4. The capillary rise when a glass capillary tube of diameter 0.4mm is dipped vertically in olive oil is 3.8mm. If the angle of contact of olive oil with glass is 0 deg and the density of olive oil is 920 kg/cu.m, find the surface tension of olive oil. 5. A liquid rises to a height of 9cm in a glass capillary of radius 0.02 cm. What will be the height of the liquid column in a similar glass capillary of radius 0.03 cm?

4. The capillary rise when a glass capillary tube of diameter 0.4mm is dipped vertically in olive oil is 3.8mm. If the angle of contact of olive oil with glass is 0 deg and the density of olive oil is 920 kg/cu.m, find the surface tension of olive oil. 5. A liquid rises to a height of 9cm in a glass capillary of radius 0.02 cm. What will be the height of the liquid column in a similar glass capillary of radius 0.03 cm?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A closed cylindrical vessel 1.50 m in diameter and 3 m high is filled with 2.50 m of glycerin (sg=1.50). It is rotated about its own vertical axis at a constant angular speed of 175 rpm. The air space above the water is under a pressure of 115.525 kPa. Determine the height of the Paraboloid in m Determine the area of the uncovered portion in sq.m. Determine the pressure acting on the bottom of the tank along its circumference in kPa. Determine the pressure acting on the top of the tank along its circumference in kPa
Calculate the vacuum pressure in kg/cm2 if the absolute reading is 5psia. a. 0.6816kg/cm2 b. 0.6746kg/cm2 c. 0.7027kg/cm2 d. 0.6324kg/cm3
diameter = 60 cm height = 60 cm The CLOSE cylindrical tank is two-thirds full of water. It is subjected to pressure = 10 kpag. Considering that the tank is to rotate about the axis at the center at 10 rad/s a. What is the pressure at point C? b. What is the pressure at point D?
The pressure on a closed tank reads 68.86 kPa. What is the equivalent height in terms of Oil having a sp.gr of 0.85
Compute the height of capillary rise for water in a tube having a diameter of 0.05 mm (in SI units).
Calculate the capillary rise in a glass tube of 2.5mm diameter when immersed vertically in a) water ; b) mercury. Take the surface tension equal to 0.0725N/m for water and 0.52N/m for mercury in contact with air. The angle of contact is 130°.
What is the mass (lbm) of an object that has a base area of 4 inch2 which exerts a pressure of 25 psi? 2.) Determine the dynamic viscosity (Pa-sec) and kinematic viscosity (m2/s) of water with a specific weight of 9.81 kN/m3, if a Falling Sphere Viscosimeter test is conducted using an aluminum sphere that has a diameter of 10 mm and a specific weight of 28.06 kN/m3. The theoretical terminal velocity of the sphere is 0.650 m/s. Round off your answer to 3 decimal places. 3.) Given the water tank A in an orifice setup that transfers water to tank B, determine the theoretical and actual velocity and flow rate if the time it takes to fill up tank B is 20 sec. 4.) Given the computed velocities and flow rates in Question 3, determine the coefficient of contraction, velocity, and discharge. Assume the diameter of vena contracta to be 4mmø.
A pressure gauge at elevation 6.5 meters at the side of a tank containing a liquidreads 95 kpa. Another gauge at elevation 2.5 meters reads 115 kpa. Compute thespecific weight of the liquid in kn/m3 and draw the figure..
2.15 The tire of an airplane is inflated at sea level to 410 KN/m2 Assuming the tire does not expand, what is the pressure within the tire at elevation 9000 m? Assume standard atmosphere. Express the answer in KN/m2 and KN/m2, abs.
Calculate the pressure differential of water across the surface of a spherical droplet of radius 200 nm at 20 °C.
Liquid A, B, and C in the container shown below have specific gravities of 0.80, 1.00 and 1.60, respectively. With the liquid surfaces at the elevation shown, what is the pressure in Pascal on the bottom of the tank? At what elevation will the liquid stand in each of the piezometer tubes?
Determine the depth of a liquid needed to create a pressure difference of 225 kPa if the liquid is mercury. a 22.9 m b. 18 650 m c. 1,686 m d. 26.7 m