guidelines, I can solve only first three subparts, for rest parts re-post in a separate…

Q: single effect evaporator is being used to concentrate 8000 kg/h of tomato juice from 5% total solids…

Q: 5000 cfm of outdoor air at 100°F/75°F is cooled to 85°F in a direct evaporative cooler. Air then…

Q: Air at 60°F dry bulb and 45°F wet bulb passes through an air washer with a humidifying efficiency of…

A: Answer: The effective bypass factor of the system is most nearly equal to 0.3.

Q: Fill in the blanks: In an ammonia refrigeration system, the pressure in the evaporator is 251 kPaa,…

Q: most of the heat in waste heat boilers absorbed by steam at :

A: Answer is a) Economizer

Q: Under ideal condition, the velocity of steam at the outlet of nozzle for heat drop of 400kj/kg will…

A: The specific heat drop of the steam in the nozzle is, h1-h2=400 kJ/kg The initial velocity of the…

Q: How many tons of refrigeration is required to produce 10 metric tons of ice per day at -10°c from…

Q: temperature of -5°C and a condensing temperature of 40°C. Determine: a) refrigerating effect; b) The…

A: Given: Refrigerant R-12 Evaporating temperature =-5oC Condensing temperature =40oC To determine: The…

Q: Q.1. A refrigeration process with interstage cooling uses refrigerant HFC-134a, and the outlet of…

Q: A system consists of one compressor and two evaporators. One evaporator carries a load of 35kw at…

Q: What are chilled liquid treatment process and condenser water treatment process in refrigeration and…

A: In this problem, it is asking about the two processes that are used in refrigeration and air…

Q: The food storage room requires a cooling system with a capacity of 10 tons of refrigeration that…

A: Given: The refrigeration capacity, R = 10 tons = 35 kW The evaporator temperature, Te = -17.8 degree…

Q: Air at 35°C, 105 kPa flows in a 100mm x 150mm rectangular duct in a heating system. If the…

A: Given data: T=35°C=308.2 KP=105 kPaV˙=0.015 m3/sA=100×150 mm2 Need to determine the mass flow rate…

Q: 2. An R22 operates between evaporator and condenser temperatures of -20 C and 50 C, respectively.…

Q: In an absorption chiller, ____________ is used to createthe difference in pressures.

A: By creating the pressure around the inside of the absorption chiller the water and lithium bromide…

Q: The mass flow rate of the refrigerant in a Single Stage Vapor Compression (SSVC) refrigeration…

Q: Most of the heat in waste heat boiler is absorbed by steam at

A: in the boiler system,flue gas exits the boiler and after that it enters an economizer.

Q: a. Explain the First Law of Thermodynamics and how it is expressed in terms of balance of energy in…

Q: Differentiate between Adiabatic and Isentropic process

Q: Indonesia Inggris A single effect evaporator was used to concentrate 8000 kg / hr of tomato juice…

Q: A single effect evaporator is used to concentrate 10 000 kg / hr of tomato juice from 5% total…

Q: 2. A Freon 12 waste water system operating at 5°C suction temperature and a 40°C condensing…

A: Given: T1=5°CT2=40°CQ=5 tons∆T=7°Ch1=353.6 kJ/kgh4=238.5 kJ/kgh2=377 kJ/kgh3=238.5 kJ/kg

Q: A single effect evaporator was used to concentrate 8000 kg / hr of tomato juice from 5% total solids…

Q: The subcooling temperature in a condenser can be measuredby taking the difference between theA.…

A: Draw the sub-cooling process in a refrigeration system T-s diagram.

Q: A vapour compression plant uses R-12 and is to develop 5 tonnes of refrigeration. The condenser and…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: scuss the following scenarios: a) Consider an air compressor that operate under the same conditions…

A: a. Volume flow rate at inlet =VIAiAt outlet =VeAegenerally volume flow rate at outlet is much less…

Q: the temperature at the beginning and end -) of the evaporator is constant, while It increases after…

A: we have to discuss why temperature stays constants in the evaporator

Q: The standard design conditions for air-conditioning systemsestablished by the Air-Conditioning,…

A: In this problem, it is asking about the standard design conditions for air-conditioning systems…

Q: What is the importance of compressor in real world?

