4. Find the coefficient of coupling between two coils whose mutual inductance is 1 H and self-inductance of 1.2 and 2 H.

Q: Determine the transfer function for the op-amp circuit shown in the Figure below. Let R1 = 167 KN, R...

A:

Q: A 1000-turn coil is uniformly wound on a ring of mean diameter 300 mm and cross-sectional area 400 m...

A:

Q: Solve for VcE -22 V 2.2 k2 82 k2 Vc IB B = 220 16 k2 0.75 k2 +12 V

A:

Q: Q10 A 240 v, 4-pole shunt motor running at 1000 r.p.m. gives 15 h.p. with an armature current of 50 ...

A:

Q: H.W: Find (HPBW) and (FNBW), in radians and degrees, for the following normalized radiation intensit...

A: It is given that: (a) Uθ=cos2θ(c) Uθ=cos2θ cos3θ 

Q: :Digital Communication Three different information signals each bandlimited to 6kHz, 11kHz, and 3kHz...

A: Given f1 = 6kHz f2 = 11kHZ f3 = 3kHz  L = 256 

Q: 4. For the circuit shown in figure below, use a current mesh analysis to dete in the capacitor Ic (b...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: Using the principle of superposition, determine the current I in the 5 2 resistor in the circuit sho...

A: The given circuit is:

Q: Sketch a power triangle for a capacitive load, label the sides, and show the power angle

A:

Q: 1. A coil of 100 turns is linked by a flux of 10 mWb. If the flux is reversed in 2 ms, find the aver...

A:

Q: Three similar choke coils are connected in star to a 3 phase supply. If the line current are 15 A, t...

A: Given,Line current IL = 15AActive Power P = 11 KWApparent power S = 15 KVA Line voltage VL =S3×IL =1...

Q: A balanced three-phase source with a 208 V rms (line-line) is delivering power to a balanced Y-conne...

A: The solution is given below 

Q: d. Determine the minimum value of R to ensure that the Zener diode is in the "on" state. Rs 220 Ω IR...

A:

Q: Calculate v and i, in the circuit of Fig. 12Ω + 16 V - + v - + 10 V 4 V 3i (+1)

A:

Q: 8. Convert the following from rectangular to polar. Put your answer in the space provided. a. 10+j 8...

A: This question belongs to basic electrical . It is based on the concept of polar and rectangular form...

Q: Each phase of a delta-connected load comprises a resistor of 50 ohms and a capacitor of 50 microFara...

A: In this question we have given delta connected load....We have to find out line current , phase curr...

Q: The rms value of a half - wave rectified sine wave is 100 amp. The value for full wave rectification...

A:

Q: Draw a series-parallel connection in DC using three lamps and two switches in the Schematic Diagram,...

A: Schematic Diagram: A schematic, is also known as schematic diagram. It is a depiction of the element...

Q: Q7 calculate the value of torque established by the armature of a 4-pole motor having conductors, tw...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Electrical Engineering Question

A: Given: A stem power station has, Overall efficiency, η=25 % 0.5 kg of coal is burnt per kWh, so Heat...

Q: Calculate v and i̟ in the circuit of Fig. 12Ω + 16 V - + v - 10 V 4 V > 3i,

A: Given circuit:

Q: The region in which 4 <r< 5, 0< 0 < 35°, 0.6m < Ø< 1.2n contains the volume charge density of p, = 1...

A: The solution is given below 

Q: takes a current of 30 A and load A is a resistance of 6.4 ohms. Calculate for the total current and ...

A:

Q: illustrates a Wheatstone bridge frequently used in strain gauge and Resistance Temperature Detector ...

A:

Q: ) Suppose you tried to measure the voltage at all three test pointy in the figure 1 below with an an...

A: Voltmeter and ammeter is a voltage and current measuring instrument. Ideal voltmeter have infinite r...

Q: Two single-phase transformers with equal ratings and turns ratios are operated in parallel to supply...

A:

Q: 04. Find the total resistance for the configuration in Fig. 4 R, 20 Rr R2 20 R3 R

A:

Q: Q6. A 4-pole wave-wound armature rotating at 400 rpm is required to generate 300 V. The effective fl...

A: Given, Number of pole, P = 4 Rotating speed, N = 400 rpm Wave wound, so number of parallel path, A =...

Q: Given scalar field T(r,0,p.) = rsin(e)cos(p). If F = gradT. Determine F0 at P(2 , 1.3 rad, 0.5 rad)

A:

Q: 4. R,=_2 R, = 1.6 kn R2 =1.2 k R3 1 kn

A:

Q: 7, and q,, are located on the x-axis, with q, at the origin and q, initially at x, = 14.0 mm. In thi...

A: We need to find out force between charge particle

Q: A point charge 5nC is located (2,0, 4) and a point charge -2nC is located at (-3,0,5). Find Eat (1,-...

A:

Q: fV = 10 cos(100t – 50°) and I = 15 sin(100t – 60°), the angle by which I lags V is

A:

Q: Vp! 4700 R1 L1 10 mH 2Vp at 2 kHz 102 R3 Calculate the peak current phase angle the impedance, the c...

A: The solution is given below

Q: Q1: The node-voltage equations for the electrical circuit shown in Figure Q1 is: 4 2 3.5 A 2.52 10 2...

A:

Q: iF AN AMMETER WAS CONNECTED BETWEEN SWITCH1 AND POTENTIOMETER R1, HOW MUCH CURRENT WOULD IT INDICATE...

A: The solution is given below 

Q: Fig. 1 Find out I2, 13 and Va + R b 10 Ω 13 R2 10 N E +18 V R4 30 N R3 50 N E = Ej + E2 /2

A:

Q: 46-50) Use the BJT network below: (Use Exact Analysis) Vcc = 24V VBE1 = VBE2 = 0.7V B1 = 80 B2 = 100...

A:

Q: 1 + 0.3z-1 + 0.5z-2 X(z) = 1+ 0.8z-1 + 0.15z-2

A:

Q: 1. R=_2 R, =1 kn R2 =20 kn %3D

A:

Q: linear, lumped-parameter electrical RLC is shown in Figure Q1a below. Let C = 1F, R = 22, L = 1H. Ze...

A: We need to find transfer function for given circuit

Q: Calculate the total magnetic flux in a 60cycle transformer in which the induced emf per turn of the ...

A:

Q: FIND THE VALUE OF V, USING MESH METHOD. J412 2/0 A 3 45 A

A:

Q: Zener Diode Table 2.1(Forward Bias Condition) Table 2.2 (Reverse Bias Condition) REGULATION CHARACTE...

A: Zener Diode- It is a specially fabricated diode which is used for special operation. This diode is s...

Q: Question No.71 Current flowing in a circuit is i = (18 + 10sinwt + 7sin2wt). A moving iron ammeter i...

A: Given a moving iron ammeter is connected in the circuit, Current flowing in a circuit, i=18+10 sinωt...

Q: ) Determine the all-day efficiency of a 50 kVA distribution transformer having a full load efficienc...

A:

Q: A transformer has a no-load voltage of 240 volts and a full load voltage of 230 volts. Determine the...

A:

Q: There are four large tanks at a water processing plant that contains different mixtures being heated...

A: There are four large tanks at a water processing plant that contains different mixtures being heated...

Q: 5. Vi Al= A2 = 12A A3= A1 20 EV A2 V2 = 3A R1 V3 = V2 R1= A3 V3 6. vi A1 = A2 = A1 BA A3 = R1 3A V1 ...

A:

Q: Three similar choke coils are connected in star to a 3 phase supply. If the line current are 15 A, t...

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.