A: Compressor: A compressor is a device that is used to pressurise the fluid for suitable utilization.…

Q: With p-h diagram explain why the compressor work increases with the decrease of evaporator…

A: Major components of a refrigeration plant are: Compressor Evaporator Expansion value or throttling…

Q: refrigerator with tetrafluoroethane as refrigerant operates with an evaporation temperature of −25°C…

A: Given:TL=26°CTH=-25°CCooling rate, Q=5 KJ/s

Q: Mass flow rate of R134a. Mass flow rate of chilled supply water and Volumetric flow rate entering…

Q: nters the condenser at 36°C, and saturated liquid exits at the same temperature. The mass flow rate…

Q: 4. A small auditorium is required to be maintained at 22 C dry bulb temperature and 70 % relative…

A: Consider the diagram shown below for the given process. Here, Process 1 to 2 is cooling and…

Q: A single effect evaporator is used to concentrate 10 000 kg / hr of tomato juice from 5% total…

A: Given data: The mass flow rate of juice is mf = 10,000 kg/h The initial concentration of juice is…

Q: 3. The evaporator load of a Freon 12 waste water system running at 5°C suction temperature and 40°C…

Q: How many tons of refrigeration is required to produce 10 metric tons of ice per day at -10°C from…

A: Given:Required refrigeration effect, RE=10 tons/dayLosses=15%

Q: A single effect evaporator is used to concentrate 10 000 kg / hr of tomato juice from 5% total…

Q: Fill in the blanks: The ratio of volume at the end of expansion to the volunbelat beginntng of…

Question

(4) all öf th
(b) dry saturated liquid refrigerant
The refrigerant supplied to a compressor must be
(a) superheated vapour refrigerant
(c) a mixture of liquid and vapour refrigerant (d) none of these
ant compressor is called

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Explanation

VIEW

Step 2 Required Answer

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

PROPERTIES OF CERTAIN REFRIGERANTS At 5°F, how much denser is R-134a than R-124?
The percent rating of water tube boiler is 200 %, factor of evaporation is 1.10, and heating surface is 400 ft2. Determine the rate of evaporation, in kg/hr.
The value of enthalpy at point 1 is ( hi2 ?) The value of enthalpy at point 3 is (h3?) The value of enthalpy at point 4 is (h4?) The value of steam mass flow rate in kg/s is The rate of heat supplied is
A 15-ton refrigeration system is used to make ice. The water is available at 20°C. Refrigerant12 is used with saturated temperature limits of -25°C and 54°C. Determine (a) the COP, (b) therefrigerant flow rate, (c) the temperature at discharge of the compressor, (d) the volume flowrate, and (e) the maximum kg of ice manufactured per day.
What is the ideal mass flow rate for a refrigeration and cryogenic plant for oxygen production? Show solution if necessary and reference.
Solve all please i give thumb up? Outside air at 15°C and 20% relative humidity is admitted at a volumetric rate of 15m³/min into an air conditioning system composed of a simple heating section followed by a humidification section, which must supply air at 27 °C and 65% relative humidity. The airflow temperature between the heating and humidifying sections is 22°C and the entire air conditioner operates at 70kPa. Determine, using calculations: (a) the rate of heat supply to the heating section, in kW, is ______. (b) the wet bulb temperature of the air after the heating section, in °C, is ______. (c) the mass flow rate of steam in the humidification section, in g/s, is ______. (d) the temperature of the steam injected into the humidification section for a steam pressure of 200kPa, in °C, is _______
What is the mass flow rate in hot stream kg/s?
Boiler raises 3.7 kg of water per kg of coal from feed water at 54.5oC,to steam at the pressure of 34 bar and temperature of 370oC. Calculate the equivalentevaporation per kg of coal.
An ammonia system with a 158-kW evaporator operating at -1°C and a 35-kW evaporator operatingat -40°C uses flash gas removal and intercooling. The condensing temperature is 32°C. Thearrangement is as shown. How many kilograms per minute of ammonia are compressed by the high-pressure compressor?
a desuperheater insulated unit (figure F) converts the inputs into asaturated vapor stream. Determine the mass flow rate of the superheatedstream. . Determine the enthalpy of liquid water both from table 5.1, table 5.4. What is your conclusion from this comparison?
A large commercial air-conditioning unit processess 5 kg/s of atmospheric air. The air enters at a pressure of 105 KPa. Its dry-bulb temperatue of 20 °C, a wet-bulb temperatue of 10 °C, and a pressure of 100 kPa. How much water is being removed fom the air in one hour? Conver to liters/hr
The standard design conditions for air-conditioning systemsestablished by the Air-Conditioning, Heating andRefrigeration Institute (AHRI) are outside temperature______°F, inside temperature ______°F, with a humidityof ______%.